scispace - formally typeset
Journal ArticleDOI

Aluminum-doped zinc oxide transparent conductors deposited by the sol-gel process

W. Tang, +1 more
- 15 Jan 1994 - 
- Vol. 238, Iss: 1, pp 83-87
TLDR
In this paper, thin films of transparent conducting aluminum-doped ZnO have been deposited using a sol-gel process and the dependence of electrical characteristics upon aluminum concentration in the films and upon post-deposition heat treatment in vacuum was examined.
About
This article is published in Thin Solid Films.The article was published on 1994-01-15. It has received 350 citations till now. The article focuses on the topics: Transparent conducting film & Thin film.

read more

Citations
More filters
Journal ArticleDOI

Sol-gel preparation of ZnO films with extremely preferred orientation along (002) plane from zinc acetate solution

TL;DR: In this article, a homogeneous and stable solution was prepared by dissolving the zinc acetate in a solution of 2methoxyethanol and monoethanolamine, which was obtained by preheating the dip-coating films at temperatures from 200° − 500°C for 10 min after each coating and postheating at temperatures between 500° − 800°c for 1 h.
Journal ArticleDOI

Zinc oxide films prepared by sol-gel spin-coating

TL;DR: In this article, electrical conductivity and optical properties of undoped zinc oxide films prepared by the sol-gel process using a spin-coating technique were investigated, and it was shown that the optical band gap energy for the films was 3.20-3.21 eV and the electronic transition was of the direct transition type.
Journal ArticleDOI

Solution processing of transparent conductors: from flask to film

TL;DR: This critical review focuses on the solution deposition of transparent conductors with a particular focus on transparent conducting oxide (TCO) thin-films, with an introduction into the applications of and material criteria for TCOs.
Journal ArticleDOI

Sol-gel synthesis of ZnO thin films

TL;DR: In this paper, transparent and crack free thin films of ZnO have been deposited on fused silica, soda glass, silicon wafers and KBr single crystals using the sol-gel technique.
Journal ArticleDOI

Sol-Gel Preparation of Transparent and Conductive Aluminum-Doped Zinc Oxide Films with Highly Preferential Crystal Orientation

TL;DR: In this article, transparent aluminum-doped zinc oxide (ZnO) films were prepared via the sol-gel method on silica-glass substrates from 2-methoxyethanol solutions of zinc acetate and aluminum chloride that contained monoethanolamine.
References
More filters
Journal ArticleDOI

Transparent conductors—A status review

TL;DR: In this paper, the authors present a comprehensive and up-to-date description of the deposition techniques, electro-optical properties, solid state physics of the electron transport and optical effects and some applications of these transparent conductors.
Journal ArticleDOI

Group III Impurity Doped Zinc Oxide Thin Films Prepared by RF Magnetron Sputtering

TL;DR: In this paper, a detailed study of electrical properties in group III impurity doped ZnO thin films prepared by rf magnetron sputtering is described, and it is shown that the resistivity dependence on film thickness below 300 nm.
Journal ArticleDOI

Highly Conductive and Transparent Aluminum Doped Zinc Oxide Thin Films Prepared by RF Magnetron Sputtering

TL;DR: In this paper, high conductive films of Al-doped ZnO have been prepared by rf magnetron sputtering of a znO target with Al2O3 dopant of 1-2 wt% in content added.
Journal ArticleDOI

Electrical and optical properties of undoped and antimony‐doped tin oxide films

TL;DR: In this paper, the electrical and optical properties of undoped and antimony-doped tin oxide films have been studied and the temperature dependence of electron mobility has been analyzed to establish the electron conduction mechanism.
Journal ArticleDOI

Optical and electrical properties of ZnO films prepared by spray pyrolysis for solar cell applications

TL;DR: In this paper, spray pyrolysis was used to produce transparent zinc oxide films with resistivity as low as 10−3 Ω(cm) by controlling the deposition procedure and postdeposition annealing in hydrogen.
Related Papers (5)