scispace - formally typeset
Open AccessJournal ArticleDOI

The Diffusion of Solids

John H. Howell
- 01 Mar 1906 - 
- Vol. 73, Iss: 1898, pp 464-464
Reads0
Chats0
TLDR
In view of the interest attaching to the vaporisation and diffusion of solids, the following observations may be worthy of record as discussed by the authors, which may be seen as a good starting point for further research.
Abstract
IN view of the interest attaching to the vaporisation and diffusion of solids, the following observations may be worthy of record.

read more

Citations
More filters

The influence of phosphorus on the solid state reaction between copper and silicon or germanium

TL;DR: A submitted manuscript is the version of the article upon submission and before peer-review as mentioned in this paper, while a published version is the final layout of the paper including the volume, issue and page numbers.
Journal ArticleDOI

Modelling the high temperature oxidation of titanium alloys: review of analytical models and development of a new numerical tool PyTiOx

TL;DR: In this paper, a numerical tool called PyTiOx was developed to predict the oxidation behavior of Ni-based superalloys at high temperatures. But this tool is not suitable for the case of thin components.

Optimization of Electrolyte Properties by Simplex Exemplified for Conductivity of Lithium Battery Electrolytes

TL;DR: The basic simplex method was introduced by G.B. Danzig, according to Weisstein [3], was presented by Spendley et al. as mentioned in this paper, and was modified and extended by several groups.
Journal ArticleDOI

Photonic bandgaps of periodic multilayers with diffuse interfaces

TL;DR: In this paper, the photonic bandgap of periodic multilayers with diffuse interfaces is calculated by considering an empirical model for the interdiffusion profile, based on the error function Erf and a characteristic parameter σ.

Powder Metallurgical Processing of Titanium Alloys and Aluminides

Hung-Wei Liu
TL;DR: In this article, a comparison of liquid phase sintering mechanisms is undertaken, with either persistent or transient liquid formation, for Ti-Ni and Ti-Sn alloys, respectively, with up to 10 wt-% alloying addition, with compacts uniaxially pressed and sintered at 1200 to 1400 °C.
References
More filters
Journal ArticleDOI

A review of conduction phenomena in Li-ion batteries

TL;DR: A comprehensive survey of conduction phenomena in all components of a Li-ion cell incorporating theoretical, experimental, and simulation studies is presented in this paper, where the critical results, issues and challenges with respect to ionic and electronic conduction in the cathode, anode and electrolyte are discussed.
Journal ArticleDOI

Criteria for developing castable, creep-resistant aluminum-based alloys - A review

TL;DR: In this paper, the authors describe four criteria for the selection of alloying elements capable of producing castable, precipitation-strengthened Al alloys with high-temperature stability and strength.
Journal ArticleDOI

Shear localization in dynamic deformation of materials: microstructural evolution and self-organization

TL;DR: In this article, the authors investigated the microstructural evolution inside the shear bands and found that they exhibit a clear self-organization, with a characteristic spacing that is a function of a number of parameters.
Journal ArticleDOI

Bulk tracer diffusion in CoCrFeNi and CoCrFeMnNi high entropy alloys

TL;DR: In this article, the diffusion coefficients of Co, Cr, Fe and Mn tracers were determined in polycrystalline CoCrFeNi and CoCr FeMnNi HEAs using the radiotracer method in the temperature interval of 1073-1373 K.