There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality.

Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

I and i

The term photonic crystals appears because of the analogy between electron waves in crystals and the light waves in artificial periodic dielectric structures. During the recent years the investigation of one-, two-and three-dimensional periodic structures has attracted a widespread attention of the world optics community because of great potentiality of such structures in advanced applied optical fields. The interest in periodic structures has been stimulated by the fast development of semiconductor technology that now allows the fabrication of artificial structures, whose period is comparable with the wavelength of light in the visible and infrared ranges.

http://ieeexplore.ieee.org/iel5/6354/16969/00781867.pdf

Photonic crystals

Metal interconnections are expected to become the limiting factor for the performance of electronic systems as transistors continue to shrink in size. Replacing them by optical interconnections, at different levels ranging from rack-to-rack down to chip-to-chip and intra-chip interconnections, could provide the low power dissipation, low latencies and high bandwidths that are needed. The implementation of optical interconnections relies on the development of micro-optical devices that are integrated with the microelectronics on chips. Recent demonstrations of silicon low-loss waveguides, light emitters, amplifiers and lasers approach this goal, but a small silicon electro-optic modulator with a size small enough for chip-scale integration has not yet been demonstrated. Here we experimentally demonstrate a high-speed electro-optical modulator in compact silicon structures. The modulator is based on a resonant light-confining structure that enhances the sensitivity of light to small changes in refractive index of the silicon and also enables high-speed operation. The modulator is 12 micrometres in diameter, three orders of magnitude smaller than previously demonstrated. Electro-optic modulators are one of the most critical components in optoelectronic integration, and decreasing their size may enable novel chip architectures.

Micrometre-scale silicon electro-optic modulator

Optical technology is poised to revolutionize short-reach interconnects. The leading candidate technology is silicon photonics, and the workhorse of such an interconnect is the optical modulator. Modulators have been improved dramatically in recent years, with a notable increase in bandwidth from the megahertz to the multigigahertz regime in just over half a decade. However, the demands of optical interconnects are significant, and many questions remain unanswered as to whether silicon can meet the required performance metrics. Minimizing metrics such as the device footprint and energy requirement per bit, while also maximizing bandwidth and modulation depth, is non-trivial. All of this must be achieved within an acceptable thermal tolerance and optical spectral width using CMOS-compatible fabrication processes. This Review discusses the techniques that have been (and will continue to be) used to implement silicon optical modulators, as well as providing an outlook for these devices and the candidate solutions of the future.

/pdf/silicon-optical-modulators-578o7o6kvr.pdf

Silicon optical modulators

Silicon has long been the optimal material for electronics, but it is only relatively recently that it has been considered as a material option for photonics1. One of the key limitations for using silicon as a photonic material has been the relatively low speed of silicon optical modulators compared to those fabricated from III–V semiconductor compounds2,3,4,5,6 and/or electro-optic materials such as lithium niobate7,8,9. To date, the fastest silicon-waveguide-based optical modulator that has been demonstrated experimentally has a modulation frequency of only ∼20 MHz (refs 10, 11), although it has been predicted theoretically that a ∼1-GHz modulation frequency might be achievable in some device structures12,13. Here we describe an approach based on a metal–oxide–semiconductor (MOS) capacitor structure embedded in a silicon waveguide that can produce high-speed optical phase modulation: we demonstrate an all-silicon optical modulator with a modulation bandwidth exceeding 1 GHz. As this technology is compatible with conventional complementary MOS (CMOS) processing, monolithic integration of the silicon modulator with advanced electronics on a single silicon substrate becomes possible.

A high-speed silicon optical modulator based on a metal–oxide–semiconductor capacitor

Volume transmission phase holographic lenses were designed and recorded to obtain a simple, lightweight, compact and inexpensive planar solar concentrator. To avoid any mechanical movement, a passive solar tracking system is also proposed by using angular multiplexed holographic lenses. Furthermore, these solar concentrators have no overheating problems resulting from the absorption of infrared frequencies, because in this spectral region the proposed volume holographic lenses do not work. Finally, the realized samples were tested and a good efficiency was obtained.

Volume Phase Holographic Lenses for Efficient Planar Solar Track-Concentrators

In this work we have investigated the performance of Schottky photodetectors based on materials non-conventionally used to detect near-infrared wavelengths. In the proposed devices the absorption mechanism is based on the internal photoemission effect. Both three-dimensional (sputtered erbium and evaporated germanium) and two-dimensional materials (graphene) have been considered and their performance compared. Our insights show that silicon Schottky photodetectors have the potentialities to play a key role in the telecommunications opening new frontiers in the field of low-cost silicon photonics.

Near-infrared silicon Schottky photodiodes based on non-metallic materials

Currently, a major technical limitation of microscopy based image analysis is linkage error – a visualization error that is measured by the distance between the cellular protein to be detected and the fluorescence emitter used for detection. With continuously improving resolution of today′s (super-resolution) microscopes, the linkage errors can severely hamper the correct interpretation of images and is usually introduced in experiments by the use of standard intracellular staining reagents such as fluorescently labelled antibodies. The linkage error of standard labelled antibodies is caused by the size of the antibody and the random distribution of fluorescent emitters on the antibody surface. Together, these two factors account for a fluorescence displacement of ~40nm when staining proteins by indirect immunofluorescence; and ~20nm when staining with fluorescently coupled primary antibodies. In this study, we describe a class of staining reagents that effectively reduce the linkage error by more than five-fold when compared to conventional staining techniques. These reagents, called Fluo–N–Fabs, consist of an antigen binding fragment of a full-length antibody (Fab/ fragment antigen binding) that is selectively conjugated at the N-terminal amino group with fluorescent organic molecules, thereby reducing the distance between the fluorescent emitter and the protein target of the analysis. Fluo–N–Fabs also exhibit the capability to penetrate tissues and highly crowded cell compartments, thus allowing for the efficient detection of cellular epitopes of interest in a wide range of fixed samples. We believe this class of reagents realize an unmet need in cell biological super resolution imaging studies where the precise localization of the target of interest is crucial for the understanding of complex biological phenomena.

/pdf/precision-localization-of-cellular-proteins-with-fluorescent-4rbqqq6k0w.pdf

Giuseppe Coppola

Papers

Volume Phase Holographic Lenses for Efficient Planar Solar Track-Concentrators

Near-infrared silicon Schottky photodiodes based on non-metallic materials

Precision localization of cellular proteins with fluorescent Fab-based probes