There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality.

Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

I and i

http://www.eecs.ucf.edu/~dcm/Teaching/COT4810-Spring2011/Literature/SensorNetworksSurvey.pdf

Wireless sensor networks: a survey

We develop and analyze low-complexity cooperative diversity protocols that combat fading induced by multipath propagation in wireless networks. The underlying techniques exploit space diversity available through cooperating terminals' relaying signals for one another. We outline several strategies employed by the cooperating radios, including fixed relaying schemes such as amplify-and-forward and decode-and-forward, selection relaying schemes that adapt based upon channel measurements between the cooperating terminals, and incremental relaying schemes that adapt based upon limited feedback from the destination terminal. We develop performance characterizations in terms of outage events and associated outage probabilities, which measure robustness of the transmissions to fading, focusing on the high signal-to-noise ratio (SNR) regime. Except for fixed decode-and-forward, all of our cooperative diversity protocols are efficient in the sense that they achieve full diversity (i.e., second-order diversity in the case of two terminals), and, moreover, are close to optimum (within 1.5 dB) in certain regimes. Thus, using distributed antennas, we can provide the powerful benefits of space diversity without need for physical arrays, though at a loss of spectral efficiency due to half-duplex operation and possibly at the cost of additional receive hardware. Applicable to any wireless setting, including cellular or ad hoc networks-wherever space constraints preclude the use of physical arrays-the performance characterizations reveal that large power or energy savings result from the use of these protocols.

Cooperative diversity in wireless networks: Efficient protocols and outage behavior

Cognitive radio is viewed as a novel approach for improving the utilization of a precious natural resource: the radio electromagnetic spectrum. The cognitive radio, built on a software-defined radio, is defined as an intelligent wireless communication system that is aware of its environment and uses the methodology of understanding-by-building to learn from the environment and adapt to statistical variations in the input stimuli, with two primary objectives in mind: /spl middot/ highly reliable communication whenever and wherever needed; /spl middot/ efficient utilization of the radio spectrum. Following the discussion of interference temperature as a new metric for the quantification and management of interference, the paper addresses three fundamental cognitive tasks. 1) Radio-scene analysis. 2) Channel-state estimation and predictive modeling. 3) Transmit-power control and dynamic spectrum management. This work also discusses the emergent behavior of cognitive radio.

/pdf/cognitive-radio-brain-empowered-wireless-communications-9m6gu0vz1z.pdf

Cognitive radio: brain-empowered wireless communications

Networking together hundreds or thousands of cheap microsensor nodes allows users to accurately monitor a remote environment by intelligently combining the data from the individual nodes. These networks require robust wireless communication protocols that are energy efficient and provide low latency. We develop and analyze low-energy adaptive clustering hierarchy (LEACH), a protocol architecture for microsensor networks that combines the ideas of energy-efficient cluster-based routing and media access together with application-specific data aggregation to achieve good performance in terms of system lifetime, latency, and application-perceived quality. LEACH includes a new, distributed cluster formation technique that enables self-organization of large numbers of nodes, algorithms for adapting clusters and rotating cluster head positions to evenly distribute the energy load among all the nodes, and techniques to enable distributed signal processing to save communication resources. Our results show that LEACH can improve system lifetime by an order of magnitude compared with general-purpose multihop approaches.

/pdf/an-application-specific-protocol-architecture-for-wireless-1s7y9fiv40.pdf

An application-specific protocol architecture for wireless microsensor networks

Multiple-input multiple-output (MIMO) systems are well suited for millimeter-wave (mmWave) wireless communications where large antenna arrays can be integrated in small form factors due to tiny wavelengths, thereby providing high array gains while supporting spatial multiplexing, beamforming, or antenna diversity. It has been shown that mmWave channels exhibit sparsity due to the limited number of dominant propagation paths, thus compressed sensing techniques can be leveraged to conduct channel estimation at mmWave frequencies. This paper presents a novel approach of constructing beamforming dictionary matrices for sparse channel estimation using the continuous basis pursuit (CBP) concept, and proposes two novel low-complexity algorithms to exploit channel sparsity for adaptively estimating multipath channel parameters in mmWave channels. We verify the performance of the proposed CBP-based beamforming dictionary and the two algorithms using a simulator built upon a three-dimensional mmWave statistical spatial channel model, NYUSIM, that is based on real-world propagation measurements. Simulation results show that the CBP-based dictionary offers substantially higher estimation accuracy and greater spectral efficiency than the grid-based counterpart introduced by previous researchers, and the algorithms proposed here render better performance but require less computational effort compared with existing algorithms.

Millimeter Wave MIMO Channel Estimation Based on Adaptive Compressed Sensing

PROBLEM TO BE SOLVED: To provide site-specific performance prediction modeling for a digital data network depending upon a performance-based real-time wireless network feedback and visual display function. SOLUTION: A method is presented for determining optimal or preferred configuration settings for wireless or wired network equipment in order to obtain a desirable level of network performance. A site-specific network model is used with adaptive processing to perform efficient design and ongoing management of network performance, and the cost is obtained, and further equipment settings, locations and orientations are updated. Display and storage are performed in real time to enable iterative adaptation to any network regarding constantly varying traffic and interference conditions. Alarms provide rapid adaptation of network parameters, and alerts, and preprogrammed network shutdown actions may be taken autonomously. COPYRIGHT: (C)2011,JPO&INPIT

Wireless communication system, and wireless communication method

Wireless information links for the factory of the future

Communication systems of the future will require hundreds of independent spatial channels achieved through dense antenna arrays connected to digital signal processing software defined radios. The cost and complexity of data converters are a significant concern with systems having hundreds of antennas. This paper explores frequency division multiplexing as an approach for augmenting the baseband signals of multiple antenna channels such that a single ADC can sample a multitude of antennas in an array. The approach is equally applicable to both massive MIMO and mm-wave digital wireless arrays. An example design based on Xilinx RF SoC for combining 4 antenna channels at 28 GHz into a single ADC is provided.

Theodore S. Rappaport

Papers

Millimeter Wave MIMO Channel Estimation Based on Adaptive Compressed Sensing

Wireless communication system, and wireless communication method

Wireless information links for the factory of the future

Massive-MIMO and Digital mm-Wave Arrays on RF-SoCs using FDM for M-Fold Increase in Antennas per ADC/DAC

Spread spectrum and digital communication techniques: A primer