Journal ArticleDOI
Fracture failure analysis of DY08Aluminum alloy elastic coupling
TLDR
In this article, the failure reasons of a DY08 aluminum alloy elastic coupling connecting the motor of the multi-functional test bench with the experimental device was investigated based on the fact that the lifespan of coupling was not reached.About:
This article is published in Engineering Failure Analysis.The article was published on 2019-10-01. It has received 9 citations till now. The article focuses on the topics: Stress concentration & Fracture mechanics.read more
Citations
More filters
Journal ArticleDOI
Effect of aging plus cryogenic treatment on the machinability of 7075 aluminum alloy
TL;DR: In this paper , the effect of aging plus cryogenic treatment on the machinability of 7075 aluminum alloy in high speed cutting was explored, and the results showed that the cutting force of T6-T6I4 was significantly smaller than without the cryogenically treated samples.
Journal ArticleDOI
Review of intelligent fault diagnosis for permanent magnet synchronous motors in electric vehicles
TL;DR: The methods of intelligent fault diagnosis for electric vehicle permanent magnet synchronous motors provides theoretical basis for motor fault diagnosis and health management in multi-variable working conditions and multi-physics environment.
Journal ArticleDOI
Evaluation of Microstructure and Mechanical Properties of Explosive-Welded HSLA/304L Steel Bimetallic Plates
TL;DR: In this paper, high strength low alloy (HSLA) steel 10CrNi3MoV and stainless steel 304L (SS304L) were used to manufacture bimetallic plates by explosive welding.
Journal ArticleDOI
Microstructure evolution and enhanced mechanical properties of additive manufacturing Al-Zn-Mg-Li alloy via forging and aging treatment
TL;DR: In this paper , multidirectional forging and aging treatment were applied to tune the microstructure and mechanical properties of wire arc additive manufacturing Al-Zn-Mg-Li alloy.
References
More filters
Journal ArticleDOI
A study of the manufacturing of tie-rod ends with casting/forging process
TL;DR: In this paper, a finite element analysis was performed to determine an optimal configuration of the cast preform, and a forging experiment was carried out to make the final product of an aluminium tie-rod end.
Journal ArticleDOI
Fracture of an automobile anti-roll bar
TL;DR: In this article, the fracture analysis of an anti-roll bar of an automobile is carried out and the microstructure and chemical compositions of the material are determined, and a stress analysis is also performed by the finite element technique for the determination of highly stressed regions on the bar.
Journal ArticleDOI
The Effects of Machining-induced Surface Topography on Fatigue Performance of Titanium Alloy Ti-6Al-4V
TL;DR: In this paper, surface topography was characterized in peripheral milling of titanium alloy Ti-6Al-4V and then, low cycle fatigue performances of machined specimens were studied on the basis of the tension-tension tests.
Journal ArticleDOI
Failure mechanism of sucker rod coupling
TL;DR: In this paper, three samples with different service times are selected from California oil fields and analyzed in details, and a comparison of the dimensions and macro-morphologies of the samples with varying service times is used to reveal the failure process.
Journal ArticleDOI
Fracture failure analysis of internal teeth of ring gear used in reducer of coal mining machine
TL;DR: In this article, a failure investigation has been conducted on a ring gear of cutting gear reducer used in coal mining and the fracture failure of this ring gear occurred in a trial run state after it was put into service within only 8h.