Open Access
Microwave circuit design using linear and nonlinear techniques
Reads0
Chats0
TLDR
In this article, Leeson presented a model of Gummel-Poon Bipolar Transistor Model for MMIC requirements and proposed a two-port network with linear two-ports.Abstract:
Foreword by David Leeson. Preface. 1. RF/Microwave Systems. 2. Lumped and Distributed Elements. 3. Active Devices. 4. Two-Port Networks. 5. Impedance Matching. 6. Microwave Filters. 7. Noise in Linear Two-Ports. 8. Small- and Large-Signal Amplifier Design. 9. Power Amplifier Design. 10. Oscillator Design. 11. Microwave Mixer Design. 12. RF Switches and Attenuators. 13. Microwave Computer-Aided Workstations foor MMIC Requirements. Appendix A: BIP: Gummel-Poon Bipolar Transistor Model. Appendix B: Level 3 MOSFET. Appendix C: Noise Parameters of GaAs MESFETs. Appendix D: Derivations for Unilateral Gain Section. Appendix E: Vector Representation of Two-Tone Intermodulation Products. Appendix F: Passive Microwave Elements. Index.read more
Citations
More filters
Journal ArticleDOI
A Review of GaN on SiC High Electron-Mobility Power Transistors and MMICs
TL;DR: Examples of broadband amplifiers, as well as several of the main areas of high-efficiency amplifier design-notably Class-D, Class-E, class-F, and Class-J approaches, Doherty PAs, envelope-tracking techniques, and Chireix outphasing are described.
Journal ArticleDOI
Range correlation and I/Q performance benefits in single-chip silicon Doppler radars for noncontact cardiopulmonary monitoring
TL;DR: In this paper, the phase relationship between the received signal and the local oscillator has a significant effect on the demodulation sensitivity, and the null points can be avoided with a quadrature (I/Q) receiver.
Journal ArticleDOI
Conversions between S, Z, Y, H, ABCD, and T parameters which are valid for complex source and load impedances
TL;DR: In this article, the authors provide tables which contain the conversion between the various common two-port parameters, Z, Y, H, ABCD, S, and T. The conversions are valid for complex normalizing impedances.
Journal ArticleDOI
A single-chip 900-MHz spread-spectrum wireless transceiver in 1-/spl mu/m CMOS. I. Architecture and transmitter design
Ahmadreza Rofougaran,G. Chang,Jacob Rael,J.Y.-C. Chang,M. Rofougaran,P.J. Chang,M. Djafari,M.-K. Ku,E.W. Roth,Asad A. Abidi,Henry Samueli +10 more
TL;DR: A single-chip transceiver for frequency-hopped code division multiple access (CDMA) in the 900 MHz industrial, scientific and medical (ISM) band is implemented in 1-/spl mu/m CMOS.
Journal ArticleDOI
Introduction to RF simulation and its application
TL;DR: This paper is an introduction to RF simulation methods and how they are applied to make common RF measurements.