Optical Waveguide Theory

Curious wave phenomena that occur in optical fibres due to the interplay of instability and nonlinear effects are reviewed.

/pdf/instabilities-breathers-and-rogue-waves-in-optics-252ilwzt4i.pdf

Instabilities, breathers and rogue waves in optics

Graphene plasmons were predicted to possess ultra-strong field confinement and very low damping at the same time, enabling new classes of devices for deep subwavelength metamaterials, single-photon nonlinearities, extraordinarily strong light-matter interactions and nano-optoelectronic switches. While all of these great prospects require low damping, thus far strong plasmon damping was observed, with both impurity scattering and many-body effects in graphene proposed as possible explanations. With the advent of van der Waals heterostructures, new methods have been developed to integrate graphene with other atomically flat materials. In this letter we exploit near-field microscopy to image propagating plasmons in high quality graphene encapsulated between two films of hexagonal boron nitride (h-BN). We determine dispersion and particularly plasmon damping in real space. We find unprecedented low plasmon damping combined with strong field confinement, and identify the main damping channels as intrinsic thermal phonons in the graphene and dielectric losses in the h-BN. The observation and in-depth understanding of low plasmon damping is the key for the development of graphene nano-photonic and nano-optoelectronic devices.

Highly confined low-loss plasmons in graphene-boron nitride heterostructures

Space-division multiplexing (SDM) uses multiplicity of space channels to increase capacity for optical communication. It is applicable for optical communication in both free space and guided waves. This paper focuses on SDM for fiber-optic communication using few-mode fibers or multimode fibers, in particular on the critical challenge of mode crosstalk. Multiple-input–multiple-output (MIMO) equalization methods developed for wireless communication can be applied as an electronic method to equalize mode crosstalk. Optical approaches, including differential modal group delay management, strong mode coupling, and multicore fibers, are necessary to bring the computational complexity for MIMO mode crosstalk equalization to practical levels. Progress in passive devices, such as (de)multiplexers, and active devices, such as amplifiers and switches, which are considered straightforward challenges in comparison with mode crosstalk, are reviewed. Finally, we present the prospects for SDM in optical transmission and networking.

Space-division multiplexing: the next frontier in optical communication

Optical fiber gratings have developed into a mature technology with a wide range of applications in various areas, including physical sensing for temperature, strain, acoustic waves and pressure. All of these applications rely on the perturbation of the period or refractive index of a grating inscribed in the fiber core as a transducing mechanism between a quantity to be measured and the optical spectral response of the fiber grating. This paper presents a relatively recent variant of the fiber grating concept, whereby a small tilt of the grating fringes causes coupling of the optical power from the core mode into a multitude of cladding modes, each with its own wavevector and mode field shape. The main consequence of doing so is that the differential response of the modes can then be used to multiply the sensing modalities available for a single fiber grating and also to increase the sensor resolution by taking advantage of the large amount of data available. In particular, the temperature cross-sensitivity and power source fluctuation noise inherent in all fiber grating designs can be completely eliminated by referencing all the spectral measurements to the wavelength and power level of the core mode back-reflection. The mode resonances have a quality factor of 105, and they can be observed in reflection or transmission. A thorough review of experimental and theoretical results will show that tilted fiber Bragg gratings can be used for high resolution refractometry, surface plasmon resonance applications, and multiparameter physical sensing (strain, vibration, curvature, and temperature).

Tilted fiber Bragg grating sensors

A 10 GHz clock recovery from a 160-Gb/s optical time-division-multiplexed data stream is experimentally demonstrated with an electro-absorption modulator and 40-Gb/s ETDM demultiplexer. The recovered clock signal exhibits excellent stability, with mean RMS jitter of 388fs and 415fs corresponding to back-to-back and transmission over 100-km, respectively.

160-Gb/s clock recovery with an electroabsorption modulator and 40-Gb/s ETDM demultiplexer

The all-fiber, multi-cavity, Fabry-Perot passband filters based on fiber Bragg gratings, up to seven, are presented and
modeled. The general formulas of the transfer function for the multiple-cavity Fabry-Perot filters are derived with the
transfer matrix method. Transmission spectrum characteristics of the filters with different number of cavities are
simulated, analyzed and compared. Numerical results show that near-rectangular bandpass shape can be realized by
choosing the proper index modulation depths for every forming FBGs. And the simulations clearly demonstrate that the
more we increase the number of cavities the more the shape of the central transmission peak is getting rectangular.

Shuisheng Jian

Papers

160-Gb/s clock recovery with an electroabsorption modulator and 40-Gb/s ETDM demultiplexer

Analysis for transmission characteristics of multi-cavity fiber Fabry-Perot filters based on fiber Bragg gratings