Showing papers by "Mark Blei published in 2018"
TL;DR: The experimental results demonstrate that the 2D GeAs crystals have promising potential for polarization optical applications, and are consistent with the theoretical calculation of band structure and band realignment.
Abstract: The ability to detect linearly polarized light is central to practical applications in polarized optical and optoelectronic fields and has been successfully demonstrated with polarized photodetection of in-plane anisotropic two-dimensional (2D) materials. Here, we report the anisotropic optical characterization of a group IV-V compound-2D germanium arsenic (GeAs) with anisotropic monoclinic structures. High-quality 2D GeAs crystals show the representative angle-resolved Raman property. The in-plane anisotropic optical nature of the GeAs crystal is further investigated by polarization-resolved absorption spectra (400-2000 nm) and polarization-sensitive photodetectors. From the visible to the near-infrared range, 2D GeAs nanoflakes demonstrate the distinct perpendicular optical reversal with a 75-80° angle on both the linear dichroism and polarization-sensitive photodetection. Obvious anisotropic features and the high dichroic ratio of Ipmax /Ipmin ∼ 1.49 at 520 nm and Ipmax /Ipmin ∼ 4.4 at 830 nm are achieved by the polarization-sensitive photodetection. The polarization-dependent photocurrent mapping implied that the polarized photocurrent mainly occurred at the Schottky photodiodes between electrode/GeAs interface. These experimental results are consistent with the theoretical calculation of band structure and band realignment. Besides the excellent polarization-sensitive photoresponse properties, GeAs-based photodetectors also exhibit rapid on/off response. These results demonstrate that the 2D GeAs crystals have promising potential for polarization optical applications.
131 citations
TL;DR: An anomalous phase instability, accompanied by a band bowing effect, is observed in GaSe1-xTex alloys on GaAs(111), highlighting unique alloying effects, not existing in single-phase alloys, and phase engineering routes for potential applications in photonic and electronics.
Abstract: Akin to the enormous number of discoveries made through traditional semiconductor alloys, alloying selected 2D semiconductors enables engineering of their electronic structure for a wide range of new applications. 2D alloys have been demonstrated when two components crystallized in the same phase, and their bandgaps displayed predictable monotonic variation. By stabilizing previously unobserved compositions and phases of GaSe1-xTe x at nanoscales on GaAs(111), we demonstrate abnormal band bowing effects and phase instability region when components crystallize in different phases. Advanced microscopy and spectroscopy measurements show as tellurium is alloyed into GaSe, nanostructures undergo hexagonal to monoclinic and isotropic to anisotropic transition. There exists an instability region (0.56 < x < 0.67) where both phases compete and coexist, and two different bandgap values can be found at the same composition leading to anomalous band bowing effects. Results highlight unique alloying effects, not existing in single-phase alloys, and phase engineering routes for potential applications in photonic and electronics.
21 citations
TL;DR: An unusual alloying rejection behavior in TiS3(1-x)Se3x vdW crystals is reported on and potential challenges in achieving stable Ti based TMTCs alloys are highlighted.
Abstract: Alloying in semiconductors has enabled many civilian technologies in electronics, optoelectronics, photonics, and others. While the alloying phenomenon is well established in traditional bulk semiconductors owing to a vast array of available ternary phase diagrams, alloying in 2D materials still remains at its seminal stages. This is especially true for transition metal trichalcogenides (TMTCs) such as TiS3 which has been recently predicted to be a direct gap, high carrier mobility, pseudo-1D semiconductor. In this work, we report on an unusual alloying rejection behavior in TiS3(1-x)Se3x vdW crystals. TEM, SEM, EDS, and angle-resolved Raman measurements show that only a miniscule amount (8%) of selenium can be successfully alloyed into a TiS3 host matrix despite vastly different precursor amounts as well as growth temperatures. This unusual behavior contrasts with other vdW systems such as TiS2(1-x)Se2x, MoS2(1-x)Se2x, Mo1-xWxS2, WS2(1-x)Se2x, where continuous alloying can be attained. Angle-resolved Raman and kelvin probe force microscopy measurements offer insights into how selenium alloying influences in-plane structural anisotropy as well as electron affinity values of exfoliated sheets. Our cluster expansion theory calculations show that only the alloys with a small amount of Se can be attained due to energetic instability above/below a certain selenium concentration threshold in the ternary phase diagrams. The overall findings highlight potential challenges in achieving stable Ti based TMTCs alloys.
8 citations