Open AccessBook
Statistical quality control : a modern introduction
Reads0
Chats0
TLDR
Part I: Introduction Chapter 1: Quality Improvement in the Modern Business Environment Chapter 2: The DMAIC Process Chapter 3: Statistical Methods Useful in Quality Control and Improvement Chapter 4: Inferences about Process QualityAbstract:
Part I: Introduction Chapter 1: Quality Improvement in the Modern Business Environment Chapter 2: The DMAIC Process Part II: Statistical Methods Useful in Quality Control and Improvement Chapter 3: Modeling Process Quality Chapter 4: Inferences about Process Quality Part III: Basic Methods of Statistical Process Control and Capability Analysis Chapter 5: Methods and Philosophy of Statistical Process Control Chapter 6: Control Charts for Variables Chapter 7: Control Charts for Attributes Chapter 8: Process and Measurement System Capability Analysis Part IV: Other Statistical Process-Monitoring and Control Techniques Chapter 9: Cumulative Sum and Exponentially Weighted Moving Average Control Charts Chapter 10: Other Univariate Statistical Process Monitoring and Control Techniques Chapter 11: Multivariate Process Monitoring and Control Chapter 12: Engineering Process Control and SPC Part V: Process Design and Improvement with Designed Experiments Chapter 13: Factorial and Fractional Experiments for Process Design and Improvements Chapter 14: Process Optimization and Designed Experiments Part VI: Acceptance Sampling Chapter 15: Lot-by-Lot Acceptance Sampling for Attributes Chapter 16: Other Acceptance Sampling Techniques Appendixread more
Citations
More filters
Journal ArticleDOI
Comparative statistical analysis of selected control charts for highly capable processes
Eva Jarošová,Darja Noskievičová +1 more
TL;DR: In this paper, the authors compared the performance of CCC, CCC-r and geometric CUSUM (CCC-CUSUM-R) charts and found that for in-control p 0 equal to 0.0002 the CCCr chart performs best especially for shifts around the pre-specifi ed out-of-control fraction nonconforming.
Journal ArticleDOI
Optimal estimated process parameters side sensitive group runs chart based on expected average run length.
TL;DR: This paper proposes the optimal design of the estimated process parameters SSGR chart based on the EARL criterion and demonstrates the application with actual data taken from a manufacturing company.
Journal ArticleDOI
Design of a steady-state in situ test to determine the air permeability coefficient of covercrete
TL;DR: In this paper, an in situ air permeability test method that does not require assumptions for the often-difficult unidirectional flow has been developed to calculate the air leakage coefficient of the near surface concrete.
Journal Article
Modified Group Chain Acceptance Sampling Plans (MGChSP) based on the Minimum Angle Method
TL;DR: The minimum angle method for the modified group chain acceptance sampling plansatisfies both parties, consumer and producer, while the number of groups for the established MGChSP only satisfied the consumer.
Proceedings ArticleDOI
Optimization of Deep Learning Hyperparameters with Experimental Design in Exchange Rate Prediction
TL;DR: Experimental design which is a statistical technique is used to identify the optimum hyperparameters within a given range for the prediction of USD/CAD exchange rate for 2019.