Journal ArticleDOI
Investigation into the machining of carbon-fibre-reinforced plastics with cemented carbides
TLDR
In this article, face turning trials were performed on carbon-fibre-reinforces plastics (CFRP) using sintered carbides (P30 and K20).About:
This article is published in Journal of Materials Processing Technology.The article was published on 1992-04-01. It has received 29 citations till now. The article focuses on the topics: Machining.read more
Citations
More filters
Journal ArticleDOI
Machining of Carbon Fiber Reinforced Plastics/Polymers: A Literature Review
TL;DR: A comprehensive literature review on machining of carbon fiber reinforced plastics/polymers is given with a focus on five main issues including conventional and unconventional hybrid processes for CFRP machining, cutting theories and thermal/mechanical response studies, numerical simulations, tool performance and tooling techniques, and economic impacts as mentioned in this paper.
Journal ArticleDOI
Recent advances in drilling hybrid FRP/Ti composite: A state-of-the-art review
TL;DR: In this paper, a rigorous review concerning the state-of-the-art results and advances on drilling solutions of hybrid FRP/Ti composite was presented by referring to the wide comparisons among literature analyses.
Journal ArticleDOI
Orthogonal cutting of fiber-reinforced composites: A finite element analysis
Dwayne Arola,Mamidala Ramulu +1 more
TL;DR: In this article, a dual fracture process was used to simulate chip formation incorporating both the maximum stress and Tsai-Hill failure criteria, and the principal cutting force predictions agreed very well with those obtained from experiments.
Journal ArticleDOI
Machining optimisation in carbon fibre reinforced composite materials
TL;DR: In this paper, the authors report practical experiments in turning, to study the performance of different tool materials such as ceramics, cemented carbide, cubic boron nitride (CBN), and diamond (PCD).
Journal ArticleDOI
Machinability study of glass fibre-reinforced polymer composites during end milling
TL;DR: In this paper, the effect of spindle speed, feed rate, and depth of cut on the machinability of GFRP composites in end milling has been investigated.
References
More filters
Journal ArticleDOI
Machining of Fibre Reinforced Plastics
TL;DR: In this paper, the major parameters determining the cutting result, especially with respect to the quality, are discussed and explained, as far as possible, as well as the tool geometry and cutting conditions are discussed.
Journal ArticleDOI
The Cutting Process, Chips and Cutting Forces in Machining CFRP
A. Koplev,Aage Lystrup,T. Vorm +2 more
TL;DR: In this paper, the cutting forces parallel and perpendicular to the cutting direction are measured for various parameters, and the results correlated to the formation of chips and the wear of the tool, and a new chip preparation technique is used for the investigation.
Journal ArticleDOI
Tool Wear in Cutting Carbon-fiber-reinforced Plastics : The Effect of Physical Properties of Tool Materials
TL;DR: In this article, a turning test on glass-fiber-reinforced-plastics was performed with several tool materials, e.g., sintered carbides, cermets and ceramics, and the wear patterns and wear land growth rate were analyzed to clarify the relationship between physical (mechanical) properties and flank wear of cutting tools.
Related Papers (5)
Damage and dimensional precision on milling carbon fiber-reinforced plastics using design experiments
J. Paulo Davim,Pedro Reis +1 more