Open AccessBook
Fundamentals of heat and mass transfer
About:
The article was published on 2008-01-01 and is currently open access. It has received 11281 citations till now. The article focuses on the topics: Mass transfer.read more
Citations
More filters
Journal ArticleDOI
Optimization of plate-fin heat exchangers by an improved harmony search algorithm
TL;DR: Numerical results indicate that the presented approach can generate optimum solutions with higher accuracy when compared to Genetic algorithms (GAs), Particle Swarm Optimization (PSO) and GA hybrids with PSO (GAHPSO).
Journal ArticleDOI
Optimization of post-combustion CO2 process using DEA–MDEA mixtures
TL;DR: In this paper, the optimal operating conditions for the post-combustion CO 2 capture process utilizing aqueous amine solutions obtained using a process simulator (HYSYS) are considered to study the performance of the capture process.
Journal ArticleDOI
A numerical and experimental study of solidification around axially finned heat pipes for high temperature latent heat thermal energy storage units
TL;DR: In this paper, a numerical and experimental investigation was conducted on the thermal performance of latent heat thermal energy storage (LHTES) systems which use heat pipes (HPs) for solar thermal power generation.
Journal ArticleDOI
A Thermal–Hydraulic Comparison of Liquid Microchannel and Impinging Liquid Jet Array Heat Sinks for High-Power Electronics Cooling
TL;DR: In this article, two single-phase liquid cooling strategies for electronics thermal management are compared and contrasted; impinging jet arrays and laminar flow in microchannels, for a situation in which an electronic device must dissipate 250 W/cm2 while being maintained at a temperature of 85degC.
Journal ArticleDOI
Hybrid Cooling Method of Axial-Flux Permanent-Magnet Machines for Vehicle Applications
M. Polikarpova,Pavel Ponomarev,Pia Lindh,Ilya Petrov,Werner Jara,Ville Naumanen,Juan A. Tapia,Juha Pyrhonen +7 more
TL;DR: This paper provides experimental verification of the simulation results on a 100-kW AFPM electrical machine and proposes a hybrid cooling arrangement that consists of a frame cooling circuit with a water flow inside, a set of copper bars inserted in the teeth, and a segment of potting material around the end windings.