Computer Solution of Linear Algebraic Systems. By G. Forsythe and C. B. Moler. Pp. xi, 148. 1967. (Prentice-Hall.)

Thank you for downloading some basic problems of the mathematical theory of elasticity. As you may know, people have search hundreds times for their favorite readings like this some basic problems of the mathematical theory of elasticity, but end up in infectious downloads. Rather than reading a good book with a cup of coffee in the afternoon, instead they cope with some infectious bugs inside their computer.

Some Basic Problems Of The Mathematical Theory Of Elasticity

Terraced landscapes: From an old best practice to a potential hazard for soil degradation due to land abandonment

A review on belt and chain continuously variable transmissions (CVT): Dynamics and control

Kinematic structure of mechanisms revisited

Viticulture is widely practiced in dry regions, where the grapevine is greatly exposed to water stress. Optimizing plant water use efficiency (WUE) without affecting crop yield, grape and wine quality is crucial to limiting use of water for irrigation and to significantly improving viticulture sustainability. This study examines the use in vineyards of particle film technology (engineered kaolin) and compares it to a film-forming antitranspirant (pinolene), traditionally used to limit leaf water loss, and to an untreated control. The trial was carried out under field conditions over three growing seasons, during which moderate to very severe plant water stress (down to -1.9 MPa) was measured through stem water potential. Leaf stomatal conductance (gs) and photosynthesis rate (An) were measured during the seasons and used to compute intrinsic WUE (WUEi, defined as An/gs ratio). Leaf temperature was also recorded and compared between treatments. Bunch quantity, bunch and berry weight, sugar accumulation, anthocyanin and flavonoid contents were measured. Finally, microvinifications were performed and resultant wines subjected to sensory evaluation.Results showed that the use of kaolin increased grapevine intrinsic WUE (+18% on average as compared to unsprayed vines) without affecting berry and bunch weight and quantity, or sugar level. Anthocyanin content increased (+35%) in kaolin treatment, and the wine was judged more attractive (p-value <0.05) and slightly more appreciated (p-value < 0.1) than control. Pinolene did not increase WUEi, limiting An more than gs; grapes with this treatment contained lower sugar and anthocyanin content than control, and the obtained wine was the least appreciated. This study demonstrates that particle film technology can improve vine WUEi and wine quality at the same time, while traditional antitranspirants were not as effective for these purposes. This positive effect can be used in interaction with other already-demonstrated uses of particle film technology, such as pest control and sunburn reduction, in order to achieve more sustainable vineyard management.

/pdf/comparing-kaolin-and-pinolene-to-improve-sustainable-4cp19kk0nm.pdf

Comparing Kaolin and Pinolene to Improve Sustainable Grapevine Production during Drought

Analysis of driving seat vibrations in high forward speed tractors

A Comprehensive Survey on Microgrippers Design: Mechanical Structure

A Comprehensive Survey on Microgrippers Design: Operational Strategy

Although tissue and cell manipulation nowadays is a common task in biomedical analysis, there are still many different ways to accomplish it, most of which are still not sufficiently general, inexpensive, accurate, efficient or effective. Several problems arise both for in vivo or in vitro analysis, such as the maximum overall size of the device and the gripper jaws (like in minimally-invasive open biopsy) or very limited manipulating capability, degrees of freedom or dexterity (like in tissues or cell-handling operations). This paper presents a new approach to tissue and cell manipulation, which employs a conceptually new conjugate surfaces flexure hinge (CSFH) silicon MEMS-based technology micro-gripper that solves most of the above-mentioned problems. The article describes all of the phases of the development, including topology conception, structural design, simulation, construction, actuation testing and in vitro observation. The latter phase deals with the assessment of the function capability, which consists of taking a series of in vitro images by optical microscopy. They offer a direct morphological comparison between the gripper and a variety of tissues.

Nicola Pio Belfiore

Papers

Comparing Kaolin and Pinolene to Improve Sustainable Grapevine Production during Drought

Analysis of driving seat vibrations in high forward speed tractors

A Comprehensive Survey on Microgrippers Design: Mechanical Structure

A Comprehensive Survey on Microgrippers Design: Operational Strategy

Development of Micro-Grippers for Tissue and Cell Manipulation with Direct Morphological Comparison