Mechanical properties of single-brin silkworm silk

TLDR: In this article, the elastic modulus (E), yield strength, tensile breaking strength, and shear modulus were derived from diameter measurements performed by scanning electron microscopy.

Abstract: Mechanical tests were performed on single brins of Bombyx mori silkworm silk, to obtain values of elastic modulus (E), yield strength, tensile breaking strength, and shear modulus (G). Specimen cross-sectional areas, needed to convert tensile loads into stresses, were derived from diameter measurements performed by scanning electron microscopy. Results are compared with existing literature values for partially degummed silkworm baves. The tensile modulus (16 ± 1 GPa) and yield strength (230 ± 10 MPa) of B. mori brin are significantly higher than the literature values reported for bave. The difference is attributed principally to the presence of sericin in bave, contributing to sample cross-section but adding little to the fiber's ability to resist tensile deformation. The two brins in bave are found to contribute equally and independently to the tensile load-bearing ability of the material. Measurements performed with a torsional pendulum can be combined with tensile load-extension data to obtain a value of E/ that is not sensitive to sample cross-sectional dimensions or, therefore, to the presence of sericin. The value of E measured for brin can be used together with this result to obtain G = 3.0 ± 0.8 GPa and E/G = 5.3 ± 0.3 for brin. The latter value indicates a mechanical, and therefore microstructural, anisotropy comparable to that of nylon. © 2000 John Wiley & Sons, Inc. J Appl Polym Sci 75: 1270–1277, 2000