Gallium nitride (GaN) and its allied binaries InN and AIN as well as their ternary compounds have gained an unprecedented attention due to their wide-ranging applications encompassing green, blue, violet, and ultraviolet (UV) emitters and detectors (in photon ranges inaccessible by other semiconductors) and high-power amplifiers. However, even the best of the three binaries, GaN, contains many structural and point defects caused to a large extent by lattice and stacking mismatch with substrates. These defects notably affect the electrical and optical properties of the host material and can seriously degrade the performance and reliability of devices made based on these nitride semiconductors. Even though GaN broke the long-standing paradigm that high density of dislocations precludes acceptable device performance, point defects have taken the center stage as they exacerbate efforts to increase the efficiency of emitters, increase laser operation lifetime, and lead to anomalies in electronic devices. The p...

/pdf/luminescence-properties-of-defects-in-gan-4hjs241x7f.pdf

Luminescence properties of defects in GaN

The rapid development of the RF power electronics requires the introduction of wide bandgap material due to its potential in high output power density, high operation voltage and high input impedance GaN-based RF power devices have made substantial progresses in the last decade This paper attempts to review the latest developments of the GaN HEMT technologies, including material growth, processing technologies, device epitaxial structures and MMIC designs, to achieve the state-of-the-art microwave and millimeter-wave performance The reliability and manufacturing challenges are also discussed

GaN-Based RF Power Devices and Amplifiers

Passive films on stainless steels—chemistry, structure and growth

The outstanding properties of SiO2, which include high resistivity, excellent dielectric strength, a large band gap, a high melting point, and a native, low defect density interface with Si, are in large part responsible for enabling the microelectronics revolution. The Si/SiO2 interface, which forms the heart of the modern metal–oxide–semiconductor field effect transistor, the building block of the integrated circuit, is arguably the worlds most economically and technologically important materials interface. This article summarizes recent progress and current scientific understanding of ultrathin (<4 nm) SiO2 and Si–O–N (silicon oxynitride) gate dielectrics on Si based devices. We will emphasize an understanding of the limits of these gate dielectrics, i.e., how their continuously shrinking thickness, dictated by integrated circuit device scaling, results in physical and electrical property changes that impose limits on their usefulness. We observe, in conclusion, that although Si microelectronic devices...

Ultrathin (<4 nm) SiO2 and Si-O-N gate dielectric layers for silicon microelectronics: Understanding the processing, structure, and physical and electrical limits

The wet etching of GaN, AlN, and SiC is reviewed including conventional etching in aqueous solutions, electrochemical etching in electrolytes and defect-selective chemical etching in molten salts. The mechanism of each etching process is discussed. Etching parameters leading to highly anisotropic etching, dopant-type/bandgap selective etching, defect-selective etching, as well as isotropic etching are discussed. The etch pit shapes and their origins are discussed. The applications of wet etching techniques to characterize crystal polarity and defect density/distribution are reviewed. Additional applications of wet etching for device fabrication, such as producing crystallographic etch profiles, are also reviewed.

Wet etching of GaN, AlN, and SiC : a review

Sampling depth of total electron and fluorescence measurements in Si L- and K-edge absorption spectroscopy

A method of growing semi-insulating GaN epilayers by ammonia molecular beam epitaxy through intentional doping with carbon is reported. Thick GaN layers of high resistivity are an important element in GaN-based heterostructure field-effect transistors. A methane ion source was used as the carbon dopant source. The cracking of the methane gas by the ion source was found to be the key to the effective incorporation of carbon. High-quality C-doped GaN layers with resistivities greater than 106 Ω cm have been grown with high reproducibility and reliability. AlGaN/GaN heterostructures grown on the C-doped semi-insulating GaN-based layers exhibited a high-mobility two-dimensional electron gas at the heterointerface, with room-temperature mobilities typically between 1000 and 1200 cm2/V s, and liquid-nitrogen-temperature mobilities up to 5660 cm2/V s. The carrier density was almost constant, with less than 3% change over the measured temperature range.

Semi-insulating C-doped GaN and high-mobility AlGaN/GaN heterostructures grown by ammonia molecular beam epitaxy

The preferred XPS methodology for measurement of SiO 2 film thickness on polished silicon surfaces is discussed. A precise measurement of the photoelectron attenuation length was made using nuclear reaction analysis (NRA) to calibrate the film thicknesses. Antic oxide films on Si, which are very reproducible in thickness, are used as test samples. Appropriate corrections for the problem of adventitions carbon are shown. Under some conditions, the phenomenon of photoelectron diffraction has a significant effect on the measurements, and improvements to the precision by rotating the sample about the normal during data acquisition are demonstrated

Film thickness measurements of SiO2 by XPS

The properties of carbon-doped GaN epilayers grown by molecular-beam epitaxy have been studied by temperature-dependent resistivity, Hall-effect measurements, x-ray diffraction, and by photoluminescence spectroscopy. Carbon doping was found to render the GaN layers highly resistive (>108 Ω cm) and quench the band edge excitonic emissions. Yellow luminescence is still present in carbon-doped GaN layers. The highly resistive state is interpreted as being caused by direct compensation by the carbon acceptors and by the consequently enhanced potential barrier at the subgrain boundaries. Evidence of dislocations joining to form potential barriers along the subgrain boundaries was observed in photoassisted wet etching experiments on electrically conducting GaN layers. GaN films grown on insulating carbon-doped base layers are of excellent transport and optical properties.

Properties of carbon-doped GaN

The mechanism of the UV photoenhanced wet etching of GaN is determined. The UV photoenhanced wet etching does not require an electrical contact to be made to the sample, and nitrides deposited on insulating substrates (such as sapphire) can be etched, unlike photoelectrochemical (PEC) wet etching. The present technique relies on adding an appropriate oxidizing agent, in this case, peroxydisulfate (S2O82−), to KOH solutions. In a similar mechanism to PEC wet etching, the regions of low defect density are preferentially etched, leaving regions of high electron recombination such as threading dislocations relatively intact. The threading dislocations may be physically broken off, either by stirring or by a postetch sonication of the sample in KOH solution. Smoothly etched surfaces can be obtained under the proper conditions. A noble metal mask acts in a catalytic manner, yielding etch rates approximately one order of magnitude greater than those observed using inert masks. The essential role of the free radi...

Jennifer A. Bardwell

Papers

Sampling depth of total electron and fluorescence measurements in Si L- and K-edge absorption spectroscopy

Semi-insulating C-doped GaN and high-mobility AlGaN/GaN heterostructures grown by ammonia molecular beam epitaxy

Film thickness measurements of SiO2 by XPS

Properties of carbon-doped GaN

Ultraviolet photoenhanced wet etching of GaN in K2S2O8 solution