scispace - formally typeset
Journal ArticleDOI

Flow Measurement Handbook: Industrial Designs, Operating Principles, Performance and Applications

M Süßer
- 01 Jan 2000 - 
- Vol. 40, Iss: 6, pp 421-421
Reads0
Chats0
About
This article is published in Cryogenics.The article was published on 2000-01-01. It has received 62 citations till now. The article focuses on the topics: Flow measurement.

read more

Citations
More filters
Journal ArticleDOI

Isoprene and acetone concentration profiles during exercise on an ergometer

TL;DR: Data appear to favor the hypothesis that short-term effects visible in breath isoprene levels are mainly caused by changes in pulmonary gas exchange patterns rather than fluctuations in endogenous synthesis, and hold great potential in capturing continuous dynamics of non-polar, low-soluble VOCs over a wide measurement range.
Journal ArticleDOI

Fiber Bragg grating sensor for simultaneous measurement of flow rate and direction

TL;DR: In this article, a fiber-optic sensor system consisting of a fiber Bragg grating cantilever as a transducer is proposed and demonstrated to realize simultaneous measurement of fluid flow rate and direction.
Journal ArticleDOI

A Flow Measurement Technique Using a Noncontact Capacitance-Type Orifice Transducer for a Conducting Liquid

TL;DR: In the proposed transducer, the use of a diaphragm-type DP cell is not needed, and thus, the problems associated with DP cell are avoided.
Journal ArticleDOI

Design and Implementation of Real-Time Flow Measurement System Using Hall Probe Sensor and PC-Based SCADA

TL;DR: In this paper, a noncontact flow rate measurement technique using Hall probe sensor and rotameter is designed, developed, and tested, and a theoretical equation has been derived to explain the operation of the system.
Journal ArticleDOI

A model-based transit-time ultrasonic gas flowrate measurement method

TL;DR: Based on the transit-time ultrasonic gas flowrate measurement principle, a new model-based time-of-flight (TOF) measurement method is proposed in this article, where zero-phase filtering and independent component analysis with reference (ICA-R) are used to realize the signal preprocessing.