There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality.

Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

I and i

The rapid development of the RF power electronics requires the introduction of wide bandgap material due to its potential in high output power density, high operation voltage and high input impedance GaN-based RF power devices have made substantial progresses in the last decade This paper attempts to review the latest developments of the GaN HEMT technologies, including material growth, processing technologies, device epitaxial structures and MMIC designs, to achieve the state-of-the-art microwave and millimeter-wave performance The reliability and manufacturing challenges are also discussed

GaN-Based RF Power Devices and Amplifiers

Industries such as the automotive, aerospace or military, as well as environmental and biological research have promoted the development of ultraviolet (UV) photodetectors capable of operating at high temperatures and in hostile environments. UV-enhanced Si photodiodes are hence giving way to a new generation of UV detectors fabricated from wide-bandgap semiconductors, such as SiC, diamond, III-nitrides, ZnS, ZnO, or ZnSe. This paper provides a general review of latest progresses in wide-bandgap semiconductor photodetectors.

https://iopscience.iop.org/article/10.1088/0268-1242/18/4/201/pdf

Wide-bandgap semiconductor ultraviolet photodetectors

https://absimage.aps.org/image/MAR14/MWS_MAR14-2014-020819.pdf

Van der Waals heterostructures

Gallium nitride (GaN) is a compound semiconductor that has tremendous potential to facilitate economic growth in a semiconductor industry that is silicon-based and currently faced with diminishing returns of performance versus cost of investment. At a material level, its high electric field strength and electron mobility have already shown tremendous potential for high frequency communications and photonic applications. Advances in growth on commercially viable large area substrates are now at the point where power conversion applications of GaN are at the cusp of commercialisation. The future for building on the work described here in ways driven by specific challenges emerging from entirely new markets and applications is very exciting. This collection of GaN technology developments is therefore not itself a road map but a valuable collection of global state-of-the-art GaN research that will inform the next phase of the technology as market driven requirements evolve. First generation production devices are igniting large new markets and applications that can only be achieved using the advantages of higher speed, low specific resistivity and low saturation switching transistors. Major investments are being made by industrial companies in a wide variety of markets exploring the use of the technology in new circuit topologies, packaging solutions and system architectures that are required to achieve and optimise the system advantages offered by GaN transistors. It is this momentum that will drive priorities for the next stages of device research gathered here.

/pdf/the-2018-gan-power-electronics-roadmap-2iunv619fh.pdf

The 2018 GaN power electronics roadmap

Al/sub 0.26/Ga/sub 0.74/N-GaN heterojunction field-effect transistors were grown by metal-organic chemical vapor deposition on high-resistivity 100-mm Si (111) substrates. Van der Pauw sheet resistance of the two-dimensional electron gas was 300 /spl Omega//square with a standard deviation of 10 /spl Omega//square. Maximum drain current density of /spl sim/1 A/mm was achieved with a three-terminal breakdown voltage of /spl sim/200 V. The cutoff frequency and maximum frequency of oscillation were 18 and 31 GHz, respectively, for 0.7-/spl mu/m gate-length devices. When biased at 50 V, a 2.14-GHz continuous wave power density of 12 W/mm was achieved with associated large-signal gain of 15.3 dB and a power-added efficiency of 52.7%. This is the highest power density ever reported from a GaN-based device grown on a silicon substrate, and is competitive with the best results obtained from conventional device designs on any substrate.

http://nitronex.com.previewyoursite.com/technical_articles/IEEE_Electron_Device_Letter_July2004.pdf

12 W/mm AlGaN-GaN HFETs on silicon substrates

Current dispersion effects have been experimentally investigated in a variety of AlGaN/GaN heterostructure FETs with large signal and switching measurements including HEMTs with doped and undoped barrier layer. A range of dispersion frequencies from 10/sup -3/ Hz to 10 GHz were observed, where the output current amplitude is drastically reduced. Through this effect the full channel charge of an AlGaN/GaN heterostructure FET may be completely depleted under specific bias conditions. This indicates that this phenomena cannot be related to deep traps alone, but is also connected to piezorelated charge states and conduction to these states.

Current instabilities in GaN-based devices

The group III-nitride material system has been demonstrated by many groups to produce high performance, heterostructure field effect transistors (HFETs). AlGaN/GaN heterostructures yield high two-dimensional electron gas densities with high carrier mobilities and simultaneous high breakdown field. Devices based on this structure perform well at high power and at high frequency operating conditions. Most AlGaN/GaN HFETs to date have been produced on sapphire or silicon carbide substrates due to the limited availability of bulk GaN substrates. There are limitations in using these substrate materials in either thermal conductivity, cost or wafer diameter. The use of silicon substrates can overcome the issues of sapphire and SiC that limit manufacturability. In this work, results from HFETs fabricated on 100-mm silicon substrates using a proprietary MOCVD reactor design will be presented. The quality and uniformity of the GaN epitaxy, the microwave characterization of these devices at 2 GHz, and the thermal performance of large periphery devices on this material will be detailed. The electrical performance of these devices is found to be comparable to that of early devices on sapphire and SiC. The results will illustrate the viability of silicon as a low cost, manufacturable platform for AlGaN based devices from the standpoint of epitaxy, device performance, and thermal power handling.

http://lehighton.com/app_notes/AlGaN%20GaN%20HFETs%20Fabricated%20on%20100mm%20GaN%20on%20Si%20Substrates.pdf

AlGaN/GaN HFETs fabricated on 100-mm GaN on silicon ( 1 1 1 ) substrates

Gallium nitride material devices and methods of forming the same are provided. The devices include an electrode-defining layer. The electrode-defining layer typically has a via formed therein in which an electrode is formed (at least in part). Thus, the via defines (at least in part) dimensions of the electrode. In some cases, the electrode-defining layer is a passivating layer that is formed on a gallium nitride material region.

Gallium nitride material devices including an electrode-defining layer and methods of forming the same

We report on frequency dependent capacitance and conductance analysis of the AlGaN/GaN/Si heterostructure field-effect transistors (HFETs) and Al2O3/AlGaN/GaN/Si metal-oxide-semiconductor HFETs (MOSHFETs) in order to investigate the trap effects in these devices. The capacitance of the HFETs exhibits significantly higher frequency dispersion than that of the MOSHFETs. Two different types of traps were found from the conductance analysis on both types of devices, fast with the time constant τ≅(0.1–1) μs and slow with τ=8 ms. The density of trap states evaluated on the HFETs was DT≅2.5×1012 and up to 1013 cm−2 eV−1 for the fast and slow traps, respectively. Analysis of the MOSHFETs yielded only slightly lower DT of the fast traps (≅1.5×1012 cm−2 eV−1), but nearly two orders of magnitude lower density of slow traps (≤4×1011 cm−2 eV−1) than those of the HFETs. This indicates an effective passivation of slow surface related traps but less influence on fast (probably bulk related) trapping states by applying an insulator on the AlGaN/GaN HFET.

Andrei Vescan

Papers

12 W/mm AlGaN-GaN HFETs on silicon substrates

Current instabilities in GaN-based devices

AlGaN/GaN HFETs fabricated on 100-mm GaN on silicon ( 1 1 1 ) substrates

Gallium nitride material devices including an electrode-defining layer and methods of forming the same

Investigation of trapping effects in AlGaN/GaN/Si field-effect transistors by frequency dependent capacitance and conductance analysis