The semiconductor ZnO has gained substantial interest in the research community in part because of its large exciton binding energy (60meV) which could lead to lasing action based on exciton recombination even above room temperature. Even though research focusing on ZnO goes back many decades, the renewed interest is fueled by availability of high-quality substrates and reports of p-type conduction and ferromagnetic behavior when doped with transitions metals, both of which remain controversial. It is this renewed interest in ZnO which forms the basis of this review. As mentioned already, ZnO is not new to the semiconductor field, with studies of its lattice parameter dating back to 1935 by Bunn [Proc. Phys. Soc. London 47, 836 (1935)], studies of its vibrational properties with Raman scattering in 1966 by Damen et al. [Phys. Rev. 142, 570 (1966)], detailed optical studies in 1954 by Mollwo [Z. Angew. Phys. 6, 257 (1954)], and its growth by chemical-vapor transport in 1970 by Galli and Coker [Appl. Phys. ...

/pdf/a-comprehensive-review-of-zno-materials-and-devices-21a3zjadem.pdf

A comprehensive review of zno materials and devices

In the past ten years we have witnessed a revival of, and subsequent rapid expansion in, the research on zinc oxide (ZnO) as a semiconductor. Being initially considered as a substrate for GaN and related alloys, the availability of high-quality large bulk single crystals, the strong luminescence demonstrated in optically pumped lasers and the prospects of gaining control over its electrical conductivity have led a large number of groups to turn their research for electronic and photonic devices to ZnO in its own right. The high electron mobility, high thermal conductivity, wide and direct band gap and large exciton binding energy make ZnO suitable for a wide range of devices, including transparent thin-film transistors, photodetectors, light-emitting diodes and laser diodes that operate in the blue and ultraviolet region of the spectrum. In spite of the recent rapid developments, controlling the electrical conductivity of ZnO has remained a major challenge. While a number of research groups have reported achieving p-type ZnO, there are still problems concerning the reproducibility of the results and the stability of the p-type conductivity. Even the cause of the commonly observed unintentional n-type conductivity in as-grown ZnO is still under debate. One approach to address these issues consists of growing high-quality single crystalline bulk and thin films in which the concentrations of impurities and intrinsic defects are controlled. In this review we discuss the status of ZnO as a semiconductor. We first discuss the growth of bulk and epitaxial films, growth conditions and their influence on the incorporation of native defects and impurities. We then present the theory of doping and native defects in ZnO based on density-functional calculations, discussing the stability and electronic structure of native point defects and impurities and their influence on the electrical conductivity and optical properties of ZnO. We pay special attention to the possible causes of the unintentional n-type conductivity, emphasize the role of impurities, critically review the current status of p-type doping and address possible routes to controlling the electrical conductivity in ZnO. Finally, we discuss band-gap engineering using MgZnO and CdZnO alloys.

/pdf/fundamentals-of-zinc-oxide-as-a-semiconductor-1s4l8bh009.pdf

Fundamentals of zinc oxide as a semiconductor

https://chemistry.beloit.edu/classes/nanotech/ZnO/mattoday10_05_40.pdf

ZnO - nanostructures, defects, and devices

Organic photovoltaics (OPVs) evolve in an exponential manner in the two key areas of efficiency and stability. The power conversion efficiency (PCE) has in the last decade been increased by almost a factor of ten approaching 10%. A main concern has been the stability that was previously measured in minutes, but can now, in favorable circumstances, exceed many thousands of hours. This astonishing achievement is the subject of this article, which reviews the developments in stability/degradation of OPVs in the last five years. This progress has been gained by several developments, such as inverted device structures of the bulk heterojunction geometry device, which allows for more stable metal electrodes, the choice of more photostable active materials, the introduction of interfacial layers, and roll-to-roll fabrication, which promises fast and cheap production methods while creating its own challenges in terms of stability.

Stability of polymer solar cells.

One-dimensional (1D) ZnO nanostructures have been studied intensively and extensively over the last decade not only for their remarkable chemical and physical properties, but also for their current and future diverse technological applications. This article gives a comprehensive overview of the progress that has been made within the context of 1D ZnO nanostructures synthesized via wet chemical methods. We will cover the synthetic methodologies and corresponding growth mechanisms, different structures, doping and alloying, position-controlled growth on substrates, and finally, their functional properties as catalysts, hydrophobic surfaces, sensors, and in nanoelectronic, optical, optoelectronic, and energy harvesting devices.

/pdf/one-dimensional-zno-nanostructures-solution-growth-and-30xs4d6be7.pdf

One-dimensional ZnO nanostructures: Solution growth and functional properties

Recent progress in processing and properties of ZnO

A review is given of recent results in developing improved fabrication processes for ZnO devices with the possible application to UV light emitters, spin functional devices, gas sensors, transparent electronics, and surface acoustic wave devices. There is also interest in integrating ZnO with other wide band-gap semiconductors, such as the AlInGaN system. In this article, we summarize recent progress in controlling n- and p-type doping, materials processing methods, such as ion implantation for doping or isolation, Ohmic and Schottky contact formation, plasma etching, the role of hydrogen in the background n-type conductivity of many ZnO films, and finally, the recent achievement of room-temperature ferromagnetism in transition-metal (Mn or Co)-doped ZnO. This may lead to another class of spintronic devices, in which the spin of the carriers is exploited rather than the charge as in more conventional structures.

Recent advances in processing of ZnO

ZnO: growth, doping & processing

A review of recent results on transition metal doping of electronic oxides such as ZnO, TiO2, SnO2, BaTiO3, Cu2O, SrTiO3 and KTaO3 is presented. There is interest in achieving ferromagnetism with Curie temperatures above room temperature in such materials for applications in the field of spintronic devices, in which the spin of the carriers is exploited. The incorporation of several atomic per cent of the transition metals without creation of second phases appears possible under optimized synthesis conditions, leading to ferromagnetism. Pulsed laser deposition, reactive sputtering, molecular beam epitaxy and ion implantation have all been used to produce the oxide-based dilute magnetic materials. The mechanism is still under debate, with carrier-induced, double-exchange and bound magnetic polaron formation all potentially playing a role depending on the conductivity type and level in the material.

T. Steiner

Papers

Recent progress in processing and properties of ZnO

Recent advances in processing of ZnO

Recent progress in processing and properties of ZnO

ZnO: growth, doping & processing

Dilute magnetic semiconducting oxides