Rheology of unsaturated polyester resins. I. Effects of filler and low‐profile additive on the rheological behavior of unsaturated polyester resin

TLDR: In this paper, the authors measured the bulk rheological properties of concentrated suspensions of particulates in unsaturated polyester resins, using a cone-and-plate rheometer.

Abstract: Measurements were taken of the bulk rheological properties of concentrated suspensions of particulates in unsaturated polyester resins, using a cone-and-plate rheometer. The particulates used were clay, calcium carbonate, and milled glass fiber. With clay and milled glass fibers, shear-thinning behavior of suspensions was observed at low shear rates or low shear stresses as the concentration of particulates was increased, whereas concentrated suspensions of calcium carbonate exhibited Newtonian behavior over the range of shear stresses or shear rates investigated. The cone-and-plate rheometer was also used for measurements of the bulk rheological properties of various mixtures of polyester resin and low-profile additives. For low-profile additives, solutions, in styrene, of poly(vinyl acetate) (PVAc) and poly(methyl methacrylate) (PMMA) were used. It was found that the bulk viscosities of all mixtures of polyester resin and PVAc solution lie between those of the individual components, whereas the bulk viscosities of some mixtures of polyester resin and PMMA solution go through a minimum and a maximum, depending on the composition of the mixture. While all mixtures of polyester resin and PVAc solution exhibited negligible normal stress, some mixtures of polyester resin and PMMA solution exhibited noticeable normal stresses. It should be mentioned that polyester resin follows Newtonian behavior. It turned out that all mixtures of polyester resin and PVAc solution exhibited clear, homogeneous solutions, whereas mixtures of polyester resin and PMMA solution exhibited optical heterogeneity, i.e., turbidity. When polyethylene powders were used as low-profile additives, suspensions of polyester resin and polyethylene powders exhibited negative values of normal stress as the concentrations of suspension reached a critical value. When both filler and low-profile additive were put together in polyester resin, the rheological behavior became quite complex, indicating that some interactions exist between the filler and the low-profile additive.