scispace - formally typeset
Journal ArticleDOI

Numerical analysis of hydrogen transport near a blunting crack tip

TLDR
In this paper, Oriani's equilibrium theory is used to relate the hydrogen in traps (micro-structural defects) to concentration in normal interstitial lattice sites (NILS), and the resulting non-linear transient hydrogen diffusion equations are integrated using a modified backward Euler method.
Abstract
T he hydrogen transport problem is studied in conjunction with large deformation elastic—plastic behavior of a material. Oriani's equilibrium theory is used to relate the hydrogen in traps (micro-structural defects) to concentration in normal interstitial lattice sites (NILS). The resulting non-linear transient hydrogen diffusion equations are integrated using a modified backward Euler method. Coupled diffusion and plastic straining is analysed with this numerical procedure in the area around a blunting crack tip. A uniform NILS concentration as dictated by Sievert's law at the pressure and temperature of interest is used as initial condition throughout the body. The crack is initially blunted by plane strain mode I (tensile) loading. The finite element results show that hydrogen residing at NILS is generally very small in comparison with the population that develops in trapping sites near the crack surface. That is, lattice diffusion delivers the hydrogen but it is predominantly the trapping that determines its distribution at temperatures of interest. The predominance of trapped hydrogen over lattice concentration prevails even in the case when hydrogen migrates under steady state conditions. Hence, the hydrostatic stress effect is less important than traps created by plastic straining as far as the creation of high total hydrogen concentration is concerned. The trapping site locations and the temperature determine the amounts and locations of high hydrogen concentrations. Consequently, ahead of a blunting crack tip, the total hydrogen concentration and plastic strain diminish with distance from the crack tip whereas the hydrostatic stress rises. This would seem to have significant consequences for fractures induced by the presence of hydrogen.

read more

Citations
More filters
Journal ArticleDOI

Reliability Analysis of a Suspension Bridge Affected by Hydrogen Induced Cracking Based upon Response Surface Method

TL;DR: In this article, a decoupling technique has been developed for the evaluation of crack propagations in a wire section driven by the hydrogen diffusion to wire sections, in terms of two 2-dimensional finite element models.
Journal ArticleDOI

A fully coupled chemo-mechanical cohesive zone model for oxygen embrittlement of nickel-based superalloys

TL;DR: In this article , a fully coupled thermodynamically consistent chemo-mechanical modeling framework for stress-assisted oxygen embrittlement of grain boundaries in polycrystals is proposed.
Journal ArticleDOI

Understanding microstructural influences on hydrogen diffusion characteristics in martensitic steels using finite element analysis (FEA)

TL;DR: In this article, a two-fold approach is considered to study hydrogen diffusion characteristics in martensitic steels, where a multi-trap stress coupled H diffusion finite element model was developed to investigate the role of various trap states on effective H trapping during a four point bend test.
Journal ArticleDOI

Identification of the hydrogen diffusion parameters in bearing steel by Evolutionary Algorithm

TL;DR: In this article, a clustering-based evolutionary algorithm was used for the identification of hydrogen diffusion parameters in metals, based on which the 1D time-dependent solution was calibrated to the experimental curve measured by the two cells permeation test.
Journal ArticleDOI

Understanding microstructural influences on hydrogen diffusion characteristics in martensitic steels using finite element analysis (FEA)

TL;DR: In this article , a two-fold approach is considered to study hydrogen diffusion characteristics in martensitic steels, where a multi-trap stress coupled H diffusion finite element model was developed to investigate the role of various trap states on effective H trapping during a four point bend test.
References
More filters
Book

The finite element method

TL;DR: In this article, the methodes are numeriques and the fonction de forme reference record created on 2005-11-18, modified on 2016-08-08.
Journal ArticleDOI

A Path Independent Integral and the Approximate Analysis of Strain Concentration by Notches and Cracks

TL;DR: In this paper, an integral is exhibited which has the same value for all paths surrounding a class of notches in two-dimensional deformation fields of linear or non-linear elastic materials.
Journal ArticleDOI

Effects of hydrogen on the properties of iron and steel

TL;DR: In this paper, the effects of hydrogen on the physical and mechanical properties of iron and steel are reviewed and a new mechanism for the cold work peak for hydrogen in iron is considered.
Journal ArticleDOI

The diffusion and trapping of hydrogen in steel

TL;DR: In this paper, the mobility of dissolved hydrogen in an iron lattice having a population of extraordinary, or trapping, sites for hydrogen is analyzed under the assumption of local equilibrium between the mobile and the trapped populations.
Book

Hydrogen in metals

Related Papers (5)