Journal ArticleDOI
The effect of glass additives on the microwave dielectric properties of Ba(Mg1/3Ta2/3)O3 ceramics
Reads0
Chats0
TLDR
In this article, the effect of glass additives on the densification, phase evolution, microstructure and microwave dielectric properties of Ba(Mg{sub 1/3}Ta{sub 2/3})O{sub 3} (BMT) was investigated.About:
This article is published in Journal of Solid State Chemistry.The article was published on 2004-11-01. It has received 100 citations till now.read more
Citations
More filters
Journal ArticleDOI
Low loss dielectric materials for LTCC applications: a review
TL;DR: In this paper, the authors present a review of low temperature co-fired ceramic (LTCC) technologies for high frequency applications, which will be of immense help to researchers and technologists all over the world.
Journal ArticleDOI
Low-loss dielectric ceramic materials and their properties
TL;DR: In this paper, the data for all reported low-loss microwave dielectric ceramic materials are collected and tabulated and the table of these materials gives the relative permittivity, quality factor, temperature variation of the resonant frequency, crystal structure, sintering temperature, measurement
Journal ArticleDOI
Forsterite-based ceramic–glass composites for substrate applications in microwave and millimeter wave communications
TL;DR: In this paper, the effect of lithium borosilicate (LBS) glass addition on sintering temperature and microwave dielectric properties of forsterite was investigated.
Journal ArticleDOI
Densification and characterization of SiO2-B2O3-CaO-MgO glass/Al2O3 composites for LTCC application
TL;DR: In this paper, a glass/ceramic composite using lead-free low melting glass (SiO2-B2O3-CaO-MgO glass) with Al 2O3 fillers was investigated.
Journal ArticleDOI
Microwave Dielectric Properties and Low-Temperature Sintering of Cerium Oxide for LTCC Applications
TL;DR: In this paper, the effect of glass additives on the microstructure, densification, and microwave dielectric properties of cerium oxide for low-temperature co-fired applications was investigated.
References
More filters
Journal ArticleDOI
A Dielectric Resonator Method of Measuring Inductive Capacities in the Millimeter Range
B.W. Hakki,P.D. Coleman +1 more
TL;DR: In this article, a novel technique for the measurement of dielectric and magnetic properties of a homogeneous isotropic medium in the range of approximately 3 to 100 kmc is described.
Book
Ceramic Processing and Sintering
TL;DR: Ceramic fabrication processes -an introductory overview synthesis of powders powder characterization science of colloidal processing sol-gel processing powder consolidation and forming of ceramics sintering of ceramic materials.
Journal ArticleDOI
Analysis and Evaluation of a Method of Measuring the Complex Permittivity and Permeability Microwave Insulators
TL;DR: In this article, a resonant post technique for characterizing dielectric and magnetic materials at microwave frequencies was proposed and experimental results of the temperature dependence of the relative dielectrics constant of nonmagnetic materials with /spl epsilon/sub r/, varying from 4 to 60, and also loss tangent measurements at room temperature.
Journal ArticleDOI
Effects of Glass Additions on (Zr,Sn)TiO4 for Microwave Applications
TL;DR: In this article, the effects of glass additions on the properties of (Zr,Sn)TiO4 as a microwave dielectric material were investigated and the results of XRD analysis and scanning electron microscopy and the effect of glass content are also presented.
Journal ArticleDOI
Compositions of MgTiO3–CaTiO3 ceramic with two borosilicate glasses for LTCC technology
TL;DR: In this paper, two-stage sintering behavior was observed in both materials, starting at around 600 and 850°C, and nearly full density (97%) was achieved in ZSB/MMT-20 and BaO-SiO 2 -B 2 O 3 /MgTiO 3 -CaTiO3
Related Papers (5)
A Dielectric Resonator Method of Measuring Inductive Capacities in the Millimeter Range
B.W. Hakki,P.D. Coleman +1 more