Multiple-input multiple-output (MIMO) technology is maturing and is being incorporated into emerging wireless broadband standards like long-term evolution (LTE) [1]. For example, the LTE standard allows for up to eight antenna ports at the base station. Basically, the more antennas the transmitter/receiver is equipped with, and the more degrees of freedom that the propagation channel can provide, the better the performance in terms of data rate or link reliability. More precisely, on a quasi static channel where a code word spans across only one time and frequency coherence interval, the reliability of a point-to-point MIMO link scales according to Prob(link outage) ` SNR-ntnr where nt and nr are the numbers of transmit and receive antennas, respectively, and signal-to-noise ratio is denoted by SNR. On a channel that varies rapidly as a function of time and frequency, and where circumstances permit coding across many channel coherence intervals, the achievable rate scales as min(nt, nr) log(1 + SNR). The gains in multiuser systems are even more impressive, because such systems offer the possibility to transmit simultaneously to several users and the flexibility to select what users to schedule for reception at any given point in time [2].

/pdf/scaling-up-mimo-opportunities-and-challenges-with-very-large-puqp9v7gzk.pdf

Scaling Up MIMO: Opportunities and Challenges with Very Large Arrays

This paper presents the expected transmission count metric (ETX), which finds high-throughput paths on multi-hop wireless networks. ETX minimizes the expected total number of packet transmissions (including retransmissions) required to successfully deliver a packet to the ultimate destination. The ETX metric incorporates the effects of link loss ratios, asymmetry in the loss ratios between the two directions of each link, and interference among the successive links of a path. In contrast, the minimum hop-count metric chooses arbitrarily among the different paths of the same minimum length, regardless of the often large differences in throughput among those paths, and ignoring the possibility that a longer path might offer higher throughput.This paper describes the design and implementation of ETX as a metric for the DSDV and DSR routing protocols, as well as modifications to DSDV and DSR which allow them to use ETX. Measurements taken from a 29-node 802.11b test-bed demonstrate the poor performance of minimum hop-count, illustrate the causes of that poor performance, and confirm that ETX improves performance. For long paths the throughput improvement is often a factor of two or more, suggesting that ETX will become more useful as networks grow larger and paths become longer.

/pdf/a-high-throughput-path-metric-for-multi-hop-wireless-routing-1p4xa8p0kv.pdf

A high-throughput path metric for multi-hop wireless routing

This paper surveys recent advances in the area of very large MIMO systems. 
With very large MIMO, we think of systems that use antenna arrays with an order of magnitude more elements than in systems being built today, say a hundred antennas or more. Very large MIMO entails an unprecedented number of antennas simultaneously serving a much smaller number of terminals. The disparity in number emerges as a desirable operating condition and a practical one as well. The number of terminals that can be simultaneously served is limited, not by the number of antennas, but rather by our inability to acquire channel-state information for an unlimited number of terminals. Larger numbers of terminals can always be accommodated by combining very large MIMO technology with conventional time- and frequency-division multiplexing via OFDM. Very large MIMO arrays is a new research field both in communication theory, propagation, and electronics and represents a paradigm shift in the way of thinking both with regards to theory, systems and implementation. The ultimate vision of very large MIMO systems is that the antenna array would consist of small active antenna units, plugged into an (optical) fieldbus.

/pdf/scaling-up-mimo-opportunities-and-challenges-with-very-large-1gai688763.pdf

Scaling up MIMO: Opportunities and Challenges with Very Large Arrays

In this chapter, we will restrict our attention to the ferrites and a few other closely related materials. The great interest in ferrites stems from their unique combination of a spontaneous magnetization and a high electrical resistivity. The observed magnetization results from the difference in the magnetizations of two non-equivalent sub-lattices of the magnetic ions in the crystal structure. Materials of this type should strictly be designated as “ferrimagnetic” and in some respects are more closely related to anti-ferromagnetic substances than they are to ferromagnetics in which the magnetization results from the parallel alignment of all the magnetic moments present. We shall not adhere to this special nomenclature except to emphasize effects, which are due to the existence of the sub-lattices.

Ferromagnetic materials

Wireless vehicular communication has the potential to enable a host of new applications, the most important of which are a class of safety applications that can prevent collisions and save thousands of lives. The automotive industry is working to develop the dedicated short-range communication (DSRC) technology, for use in vehicle-to-vehicle and vehicle-to-roadside communication. The effectiveness of this technology is highly dependent on cooperative standards for interoperability. This paper explains the content and status of the DSRC standards being developed for deployment in the United States. Included in the discussion are the IEEE 802.11p amendment for wireless access in vehicular environments (WAVE), the IEEE 1609.2, 1609.3, and 1609.4 standards for Security, Network Services and Multi-Channel Operation, the SAE J2735 Message Set Dictionary, and the emerging SAE J2945.1 Communication Minimum Performance Requirements standard. The paper shows how these standards fit together to provide a comprehensive solution for DSRC. Most of the key standards are either recently published or expected to be completed in the coming year. A reader will gain a thorough understanding of DSRC technology for vehicular communication, including insights into why specific technical solutions are being adopted, and key challenges remaining for successful DSRC deployment. The U.S. Department of Transportation is planning to decide in 2013 whether to require DSRC equipment in new vehicles.

Dedicated Short-Range Communications (DSRC) Standards in the United States

An optical frequency shifter that uses mode coupling of magnetostatic waves with light having frequency ω o from a laser. A controllable external magnetic biasing field and a controlled microwave source are used to independently specify the frequency ω q and wavenumber K q of the magnetostatic wave. As a result, the mode coupling can be maintained over a range of frequencies ω q so a shifted beam of light ω o ±ω q can be produced.

Optical frequency shifter using magnetostatic waves

We have fabricated and demonstrated both wafer and waveguide electro‐optic beam scanners in KTiOPO4 using alternating domain‐inverted triangular patterns in the substrate. This device is an extension of previous work in LiTaO3. The domain inversion was achieved by pulsed electric field poling. The deflection sensitivity was 2.1 mrad/kV, compared to the calculated value of 2.3 mrad/kV for this geometry. The bandwidth of the devices was measured to be at least 200 kHz, which was limited by the high voltage driver.

Electro‐optic beam scanner in KTiOPO4

An apparatus for producing an optical spot on the order of 25 nm in a recording media. The apparatus includes an optical transducer comprising a waveguide which defines an aperture adjacent to an air bearing surface of the transducer adjacent a recording media. The transducer includes a protrusion extending beyond the plane of the air bearing surface extending toward the recording media.

Apparatus for excitation, enhancement, and confinement of surface electromagnetic waves for confined optical power delivery

Traditional wireless position-location systems, operating using propagating waves, suffer reduced performance in non-line-of-sight (NLoS) applications. Traditional systems that use quasistatic fields have instead been limited to short ranges, progressive direction-finding applications, require RF fingerprinting, or do not provide complete immunity to dielectric obstacles (use of electric fields). These limitations impose severe restrictions in applications such as tracking an American football during game play, where position and orientation tracking may be required over long ranges, and when the line-of-sight (LoS) is blocked by groups of people. A technique using magneto-quasistatic fields and complex image theory was recently shown to circumvent these problems, and to enable accurate long-range one-dimensional and two-dimensional measurements. In this work, we present three-dimensional position and orientation measurements using the magneto-quasistatic system and complex image theory over an area of 27.43 m × 27.43 m. Inverting the theoretical expression for the voltage measured at the terminals of the receiving loops to determine three-dimensional position and orientation resulted in mean and median geometric position errors of 0.77 m and 0.71 m, respectively; inclination orientation mean and median errors of 9.67° and 8.24°, respectively; and azimuthal orientation mean and median errors of 2.84° and 2.25°, respectively.

Measurements corner: Three-dimensional position and orientation measurements using magneto-quasistatic fields and complex image theory

The design and analysis of one-dimensional (1-D) electrooptic lens stacks is presented. Experimental results of a seven-element stack fabricated on Z-cut LiTaO/sub 3/ substrates using domain inversion support the analysis. The optical focusing power of these bulk stacks is shown to be voltage-controlled.

Daniel D. Stancil

Papers

Optical frequency shifter using magnetostatic waves

Electro‐optic beam scanner in KTiOPO4

Apparatus for excitation, enhancement, and confinement of surface electromagnetic waves for confined optical power delivery

Measurements corner: Three-dimensional position and orientation measurements using magneto-quasistatic fields and complex image theory

Electrooptic lens stacks on LiTaO/sub 3/ by domain inversion