Open AccessProceedings Article
Development of micro mirror solar concentrator
Ernst Kussul,T. Baidyk,Oleksandr Makeyev,Felipe Lara-Rosano,José M. Saniger,Neil C. Bruce +5 more
- pp 293-298
Reads0
Chats0
TLDR
In this paper, a low cost micro facet solar concentrator is proposed, where large number of small flat mirrors are placed at parabolic surface to approximate large parabolic mirror, and geometric analysis shows that this concentrator will have concentration rate of some hundreds suns. Rough estimations show that the cost of the concentrator should be approximately $ 55 per square meter of concentrator surface.Abstract:
The low cost micro facet solar concentrator is proposed. Large number of small flat mirrors is situated at parabolic surface to approximate large parabolic mirror. Low cost commercial flat mirrors can be used for manufacturing of such concentrator. Geometrical analysis show that this concentrator will have concentration rate of some hundreds suns. Rough estimations show that the cost of the concentrator should be approximately $ 55 per square meter of concentrator surface.read more
Citations
More filters
Flat Facet Parabolic Solar Concentrator With Support Cell for One and More Mirrors
Ernst Kussul,Tatiana Baidyk,Oleksandr Makeyev,Felipe Lara-Rosano,José M. Saniger,Neil C. Bruce,Circuito Exterior +6 more
TL;DR: In this article, a small prototype of this type of solar concentrator is presented, which contains 24 flat mirrors in the form of equilateral triangles with side length of 50mm and has special nuts to adjust the positions of the nodes in the points of connections of the apexes.
Technological status and market trends of photovoltaic cell industry
TL;DR: In this article, the authors investigated the technological developments and market tendencies in photovoltaic cell (PV) industry and found that silicon silicon cells significantly dominate the PV cell market with their converting outputs exceeding 20% in small areas.
Patent
Method and device for mirrors position adjustment of a solar concentrator
Ernst Kussul,Tetyana Baydyk,Felipe de Jesús Lara Rosano,José Manuel Saniger Blesa,Gabriel Ascanio Gasca,Neil Charles Bruce Davidson +5 more
TL;DR: In this paper, the authors developed a technology with different processes to realize an optimal solar approach using a solar concentrator where distance screws are used that, when moving, allow the positioning of the mirrors whereby the reflected solar beam is directed to a focal point; the advantage of these processes is that each movement of the screws involves adjusting the position of all the neighboring mirrors.
Journal ArticleDOI
The Problem of Automation of Solar Concentrator Assembly and Adjustment
Ernst Kussul,Oleksandr Makeyev,Tatiana Baidyk,José Manuel Saniger Blesa,Neil C. Bruce,Felipe Lara-Rosano +5 more
TL;DR: This work describes an improvement of the concentrator support frame assembly connected with the design of the gauge/guages for support frame adjustment that approximates parabolic surface needed for solar light concentration.
Journal ArticleDOI
Combinations of Solar Concentrators with Agricultural Plants
TL;DR: In this article, a new trend involving the combination of solar concentrators and agricultural plants on the same piece of land offers the possibility of realizing both electricity generation and a good crop harvest.
References
More filters
Book
Renewable and Efficient Electric Power Systems
TL;DR: In this article, the authors present an overview of the early history of the electric power industry, including the early pioneers of the electrical power industry and the development of the modern electric power system.
Book
Integration of alternative sources of energy
TL;DR: This chapter contains sections titled: Introduction Principles of Power Injection Instantaneous Active and Reactive Power Control Approach Integration of Multiple Renewable Energy Sources Islanding and Interconnection Control DG Control and Power In injection References.
Journal ArticleDOI
Development of micromachine tool prototypes for microfactories
Ernst Kussul,T. Baidyk,Leopoldo Ruiz-Huerta,Alberto Caballero-Ruiz,Graciela Velasco,L. Kasatkina +5 more
TL;DR: In this paper, an alternative technology of micromechanical device production is proposed based on micromachine tools (MMT) and microassembly devices, which can be produced as sequential generations of microequipment.
Journal ArticleDOI
Micromechanical engineering: a basis for the low-cost manufacturing of mechanical microdevices using microequipment
TL;DR: In this article, a series of equipment generations with gradually decreasing dimensions are proposed to reduce power consumption and floor area occupied, which in turn will reduce the cost of micro-equipment.
Journal ArticleDOI
Flat image recognition in the process of microdevice assembly
T. Baidyk,Ernst Kussul,Oleksandr Makeyev,Alberto Caballero,L. Ruiz,Gerardo Carrera,Graciela Velasco +6 more
TL;DR: An image recognition system for use in the assembly of microdevices gives an increase in theassembly process precision and will be used for assembly of microring-based filters.