scispace - formally typeset
Journal ArticleDOI

Solution‐Processed Metallic Conducting Polymer Films as Transparent Electrode of Optoelectronic Devices

Yijie Xia, +2 more
- 08 May 2012 - 
- Vol. 24, Iss: 18, pp 2436-2440
Reads0
Chats0
TLDR
These PEDOT:PSS films with conductivity and transparency comparable to ITO can replace ITO as the transparent electrode of optoelectronic devices.
Abstract
The conductivity of PEDOT:PSS films was significantly enhanced from 0.3 S cm(-1) to 3065 S cm(-1) through a treatment with dilute sulfuric acids. PEDOT:PSS films with a sheet resistance of 39 Ω sq(-1) and transparency of around 80% at 550 nm are obtained. These PEDOT:PSS films with conductivity and transparency comparable to ITO can replace ITO as the transparent electrode of optoelectronic devices.

read more

Citations
More filters
Journal ArticleDOI

A review on the dominating factor for the conductivity enhancement of PEDOTs: The affinity of polyanion shell toward post-processing reagents?

TL;DR: In this paper , the influence of the polyanion-rich part (the shell of poly(3,4-ethylenedioxythiophene) (PEDOT) conducting polymers (CPs) on the penetration kenetics of post-processing was investigated.
Journal ArticleDOI

Versatile fabrication of a passivation material, solute PEDOT:PSS, for a c-Si substrate using alcoholic solvents

TL;DR: In this article, the carrier lifetimes of passivated c-Si are recorded to be more than 1 millisecond under an injection level of 1 × 1014 cm−3.
Journal ArticleDOI

Functionalization of Graphene Derivatives with Conducting Polymers and Their Applications in Uric Acid Detection

TL;DR: In this article , the authors review recent progress concerning the development of sensorial platforms based on graphene derivatives and conducting polymers (CPs), alternatively deposited or co-deposited on the working electrode (usually a glassy carbon electrode; GCE) using a simple potentiostatic method (often cyclic voltammetry; CV), possibly followed by the deposition of metallic nanoparticles (NPs) on the electrode surface (ES).
Journal ArticleDOI

Confinement highlights the different electrical transport mechanisms prevailing in conducting polymers

TL;DR: In this article , the differences in electrical charge transport dynamics of the conductivity enhancement of poly(3,4-ethylenedioxythiophene) derivatives under geometrical confinement were studied.
References
More filters
Journal ArticleDOI

Large-scale pattern growth of graphene films for stretchable transparent electrodes

TL;DR: The direct synthesis of large-scale graphene films using chemical vapour deposition on thin nickel layers is reported, and two different methods of patterning the films and transferring them to arbitrary substrates are presented, implying that the quality of graphene grown by chemical vapours is as high as mechanically cleaved graphene.
Journal ArticleDOI

Poly(3,4‐ethylenedioxythiophene) and Its Derivatives: Past, Present, and Future

TL;DR: An overview of 3,4-ethylenedioxythiophene (PEDT) and its derivatives can be found in this article, along with a description of the broad array of properties accessible and a set of the more prominent applications in which they can be utilized.
Journal ArticleDOI

Evaluation of Solution-Processed Reduced Graphene Oxide Films as Transparent Conductors

TL;DR: These experiments demonstrate solution-processed GO films have potential as transparent electrodes and sheet resistance and optical transparency using different reduction treatments.
Journal ArticleDOI

Transparent, Conductive Carbon Nanotube Films

TL;DR: Characteristics of the fabrication of ultrathin, transparent, optically homogeneous, electrically conducting films of pure single-walled carbon nanotubes indicate broad applicability of the films for electrical coupling in photonic devices.
Journal ArticleDOI

Solution-processed metal nanowire mesh transparent electrodes.

TL;DR: In this article, the authors demonstrate solution-processed transparent electrodes consisting of random meshes of metal nanowires that exhibit an optical transparency equivalent to or better than that of metal-oxide thin films for the same sheet resistance.
Related Papers (5)