Cavity Ringdown Laser Absorption Spectroscopy: History, Development, and Application to Pulsed Molecular Beams.

TLDR: This review describes a relatively new direct absorption technique that is developed for measuring the electronic spectra of jet-cooled molecules and clusters with both high sensitivity and high spectral resolution.

Abstract: The measurement of electronic spectra of supersonically cooled molecules and clusters is a widely used approach for addressing many problems in chemistry. The most established techniques for making such measurements are laser-induced fluorescence (LIF) and resonance-enhanced multiphoton ionization (REMPI), and both have been employed very successfully in a large number of studies. However, both methods often fail for systems containing more than a few atoms, due to rapid internal conversion, predissociation, or other dynamical processes. Even for small systems, the vibronic band intensities are often contaminated by intramolecular relaxation dynamics; in such cases, these techniques cannot be used for reliable intensity measurements. For clusters that exhibit rapid photofragmentation, depletion spectroscopy can be employed quite effectively to measure their vibronic structure, but again, dynamic effects complicate the interpretation of spectra. The same considerations apply to other types of “action” spectroscopy. It would often be preferable to measure the electronic spectra of molecules and clusters in direct absorption, as this approach is the most straightforward and accurate means of determining absolute vibronic band intensities and for accessing states that are invisible to LIF or REMPI. The problem, of course, is that direct absorption methods are generally orders of magnitude less sensitive than the “action” techniques and are, therefore, difficult to apply to transient species, such as clusters or radicals. In this review, we describe a relatively new direct absorption technique that we have developed for measuring the electronic spectra of jet-cooled molecules and clusters with both high sensitivity and high spectral resolution. The method is based on measurement of the time rate of decay of a pulse of light trapped in a high reflectance optical cavity; we call it cavity ringdown laser absorption spectroscopy (CRLAS). In practice, pulsed laser light is injected into an optical cavity that is formed by a pair of highly reflective (R > 99.9%) mirrors. The small amount of light that is now trapped inside the cavity reflects back and forth between the two mirrors, with a small fraction (∼1 R) transmitting through each mirror with each pass. The resultant transmission of the circulating light is monitored at the output mirror as a function of time and allows the decay time of the cavity to be determined. A simple picture of the cavity decay event for the case where the laser pulse is temporally shorter than the cavity round trip transit time is presented in Figure 1. In this case, the intensity envelope of these discrete transmitted pulses exhibits a simple exponential decay. The time required for the cavity to decay to 1/e of the initial output pulse is called the “cavity ringdown” time. Determination of the ringdown time allows the absolute single pass transmission coefficient of the cavity to be determined with high accuracy, given the mirror spacing. The apparatus is converted to a sensitive absorption spectrometer simply by placing an absorbing medium between the two mirrors and recording the frequency dependent ringdown time of the cavity. Ideally, the ringdown time is a function of only the mirror reflectivities, cavity dimensions, and sample absorption. Absolute absorption intensities are obtained by subtracting the base-line transmission of the cavity, which is determined when the laser wavelength is off-resonance with all molecular transitions. † IBM Predoctoral Fellow. Current address: Sandia National Laboratories, M/S 9055, Livermore, CA 94551-0969. ‡ Los Gatos Research. 25 Chem. Rev. 1997, 97, 25−51