Journal ArticleDOI
Morphology of y’ and y” precipitates and thermal stability of inconel 718 type alloys
R. Cozar,André Pineau +1 more
- Vol. 4, Iss: 1, pp 47-59
Reads0
Chats0
TLDR
In this article, the precipitation microstructure varies rapidly with aging temperature and composition, and the influence of composition and aging temperature on the conditions that bring about this compact morphology has been investigated.Abstract:
The precipitation of the γ’ (Ll2) and γ" (DO22) phases has been studied in four alloys Fe-Ni-Cr-Ti-Al-Nb containing a higher Ti + Al/Nb ratio than that of the INCONEL 718 alloy. For these alloys, the precipitation microstructure varies rapidly with aging temperature and composition. Bct γ"particles have always been found to precipitate on γ’ phase. Moreover, by aging three alloys above a critical temperature, a “compact ntorphology” has been observed: cube-shaped γ’ particles coated on their six faces with a shell of γ" precipitate. This microstructure has proved to be very stable on prolonged aging. A thermal stability better than that encountered in nominal INCONEL 718 alloy can thus be achieved. The influence of composition and aging temperature on the conditions that bring about this “compact morphology” has been investigated. A minimal Ti + Al/Nb ratio between 0.9 and 1 has been determined, allowing the “compact morphology” to be obtained.read more
Citations
More filters
Journal ArticleDOI
Microstructure and mechanical properties of in-situ synthesized Ti(N,C) strengthen IN718/1040 steel laminate by directed energy deposition
TL;DR: In this paper , in-situ synthesized ceramic strengthening phase by adding Ti powder to the depositing material improves the microhardness from and tensile strength significantly, which provides a reference for designing and fabricating new high-performance laminates.
Journal ArticleDOI
Hardness Variation in Inconel 718 Produced by Laser Directed Energy Deposition
Lova Chechik,KA Christofidou,Jonathon F. S. Markanday,Alexander D. Goodall,James Miller,Geoff West,Howard A. Stone,Iain Todd +7 more
TL;DR: In this paper , a simple precipitation potential model based on a moving heat source was found to correlate with the measured hardness and explain the hardness distribution observed, and it has been shown that sections under a critical thickness of 2 mm never reach the peak hardness in the as-built condition.
References
More filters
Journal ArticleDOI
The Determination of the Elastic Field of an Ellipsoidal Inclusion, and Related Problems
TL;DR: In this paper, it is shown that to answer several questions of physical or engineering interest, it is necessary to know only the relatively simple elastic field inside the ellipsoid.
Journal ArticleDOI
Déformations de cohérence d'un précipité quadratique
TL;DR: In this paper, exact expressions for the elastic field due to a perfectly coherent precipitate having the form of a rectangular parallelepiped, the material being supposed elastically homogeneous and isotropic.
Journal ArticleDOI
The microstructure of 706, a new Fe−Ni-base superalloy
TL;DR: In this article, the phase relationships of Alloy 706 alloy were investigated and it was shown that on the basis of chemistry and micro-structural response, Alloy 606 alloy can be considered to be intermediate to the well-known alloys, 718 and 901.
Journal ArticleDOI
Heterogeneous precipitation of metastable γ′-ni3ti in a nickelbase alloy
TL;DR: In this article, the effect of prior deformation on the precipitation of L12 γ′-Ni3Ti in nickel-base Alloy 901 was investigated by thin foil microscopy.
Journal ArticleDOI
Fine Faults and Crystal Structures of Precipitates in Fe-Mo and Fe-W Alloys
Kōhei Yagisawa,Hiroshi Fujita +1 more
TL;DR: In this paper, the crystal structure and two-dimensional faults of the precipitates in Fe-Mo alloys were investigated using electron microscopic method, and the faults were found on {00.1}hex, {10.0}hex and {100}hex planes.