scispace - formally typeset
Journal ArticleDOI

Numerical analysis of hydrogen transport near a blunting crack tip

TLDR
In this paper, Oriani's equilibrium theory is used to relate the hydrogen in traps (micro-structural defects) to concentration in normal interstitial lattice sites (NILS), and the resulting non-linear transient hydrogen diffusion equations are integrated using a modified backward Euler method.
Abstract
T he hydrogen transport problem is studied in conjunction with large deformation elastic—plastic behavior of a material. Oriani's equilibrium theory is used to relate the hydrogen in traps (micro-structural defects) to concentration in normal interstitial lattice sites (NILS). The resulting non-linear transient hydrogen diffusion equations are integrated using a modified backward Euler method. Coupled diffusion and plastic straining is analysed with this numerical procedure in the area around a blunting crack tip. A uniform NILS concentration as dictated by Sievert's law at the pressure and temperature of interest is used as initial condition throughout the body. The crack is initially blunted by plane strain mode I (tensile) loading. The finite element results show that hydrogen residing at NILS is generally very small in comparison with the population that develops in trapping sites near the crack surface. That is, lattice diffusion delivers the hydrogen but it is predominantly the trapping that determines its distribution at temperatures of interest. The predominance of trapped hydrogen over lattice concentration prevails even in the case when hydrogen migrates under steady state conditions. Hence, the hydrostatic stress effect is less important than traps created by plastic straining as far as the creation of high total hydrogen concentration is concerned. The trapping site locations and the temperature determine the amounts and locations of high hydrogen concentrations. Consequently, ahead of a blunting crack tip, the total hydrogen concentration and plastic strain diminish with distance from the crack tip whereas the hydrostatic stress rises. This would seem to have significant consequences for fractures induced by the presence of hydrogen.

read more

Citations
More filters
Journal ArticleDOI

Internal Hydrogen-Induced Subcritical Crack Growth in Austenitic Stainless Steels

TL;DR: In this article, the effects of small amounts of dissolved hydrogen on crack propagation were determined for two austenitic stainless steel alloys, AISI 301 and 310S, for sustained load tests were performed on fatigue precracked specimens in air at 0, 25, and 50, with hydrogen contents up to 41 wt ppm.
Journal ArticleDOI

Coupled Analysis of Hydrogen Transport using ABAQUS

TL;DR: In this paper, two user subroutines were developed within ABAQUS to simulate coupled hydrogen transport equations, and compared with published results, showing good agreements for all cases considered.
Journal ArticleDOI

The role of plasticity and hydrogen flux in the fracture of a tempered martensitic steel: A new design of mechanical test until fracture to separate the influence of mobile from deeply trapped hydrogen

TL;DR: In this article, an electrochemical permeation device on a tensile machine has allowed to control the hydrogen flux and to isolate the effects of trapped and mobile hydrogen on the hydrogen embrittlement of a martensitic steel.
Journal ArticleDOI

Pressure Cycle Testing of Cr–Mo Steel Pressure Vessels Subjected to Gaseous Hydrogen

TL;DR: In this paper, two types of CrMo steel pressure vessels with notches machined on their inside under hydrogen-gas pressures, between 0.6 and 45 MPa at room temperature, were tested with gaseous hydrogen.
Journal ArticleDOI

A thermo-mechanically-coupled theory accounting for hydrogen diffusion and large elastic–viscoplastic deformations of metals

TL;DR: In this paper, a thermodynamically-consistent coupled-theory was developed to account for diffusion of hydrogen, diffusion of heat, and large elastic-viscoplastic deformations of metals.
References
More filters
Book

The finite element method

TL;DR: In this article, the methodes are numeriques and the fonction de forme reference record created on 2005-11-18, modified on 2016-08-08.
Journal ArticleDOI

A Path Independent Integral and the Approximate Analysis of Strain Concentration by Notches and Cracks

TL;DR: In this paper, an integral is exhibited which has the same value for all paths surrounding a class of notches in two-dimensional deformation fields of linear or non-linear elastic materials.
Journal ArticleDOI

Effects of hydrogen on the properties of iron and steel

TL;DR: In this paper, the effects of hydrogen on the physical and mechanical properties of iron and steel are reviewed and a new mechanism for the cold work peak for hydrogen in iron is considered.
Journal ArticleDOI

The diffusion and trapping of hydrogen in steel

TL;DR: In this paper, the mobility of dissolved hydrogen in an iron lattice having a population of extraordinary, or trapping, sites for hydrogen is analyzed under the assumption of local equilibrium between the mobile and the trapped populations.
Book

Hydrogen in metals

Related Papers (5)