B
Bhagwati Prasad Kashyap
Researcher at Indian Institute of Technology Bombay
Publications - 151
Citations - 3269
Bhagwati Prasad Kashyap is an academic researcher from Indian Institute of Technology Bombay. The author has contributed to research in topics: Strain rate & Superplasticity. The author has an hindex of 31, co-authored 148 publications receiving 2796 citations. Previous affiliations of Bhagwati Prasad Kashyap include University of Manitoba & University of California, Davis.
Papers
More filters
Journal ArticleDOI
Study on the substructure evolution and flow behaviour in type 316L stainless steel over the temperature range 21-900°C
TL;DR: In this paper, the normalized yield and flow stresses against temperature plots exhibit three regions: regions I and III, where the stresses decrease with increasing temperature, they increase with an increasing temperature in region II.
Journal ArticleDOI
On the hot working characteristics of 6061Al-SiC and 6061-Al2O3 particulate reinforced metal matrix composites
TL;DR: In this paper, a simple instability condition for assessing the extent of plastic deformation in a workpiece prior to the formation of defects, is derived based on the Ziegler's continuum principles.
Journal ArticleDOI
Dynamic Recrystallization during Hot Deformation of 304 Austenitic Stainless Steel
TL;DR: In this paper, the kinetics of dynamic recrystallization (DRX) during hot compression of 304 austenitic stainless steel was studied over the temperature range of 900-1200°C and strain rate range of 0.002-0.1 s−1.
Journal ArticleDOI
Microstructural evolution during reactive brazing of alumina to Inconel 600 using Ag-based alloy
TL;DR: In this paper, a metal-ceramic bonding process was developed to produce vacuum tight alumina-Inconel 600 joints using an Ag-based active metal brazing alloy that can withstand continuous operating temperature up to 560°C.
Journal ArticleDOI
Microstructure refinement and its effect on specific strength and bio-corrosion resistance in ultralight Mg–4Li–1Ca (LC41) alloy by hot rolling
S.S. Nene,S.S. Nene,Bhagwati Prasad Kashyap,Nityanand Prabhu,Yuri Estrin,Yuri Estrin,Yuri Estrin,Talal Al-Samman +7 more
TL;DR: In this paper, a ternary alloy Mg-4Li-1Ca (LC41) was hot rolled at 300°C, which resulted in refinement of the grain size from 100μm to 5μm by recrystallization.