scispace - formally typeset
Open Access

Wastewater engineering treatment: disposal and reuse

About
The article was published on 1991-01-01 and is currently open access. It has received 3805 citations till now. The article focuses on the topics: Wastewater engineering & Reuse.

read more

Content maybe subject to copyright    Report

Citations
More filters
Journal ArticleDOI

A Granulometry-Based Selection Methodology for Separation of Traffic-Generated Particles in Urban Highway Snowmelt Runoff

TL;DR: In this article, a granulometry-based analysis of snow melt particles from 10 highway shoulder sites in urban Cincinnati (State of Ohio, U.S.A.) generated from a 46 cm, 48 hr snowfall with a highwayshoulder residence time of 102 hr.
Journal ArticleDOI

Spatial Distribution of Extracellular Polymeric Substances in Biofilms

TL;DR: In this paper, the spatial distribution of biofilm extracellular polymeric substances (EPS) with depth in biofilms was investigated in a rotating drum biofilm reactor fed with synthetic wastewater with a COD of 150 mg/L.
Journal ArticleDOI

COD removal and nitrification of low-strength domestic wastewater in aerobic granular sludge sequencing batch reactors

TL;DR: In this article, Acetate-fed granules were used to start-up reactors for the treatment of low-strength domestic wastewater at 25 °C and 35 °C (R2).
Journal ArticleDOI

Aquaculture wastewater treatment and reuse by wind-driven reverse osmosis membrane technology: a pilot study on Coconut Island, Hawaii

TL;DR: Testing results indicated that the prototype wind-driven RO system can process and recycle freshwater at a flux of 228–366 L/h, depending on wind speed, and the nitrogen removal rate ranges from 90% to 97%, and the recovery rate of the RO membrane is about 40–56%.
Journal ArticleDOI

Evaluation of a respirometric test method to determine the heterotrophic yield coefficient of activated sludge bacteria

TL;DR: It was proved that the heterotrophic yield coefficient of aerobically degrading activated sludge bacteria could reliably be determined and that it was independent of the F M ratio over a wide range.