Journal ArticleDOI
Design and Analysis of Hall Effect Probe-Based Pressure Transmitter Using Bellows as Sensor
TLDR
The design of a noncontact pressure transducer along with a transmitting unit using bellows as the primary sensing element and a Hall sensor as secondary sensing element has been described and theoretical equations describing the operation of the proposed transducers and transmitter have been derived.Abstract:
Bellows is an elastic-type pressure sensor used as a local indicator in industry. Transmission of bellows reading to a remote location in control room is very important in pressure measurement and control system in industry. In this paper, the design of a noncontact pressure transducer along with a transmitting unit using bellows as the primary sensing element and a Hall sensor as secondary sensing element has been described. The theoretical equations describing the operation of the proposed transducer and transmitter have been derived. The function of the transducer and transmitter has been experimentally tested and the experimental results are reported in the paper. Both transducer and transmitter characteristics have been found to be linear with good repeatability. The graphical abstract is shown in Fig. 1 . Fig. 1. Graphical abstract.read more
Citations
More filters
Journal ArticleDOI
A Hall Sensor-Based Position Measurement With On-Line Model Parameters Computation for Permanent Magnet Synchronous Linear Motor
TL;DR: An on-line simultaneous computation of model parameters and position method is proposed to measure position for a permanent magnet synchronous linear motor and results indicate that the standard deviation of measurement error is less than less than 10% with the comparison of a reference optical encoder.
Journal ArticleDOI
A Comprehensive Review of Integrated Hall Effects in Macro-, Micro-, Nanoscales, and Quantum Devices.
TL;DR: An up-to-date review of the main existing devices, based on the classic and new related Hall Effects, to serve the scientific community as a basis for novel research oriented to new nanoscale devices, modules, and Process Development Kit (PDK) markets.
Journal ArticleDOI
Temperature and Nonlinearity Compensation of Pressure Sensor With Common Sensors Response
Jacek Pieniazek,Piotr Ciecinski +1 more
TL;DR: A new compensation method that features the utilization of common response of the given type of sensors and the reduction of particular sensor calibration data set, which subsequently reduces the duration of necessary experiments and demonstrates that the proposed compensation method is valid for high-accuracy measurements.
Journal ArticleDOI
A Differential Hall Effect Based Pressure Sensor
Sankalp Paliwal,Sujan Yenuganti +1 more
TL;DR: In this article, the authors presented the design and simulation of a pressure sensor integrated with two identical hall effect sensors and permanent magnets arranged in a differential configuration for measuring pressure in the range of 0-20 bar.
Journal ArticleDOI
Design and development of an electronic level transmitter based on hydrostatic principle
S. Faizan Ali,Nirupama Mandal +1 more
TL;DR: In this paper, a simple low cost HLS transmitter with diaphragm as a primary transducer and Hall sensor as a secondary transceiver is presented. But, the performance of the proposed transmitter was not analyzed.
References
More filters
Journal ArticleDOI
Study of a Pressure Transmitter Using an Improved Inductance Bridge Network and Bourdon Tube as Transducer
TL;DR: An improved inductance bridge-type technique has been developed to convert the Bourdon tube movement into an electrical current signal which can be transmitted to a remote indicator.
Proceedings ArticleDOI
A MEMS pressure sensor based on Hall effect
TL;DR: In this paper, a microfabricated pressure sensor based on the Hall effect was reported, whose output voltage is linear to the pressure and the sensitivity is 0.0288 mV/hPa.
Journal ArticleDOI
A low cost design and development of a reluctance type pressure transducer
TL;DR: In this paper, a simple low cost reluctance type pressure transducer has been developed and tested in the laboratory and has been found to follow the theoretical equations and a very good linearity and repeatability of the data has been observed.
Proceedings ArticleDOI
High sensitive FBG pressure sensor using metal bellows
TL;DR: In this paper, a fiber-optic sensor scheme, capable of the simultaneous measurement of pressure and temperature using two in-line Fiber Bragg Gratings (FBGs) is reported.
Journal ArticleDOI
Performance evaluation of a differential pressure cell model
TL;DR: The development of a mathematical model of a differential pressure cell and its application in MATLAB shows that while the majority of the subsystems are nonlinear, they can adequately be approximated by Taylor polynomials.