scispace - formally typeset
Book ChapterDOI

Thermal protection coatings of metal oxide powders

K.V. Madhuri
- pp 209-231
Reads0
Chats0
TLDR
The necessity of thermal protection coating and the development of coatings on various metal oxide powders by various physical and chemical deposition techniques are discussed in this paper, where the authors also discuss the need for continuous development in finding out newer materials and composites.
Abstract
Metal oxide powders and thick and thin films of metal oxides are drawing the attention of researchers owing to their use in industry and societal applications. To improve the efficiency, lifetime and also to arrest the degradation of the composition, protection coatings are very much important. Continuous development in finding out newer materials and composites is essential to meet the challenges posed by the demands. In this chapter the necessity of thermal protection coating and the development of coatings on various metal oxide powders by various physical and chemical deposition techniques are discussed.

read more

Citations
More filters
Journal ArticleDOI

State-of-the-art review of fabrication, application, and mechanical properties of functionally graded porous nanocomposite materials

TL;DR: In this paper , the impact of nano-reinforcing agents on the elastic properties of functionally graded porous (FGP) nanocomposites was analyzed and classified for different engineering analysis types including buckling, thermal, vibrational, thermoelasticity, static, and dynamic bending.
Journal ArticleDOI

P-Type Metal Oxide Semiconductor Thin Films: Synthesis and Chemical Sensor Applications

TL;DR: In this paper , the synthesis of p-type metal-oxide (p-type MOX) semiconductor thin films, such as CuO, NiO, Co3O4, and Cr2O3, is discussed.
Journal ArticleDOI

Agricultural and industrial waste-derived mesoporous silica nanoparticles: A review on chemical synthesis route

TL;DR: In this paper , the mesoporous silica nanoparticles (MSNs) were synthesized from waste using a chemical synthesis route, which offers the possibility to control silica structure, phase, morphology, and sizes by fine tuning the reaction parameters/conditions.
Journal ArticleDOI

Review of Surface Modification in Pool Boiling Application: Coating Manufacturing Process and Heat Transfer Enhancement Mechanism

TL;DR: In this article , the surface modification methods of coatings commonly used in pool boiling are summarized and evaluated, and the influence mechanisms under different heat fluxes are reviewed, including strengthening and weakening.
Journal ArticleDOI

Recent Progress on Bimetallic-Based Spinels as Electrocatalysts for the Oxygen Evolution Reaction.

Joshua Oluwole Olowoyo, +1 more
- 22 Aug 2022 - 
TL;DR: In this paper , a review of the recent progress on the application of bimetallic-based spinels (AFe2 O4 , ACo2 O 4 , and AMn2O4 ) as electrocatalysts for the oxygen evolution reaction (OER) is presented.
References
More filters
Journal ArticleDOI

Ceramic materials for thermal barrier coatings

TL;DR: In this article, the basic properties of ceramic materials for thermal barrier coatings are summarized, showing that they are more resistant to oxidation, corrosion and wear, as well as being better thermal insulators.
Journal ArticleDOI

Thermal barrier coating materials

TL;DR: In this paper, an integrated strategy of experiment, intuitive arguments based on crystallography, and simulation may lead most rapidly to the development of new thermal barrier coatings (TBCs) materials.
Journal ArticleDOI

Sol–gel coatings for corrosion protection of metals

TL;DR: In this article, the incorporation of nanoparticles in the hybrid sol-gel systems increases the corrosion protection properties due to lower porosity and lower cracking potential along with enhancement of the mechanical properties.
Journal ArticleDOI

Active protection coatings with layered double hydroxide nanocontainers of corrosion inhibitor

TL;DR: In this paper, a novel LDH-based nanocontainers of corrosion inhibitor are developed, which are composed by nanostructured layered double hydroxides with divanadate anions located in the interlayer regions.
Journal ArticleDOI

Inorganic–organic sol gel hybrid coatings for corrosion protection of metals

TL;DR: In this paper, an ideal multiple model of hybrid coatings for superior anti-corrosion of metals proposed is a combination of super-hydrophobic hybrid coating and underlying hybrid coating doped with sustained release of corrosion inhibitors on metal substrates.
Related Papers (5)