The semiconductor ZnO has gained substantial interest in the research community in part because of its large exciton binding energy (60meV) which could lead to lasing action based on exciton recombination even above room temperature. Even though research focusing on ZnO goes back many decades, the renewed interest is fueled by availability of high-quality substrates and reports of p-type conduction and ferromagnetic behavior when doped with transitions metals, both of which remain controversial. It is this renewed interest in ZnO which forms the basis of this review. As mentioned already, ZnO is not new to the semiconductor field, with studies of its lattice parameter dating back to 1935 by Bunn [Proc. Phys. Soc. London 47, 836 (1935)], studies of its vibrational properties with Raman scattering in 1966 by Damen et al. [Phys. Rev. 142, 570 (1966)], detailed optical studies in 1954 by Mollwo [Z. Angew. Phys. 6, 257 (1954)], and its growth by chemical-vapor transport in 1970 by Galli and Coker [Appl. Phys. ...

/pdf/a-comprehensive-review-of-zno-materials-and-devices-21a3zjadem.pdf

A comprehensive review of zno materials and devices

In the past ten years we have witnessed a revival of, and subsequent rapid expansion in, the research on zinc oxide (ZnO) as a semiconductor. Being initially considered as a substrate for GaN and related alloys, the availability of high-quality large bulk single crystals, the strong luminescence demonstrated in optically pumped lasers and the prospects of gaining control over its electrical conductivity have led a large number of groups to turn their research for electronic and photonic devices to ZnO in its own right. The high electron mobility, high thermal conductivity, wide and direct band gap and large exciton binding energy make ZnO suitable for a wide range of devices, including transparent thin-film transistors, photodetectors, light-emitting diodes and laser diodes that operate in the blue and ultraviolet region of the spectrum. In spite of the recent rapid developments, controlling the electrical conductivity of ZnO has remained a major challenge. While a number of research groups have reported achieving p-type ZnO, there are still problems concerning the reproducibility of the results and the stability of the p-type conductivity. Even the cause of the commonly observed unintentional n-type conductivity in as-grown ZnO is still under debate. One approach to address these issues consists of growing high-quality single crystalline bulk and thin films in which the concentrations of impurities and intrinsic defects are controlled. In this review we discuss the status of ZnO as a semiconductor. We first discuss the growth of bulk and epitaxial films, growth conditions and their influence on the incorporation of native defects and impurities. We then present the theory of doping and native defects in ZnO based on density-functional calculations, discussing the stability and electronic structure of native point defects and impurities and their influence on the electrical conductivity and optical properties of ZnO. We pay special attention to the possible causes of the unintentional n-type conductivity, emphasize the role of impurities, critically review the current status of p-type doping and address possible routes to controlling the electrical conductivity in ZnO. Finally, we discuss band-gap engineering using MgZnO and CdZnO alloys.

/pdf/fundamentals-of-zinc-oxide-as-a-semiconductor-1s4l8bh009.pdf

Fundamentals of zinc oxide as a semiconductor

Dimensionality plays a critical role in determining the properties of materials due to, for example, the different ways that electrons interact in three-dimensional, twodimensional (2D), and one-dimensional (1D) structures.1-5 The study of dimensionality has a long history in chemistry and physics, although this has been primarily with the prefix “quasi” added to the description of materials; that is, quasi-1D solids, including square-planar platinum chain and metal trichalcogenide compounds,2,6 and quasi2D layered solids, such as metal dichalcogenides and copper oxide superconductors.3-5,7,8 The anisotropy inherent in quasi-1D and -2D systems is central to the unique properties and phases that these materials exhibit, although the small but finite interactions between 1D chains or 2D layers in bulk materials have made it difficult to address the interesting properties expected for the pure low-dimensional systems. Are pure low-dimensional systems interesting and worth pursuing? We believe that the answer to this question is an unqualified yes from the standpoints of both fundamental science and technology. One needs to look no further than past studies of the 2D electron gas in semiconductor heterostructures, which have produced remarkably rich and often unexpected results,9,10 and electron tunneling through 0D quantum dots, which have led to the concepts of the artificial atom and the creation of single electron transistors.11-15 In these cases, lowdimensional systems were realized by creating discrete 2D and 0D nanostructures. 1D nanostructures, such as nanowires and nanotubes, are expected to be at least as interesting and important as 2D and 0D systems.16,17 1D systems are the smallest dimension structures that can be used for efficient transport of electrons and optical excitations, and are thus expected to be critical to the function and integration of nanoscale devices. However, little is known about the nature of, for example, localization that could preclude transport through 1D systems. In addition, 1D systems should exhibit density of states singularities, can have energetically discrete molecularlike states extending over large linear distances, and may show more exotic phenomena, such as the spin-charge separation predicted for a Luttinger liquid.1,2 There are also many applications where 1D nanostructures could be exploited, including nanoelectronics, superstrong and tough composites, functional nanostructured materials, and novel probe microscopy tips.16-29 To address these fascinating fundamental scientific issues and potential applications requires answers to two questions at the heart of condensed matter chemistry and physics research: (1) How can atoms or other building blocks be rationally assembled into structures with nanometer-sized diameters but much longer lengths? (2) What are the intrinsic properties of these quantum wires and how do these properties depend, for example, on diameter and structure? Below we describe investigations from our laboratory directed toward these two general questions. The organization of this Account is as follows. In section II, we discuss the development of a general approach to the rational synthesis of crystalline nanowires of arbitrary composition. In section III, we outline key challenges to probing the intrinsic properties of 1D systems and illustrate solutions to these challenges with measurements of the atomic structure and electronic properties of carbon nanotubes. Last, we discuss future directions and challenges in section IV.

http://cmliris.harvard.edu/assets/AccChemRes_32_435.pdf

Chemistry and Physics in One Dimension: Synthesis and Properties of Nanowires and Nanotubes

Since the successful demonstration of a blue light-emitting diode (LED)1, potential materials for making short-wavelength LEDs and diode lasers have been attracting increasing interest as the demands for display, illumination and information storage grow2,3,4. Zinc oxide has substantial advantages including large exciton binding energy, as demonstrated by efficient excitonic lasing on optical excitation5,6. Several groups have postulated the use of p-type ZnO doped with nitrogen, arsenic or phosphorus7,8,9,10, and even p–n junctions11,12,13. However, the choice of dopant and growth technique remains controversial and the reliability of p-type ZnO is still under debate14. If ZnO is ever to produce long-lasting and robust devices, the quality of epitaxial layers has to be improved as has been the protocol in other compound semiconductors15. Here we report high-quality undoped films with electron mobility exceeding that in the bulk. We have used a new technique to fabricate p-type ZnO reproducibly. Violet electroluminescence from homostructural p–i–n junctions is demonstrated at room-temperature.

Repeated temperature modulation epitaxy for p-type doping and light-emitting diode based on ZnO

We present a review of current research on the optical properties of ZnO nanostructures. We provide a brief introduction to different fabrication methods for various ZnO nanostructures and some general guidelines on how fabrication parameters (temperature, vapor-phase versus solution-phase deposition, etc.) affect their properties. A detailed discussion of photoluminescence, both in the UV region and in the visible spectral range, is provided. In addition, different gain (excitonic versus electron hole plasma) and feedback (random lasing versus individual nanostructures functioning as Fabry-Perot resonators) mechanisms for achieving stimulated emission are described. The factors affecting the achievement of stimulated emission are discussed, and the results of time-resolved studies of stimulated emission are summarized. Then, results of nonlinear optical studies, such as second-harmonic generation, are presented. Optical properties of doped ZnO nanostructures are also discussed, along with a concluding outlook for research into the optical properties of ZnO.

Optical properties of ZnO nanostructures.

We describe the structural and optical properties of II–VI oxide alloys, MgxZn1−xO and CdyZn1−yO, grown by pulsed-laser deposition. Single-phase alloyed films of (Mg,Zn)O and (Cd,Zn)O with c-axis orientations were epitaxially grown on sapphire (0001) substrates. The maximum magnesium and cadmium concentrations (x=0.33 and y=0.07, respectively) were significantly larger than the thermodynamic solubility limits. The band gap energies systematically changed from 3.0 (y=0.07) to 4.0 eV (x=0.33) at room temperature. The photoluminescence peak energy deduced at 4.2 K could be tuned from 3.19 to 3.87 eV by using Cd0.07Zn0.93O and Mg0.33Zn0.67O at both ends, respectively. The lattice constants of the a axis were monotonically increasing functions of the concentrations of both alloys. The exciton–phonon coupling strength was determined in Cd0.01Zn0.99O grown on a lattice-matched ScAlMgO4 substrate.

/pdf/band-gap-engineering-based-on-mgxzn1-xo-and-cdyzn1-yo-yhpj3xhius.pdf

Band gap engineering based on MgxZn1−xO and CdyZn1−yO ternary alloy films

Lattice-matched (Δa/a=0.09%) ScAlMgO4(0001) substrates were employed to grow single crystalline quality ZnO films by laser molecular-beam epitaxy. Extremely smooth surface represented by atomically flat terraces and half unit cell (0.26 nm) high steps and extremely small orientation fluctuations both in-plane (<0.02°) and out-of-plane (<0.01°) are achieved. The films have high mobility (∼100 cm2/V s) together with low residual carrier concentration (∼1015 cm−3). Excellent optical properties, including a clear doublet of A and B exciton peaks in absorption spectra, were also observed. These features could not be simultaneously achieved for ZnO films grown on sapphire(0001) having a large lattice mismatch (Δa/a=18%).

/pdf/single-crystalline-zno-films-grown-on-lattice-matched-1t8sdwgtj5.pdf

Single crystalline ZnO films grown on lattice-matched ScAlMgO4(0001) substrates

Using electron paramagnetic resonance (EPR), energy levels of the carbon vacancy (V(C)) in 4H-SiC and its negative-U properties have been determined. Combining EPR and deep-level transient spectroscopy we show that the two most common defects in as-grown 4H-SiC--the Z(1/2) lifetime-limiting defect and the EH(7) deep defect--are related to the double acceptor (2-|0) and single donor (0|+) levels of V(C), respectively.

/pdf/negative-u-system-of-carbon-vacancy-in-4h-sic-3bksqib23c.pdf

Negative-U System of Carbon Vacancy in 4H-SiC

We investigated the optical properties of epitaxial n-type ZnO films grown on lattice-matched ScAlMgO4 substrates. As the Ga doping concentration increased up to 6×1020cm−3, the absorption edge showed a systematic blueshift, consistent with the Burstein–Moss effect. A bright near-band-edge photoluminescence (PL) could be observed even at room temperature, the intensity of which increased monotonically as the doping concentration was increased except for the highest doping level. It indicates that nonradiative transitions dominate at a low doping density. Both a Stokes shift and broadening in the PL band are monotonically increasing functions of donor concentration, which was explained in terms of potential fluctuations caused by the random distribution of donor impurities.

/pdf/gallium-concentration-dependence-of-room-temperature-near-1sj34wfkye.pdf

Takahiro Makino

Papers

Band gap engineering based on MgxZn1−xO and CdyZn1−yO ternary alloy films

Single crystalline ZnO films grown on lattice-matched ScAlMgO4(0001) substrates

Negative-U System of Carbon Vacancy in 4H-SiC

Gallium concentration dependence of room-temperature near-band-edge luminescence in n-type ZnO:Ga

Optimization of zinc oxide thin film for surface acoustic wave filters by radio frequency sputtering