An Optimalization Study on the Surface Texture and Machining Parameters of 60CrMoV18-5 Steel by EDM

TLDR: In this paper , a complete experimental study of CALMAX machining using EDM is presented, using a Taguchi Design of Experiment (DOE) was used, using pulse-on current, pulseon time, and opencircuit voltage as control parameters.

Abstract: As a non-conventional machining technology, EDM is used extensively in modern industry, particularly in machining difficult-to-cut materials. CALMAX is a chromium-molybdenum-vanadium tool steel with exceptional toughness, ductility, and wear resistance that has a wide range of applications. Despite the fact that EDM is routinely used in CALMAX machining, the related published research is brief and limited. The current research gives a complete experimental study of CALMAX machining using EDM. A Taguchi Design of Experiment (DOE) was used, using pulse-on current, pulse-on time, and open-circuit voltage as control parameters. Material Removal Rate (MRR), Tool Material Removal Rate (TMRR), and Tool Wear Ratio (TWR) were used to evaluate machining performance, while Ra and Rz were used to estimate Surface Quality (SQ). The produced White Layer (WL) parameters were determined using optical and SEM microscopy, as well as EDX measurements and micro-hardness studies. Finally, for each of the aforementioned indexes, Analysis of Variance (ANOVA) was performed, and multi-objective optimization was based on Grey Relational Analysis (GRA). The results show that higher open-circuit voltage produces lower WL thickness, although by increasing the pulse-on time, the TWR is increased. The average hardness of the WL is increased about 400% compared to the micro-hardness of the bulk material.