Open AccessBook
Manufacturing Processes for Engineering Materials
Reads0
Chats0
TLDR
In this paper, the authors present the fundamental properties of materials and their properties, including surfaces, tribology, dimensional characteristics, inspection, and product quality assurance, and manufacturing properties of metals.Abstract:
1 Introduction 2 Fundamentals of the mechanical behavior of materials 3 Structure and manufacturing properties of metals 4 Surfaces, tribology, dimensional characteristics, inspection, and product Quality assurance 5 Metal-casting processes and equipment heat treatment 6 Bulk deformation processes 7 Sheet-metal forming processes 8 Material-removal pocesses: cutting 9 Material-removal processes: abrasive, chemical, electrical, and high-energy beams 10 Properties and processing of polymers and reinforced plastics rapid prototyping and rapid tooling 11 Properties and processing of metal powders, ceramics, glasses, composites, and superconductors 12 Joining and fastening processes 13 Fabrication of microelectronic, micromechanical, and microelectromechanical devices nanomanufacturing 14 Automation of manufacturing processes and operations 15 Computer-integrated manufacturing systems 16 Product design and manufacturing in a global competitive environmentread more
Citations
More filters
Patent
Method of polishing using a polishing pad
TL;DR: A polishing pad for polishing hard surfaces such as glass and silicon wafers and a method of polishing using such a polishingpad are described in this article. But they do not specify a method for applying polishing to the hard surfaces.
Journal ArticleDOI
Creep Behavior of Al-Si Die-Cast Alloys
T. Jaglinski,Roderic S. Lakes +1 more
TL;DR: In this paper, the authors conducted load creep tests on aluminum die-casting alloys: B-390, eutectic Al-Si and a 17% Si-Al alloys.
Journal ArticleDOI
Wear maps for some uncoated cutting tools
TL;DR: In this article, wear maps obtained earlier for uncoated high-speed steel (HSS) cutting tools are presented together with maps for un-coated carbide cutting tools.
Journal ArticleDOI
CaCO3 scaling in AISI 316 stainless steel tubes – effect of thermal and hydraulic parameters on the induction time and growth rate
TL;DR: In this article, an experimental study was carried out to determine the effect of tube surface temperature, Reynolds number, tube diameter and salt concentration on the induction time of CaCO3 scaling.
Journal ArticleDOI
Quenching microstructure and properties of 300M ultra-high strength steel electron beam welded joints
TL;DR: In this article, the microstructure and fracture morphology were analyzed using scanning electron microscopy (SEM) and optical microscope, and X-ray energy spectrum analysis was used to determine chemical composition of phases formed at the joint.