Ultrasensitive Chemical Analysis by Raman Spectroscopy

TLDR: The spontaneous Raman effect has attracted attention from a basic research point of view as well as a powerful spectroscopic technique with many practical applications as discussed by the authors, however, it has not yet advanced the field of ultrasensitive trace detection.

Abstract: In the Raman effect, incident light is inelastically scattered from a sample and shifted in frequency by the energy of its characteristic molecular vibrations. Since its discovery in 1927, the effect has attracted attention from a basic research point of view as well as a powerful spectroscopic technique with many practical applications. The advent of laser light sources with monochromatic photons at high flux densities was a milestone in the history of Raman spectroscopy and resulted in dramatically improved scattering signals (for a general overview of modern Raman spectroscopy, see refs 1-5). In addition to this so-called spontaneous or incoherent Raman scattering, the development of lasers also opened the field of stimulated or coherent Raman spectroscopies, in which molecular vibrations are coherently excited. Whereas the intensity of spontaneous Raman scattering depends linearly on the number of probed molecules, the coherent Raman signal is proportional to the square of this number (for an overview, see refs 6 and 7). Coherent Raman techniques can provide interesting new opportunities such as vibrational imaging of biological samples,8 but they have not yet advanced the field of ultrasensitive trace detection. Therefore, in the following article, we shall focus on the spontaneous Raman effect, in the following simply called Raman scattering. Today, laser photons over a wide range of frequencies from the near-ultraviolet to the near-infrared region are used in Raman scattering studies, allowing selection of optimum excitation conditions for each sample. By choosing wavelengths which excite appropriate electronic transitions, resonance Raman studies of selected components of a sample or parts of a molecule can be performed.9 In the past few years, the range of excitation wavelengths has been extended to the near-infrared (NIR) region, in which background fluorescence is reduced and photoinduced degradation from the sample is diminished. High-intensity NIR diode lasers are easily available, making this region attractive for compact, low cost Raman instrumentation. Further, the development of low noise, high quantum efficiency multichannel detectors (chargecoupled device (CCD) arrays), combined with highthroughput single-stage spectrographs used in combination with holographic laser rejection filters, has led to high-sensitivity Raman spectrometers (for an overview on state-of-the-art NIR Raman systems, see ref 10). As we shall show in section 2, the nearinfrared region also has special importance for ultrasensitive Raman spectroscopy at the singlemolecule level. As with optical spectroscopy, the Raman effect can be applied noninvasively under ambient conditions in almost every environment. Measuring a Raman spectrum does not require special sample preparation techniques, in contrast with infrared absorption spectroscopy. Optical fiber probes for bringing excitation laser light to the sample and transporting scattered light to the spectrograph enable remote detection of Raman signals. Furthermore, the spatial and temporal resolution of Raman scattering are determined by the spot size and pulse length, respectively, of the excitation laser. By using a confocal microscope, Raman signals from femtoliter volumes (∼1 μm3) can by observed, enabling spatially resolved measurements in chromosomes and cells.11 Techniques such as multichannel Hadamard transform Raman microscopy12,13 or confocal scanning Fourier transform Raman microscopy14 allow generation of high-resolution Raman images of a sample. Recently, Raman spectroscopy was performed using near-field optical microscopy.15-17 Such techniques overcome the diffraction limit and allow volumes significantly smaller than the cube of the wavelength to be investigated. In the time domain, Raman spectra can be measured on the picosecond time scale, providing information on short-lived species such as excited 2957 Chem. Rev. 1999, 99, 2957−2975