Investigation of the Suitability of Surface Treatments for Dry Cold Extrusion by Process-Oriented Tribological Testing

Abstract: In cold extrusion of aluminum alloys adhesive wear can be prevented by an excessive lubrication of the process. While this causes additional process steps also environmental risks have to be addressed. Hence, dry metal forming, i.e. avoiding lubrication by means of coatings and topography modifications is highly desirable. In this paper first results concerning the behavior of tailored surfaces under dry metal forming conditions for pure aluminum are presented. Different surface treatments (laser polishing and Mo2BC coating) of the tool steel AISI H11 are tested in a compression-torsion-tribometer under conditions adapted from cold extrusion. Normal stresses six times higher than the initial yield stress of the tested workpiece material pure aluminum (AA1050-O) are applied. Furthermore, a strategy for the characterization of aluminum adhesions to the tool is introduced. The influences of different topographies and the presence of a coating on the loss of material due to adhesive wear are investigated.