scispace - formally typeset
Open AccessBook

Compact and Broadband Microstrip Antennas

Kin-Lu Wong
Reads0
Chats0
TLDR
In this paper, the authors present an overview of the most recent advances in regular-size Dual-Frequency Antennas and their application in a wide range of applications, including: 1.1 Introduction.
Abstract
Preface. 1. Introduction and Overview. 1.1 Introduction. 1.2 Compact Microstrip Antennas. 1.3 Compact Broadband Microstrip Antennas. 1.4 Compact Dual-Frequency Microstrip Antennas. 1.5 Compact Dual-Polarized Microstrip Antennas. 1.6 Compact Circularly Polarized Microstrip Antennas. 1.7 Compact Microstrip Antennas with Enhanced Gain. 1.8 Broadband Microstrip Antennas. 1.9 Broadband Dual-Frequency and Dual-Polarized Microstrip Antennas. 1.10 Broadband and Dual-Band Circularly Polarized Microstrip Antennas. 2. Compact Microstrip Antennas. 2.1 Introduction. 2.2 Use of a Shorted Patch with a Thin Dielectric Substrate. 2.3 Use of a Meandered Patch. 2.4 Use of a Meandered Ground Plane. 2.5 Use of a Planar Inverted-L Patch. 2.6 Use of an Inverted U-Shaped or Folded Patch. 3. Compact Broadband Microstrip Antennas. 3.1 Introduction. 3.2 Use of a Shorted Patch with a Thick Air Substrate. 3.3 Use of Stacked Shorted Patches. 3.4 Use of Chip-Resistor and Chip-Capacitor Loading Technique. 3.5 Use of a Slot-Loading Technique. 3.6 Use of a Slotted Ground Plane. 4. Compact Dual-Frequency and Dual-Polarized Microstrip Antennas. 4.1 Introduction. 4.2 Some Recent Advances in Regular-Size Dual-Frequency Designs. 4.3 Compact Dual-Frequency Operation with Same Polarization Planes. 4.4 Compact Dual-Frequency Operation. 4.5 Dual-Band or Triple-Band PIFA. 4.6 Compact Dual-Polarized Designs. 5. Compact Circularly Polarized Microstrip Antennas. 5.1 Introduction. 5.2 Designs with a Cross-Slot of Unequal Arm Lengths. 5.3 Designs with a Y-Shaped Slot of Unequal Arm Lengths. 5.4 Designs with Slits. 5.5 Designs with Spur Lines. 5.6 Designs with Truncated Corners. 5.7 Designs with Peripheral Cuts. 5.8 Designs with a Tuning Stub. 5.9 Designs with a Bent Tuning Stub. 5.10 Compact CP Designs with an Inset Microstrip-Line Feed. 6. Compact Microstrip Antennas with Enhanced Gain. 6.1 Introduction. 6.2 Compact Microstrip Antennas with High-Permittivity Superstrate. 6.3 Compact Microstrip Antennas with Active Circuitry. 7. Broadband Microstrip Antennas. 7.1 Introduction. 7.2 Use of Additional Microstrip Resonators. 7.3 Microstrip Antennas with an Air Substrate. 7.4 Broadband Slot-Loaded Microstrip Antennas. 7.5 Broadband Microstrip Antennas with an Integrated Reactive Loading. 7.6 Broadband Microstrip Antennas with Reduced Cross-Polarization Radiation. 8. Broadband Dual-Frequency and Dual-Polarized Microstrip Antennas. 8.1 Introduction. 8.2 Broadband Dual-Frequency Microstrip Antennas. 8.3 Broadband Dual-Polarized Microstrip Antennas. 9. Broadband and Dual-Band Circularly Polarized Microstrip Antennas. 9.1 Introduction. 9.2 Broadband Single-Feed Circularly Polarized Microstrip Antennas. 9.3 Broadband Two-Feed Circularly Polarized Microstrip Antennas. 9.4 Broadband Four-Feed Circularly Polarized Microstrip Antennas. 9.5 Dual-Band Circularly Polarized Microstrip Antennas. Index.

read more

Citations
More filters
Proceedings ArticleDOI

Compact Cross Shaped Slit Circularly Polarized Microstrip Antenna for GNSS Applications

TL;DR: In this paper, a compact single feed circularly polarized micro strip antenna with cross-shaped slits is proposed for GNSS (Global Navigation Satellite System) applications, where four cross shaped slits are embedded at the corners of a cross slot loaded square patch thus improving axial ratio bandwidth.
Proceedings ArticleDOI

Design of Notch Cut Circularly Polarized Circular Microstrip Antenna

TL;DR: In this paper, a notch cut circular microstrip antenna to realize circular polarization on thinner substrate is proposed, which degenerates fundamental TM11 mode into two orthogonal modes to yield circular polarization.
Proceedings ArticleDOI

Broadband gap-coupled isosceles triangular microstrip antennas

TL;DR: In this paper, gap-coupled variations of 900, 1000 and 1100 Isoseleous triangular microstrip antennas are proposed, and wideband response is obtained by varying isosceles angle which tunes spacing between first two resonant modes of patch.
Proceedings ArticleDOI

Shorted Rectangular Microstrip Antenna for Dual-band Operation

TL;DR: In this article, a shorted rectangular microstrip antenna for dual-band operation is presented, and the analysis have been carried out by varying the shortingpin position from edge to center of the patch, such an antenna provides tunable frequency ratio of about 2.91 to 2.2 for the two operating frequencies.
Proceedings ArticleDOI

A broadband compact left-handed transmission antenna loaded with EBG structures

TL;DR: In this article, a broadband compact left-handed transmission antenna loaded with electromagnetic band-gap (EBG) structures is presented, which has advantages with respect to conventional patch antennas, for example enhancement of bandwidth, reduction of antenna size, and multi-frequency performance.
References
More filters
Book

Microstrip antennas

I. J. Bahl
Journal ArticleDOI

Dual-frequency patch antennas

TL;DR: In this paper, a critical overview of possible solutions for dual-frequency patch antennas is presented, and future perspectives are outlined, in particular geometric and spectral properties of patch antennas are discussed.
Journal ArticleDOI

Dual-frequency planar inverted-F antenna

TL;DR: In this paper, the authors proposed a planar dual-band inverted-F antenna for cellular handsets, which operates at the 0.9-GHz and 1.8-GHz bands.
Journal ArticleDOI

Active integrated antennas

TL;DR: Active integrated antenna (AIA) technologies have been extensively studied in the past decade or so as discussed by the authors, with a brief introduction on the definition and some historical remarks on the research effort on the past decades or so.
Journal ArticleDOI

Experimental and simulation studies of the coaxially fed U-slot rectangular patch antenna

TL;DR: In this paper, the U-slot patch on a foam substrate of about 0.08/spl lambda/thick was designed to attain 20-30% impedance as well as gain bandwidth.