scispace - formally typeset
Journal ArticleDOI

Manganese oxides for lithium batteries

Reads0
Chats0
About
This article is published in Progress in Solid State Chemistry.The article was published on 1997-01-01. It has received 1332 citations till now. The article focuses on the topics: Lithium vanadium phosphate battery & Lithium.

read more

Citations
More filters
Journal ArticleDOI

Electrochemical characterization of manganese oxide cathode materials based on Na0.4MnO2

TL;DR: In this article, the cathode materials for lithium rechargeable batteries were prepared from Na 0.4 MnO 2 by solution and molten salt ion-exchanges, and the discharge characteristics depend upon the sodium content, with the partially lithiated material exhibiting hysteresis in the charge/discharge profile and differential capacity plots from stepped potential experiments.
Book ChapterDOI

The Electrochemical Performance of Deposited Manganese Oxide-Based Film as Electrode Material for Electrochemical Capacitor Application

TL;DR: In this paper, the surface redox reactions that contributed to the wide potential window shown on cyclic voltammetry curve were investigated on hydrous ruthenium oxide, which is a pseudocapacitive material.
Journal ArticleDOI

Improved electrochemical properties of Li[Li0.2Ni0.17Mn0.56Co0.07]O2 cathode material via micro-structural rearrangement

TL;DR: In this article, a facile method aimed at micro-structural rearrangement was proposed to improve the rate capability of lithium-rich layered cathode material Li[Li0.2Ni0.17Mn0.56Co0.07]O2.
Journal ArticleDOI

Remarkable enhancement of the electrode performance of nanocrystalline LiMn2O4 via solvothermally-assisted immobilization on reduced graphene oxide nanosheets

TL;DR: In this article, a facile solvothermal way to immobilize nanocrystalline LiMn2O4 on the surface of graphene nanosheets is developed to improve the functionality of lithium manganate as lithium intercalation electrode.
Journal ArticleDOI

Suitability of representative electrochemical energy storage technologies for ramp-rate control of photovoltaic power

TL;DR: In this paper, a quantitative comparison of the suitability of different electrochemical energy storage system (ESS) technologies to provide ramp-rate control of power in PV systems is presented.
References
More filters
Journal ArticleDOI

LixCoO2 (0<x<-1): A new cathode material for batteries of high energy density

TL;DR: In this paper, a new system LixCoO2 (0 Li x CoO 2 Li ) is proposed, which shows low overvoltages and good reversibility for current densities up to 4 mA cm−2 over a large range of x.
Journal ArticleDOI

Zero‐Strain Insertion Material of Li [ Li1 / 3Ti5 / 3 ] O 4 for Rechargeable Lithium Cells

TL;DR: In this paper, a defect spinel-framework structure was examined in nonaqueous lithium cells and it was shown that the lattice dimension did not change during the reaction since the reaction consists of lithium ion and electron insertion into/extraction from the solid matrix without a noticeable change in lattice dimensions.
Journal ArticleDOI

Lithium insertion into manganese spinels

TL;DR: In this article, Li has been inserted chemically and electrochemically into Mn3O4 and Li[Mn2]O4 at room temperature from X-ray diffraction.
Journal ArticleDOI

Electrochemical and In Situ X‐Ray Diffraction Studies of Lithium Intercalation in Li x CoO2

TL;DR: In this article, high precision voltage measurements and in situ x-ray diffraction indicate a sequence of three distinct phase transitions as varies from 1 to 0.4, two of which are situated slightly above and below and are caused by an order/disorder transition of the lithium ions.
Journal ArticleDOI

Improved capacity retention in rechargeable 4 V lithium/lithium- manganese oxide (spinel) cells

TL;DR: In this article, the authors improved the rechargeable capacity of 4 V LixMn2O4 spinel cathodes by modifying the composition of the spinel electrode, achieving a capacity in excess of 100 mAh/g in flooded-electrolyte lithium cells.
Related Papers (5)