Journal ArticleDOI
Rupture of rubber. I. Characteristic energy for tearing
R. S. Rivlin,A. G. Thomas +1 more
TLDR
The resistance to tearing of a rubber vulcanizate is usually determined by loading in a specified manner a test-piece of the vulcanizer of standard shape, in which a notch has been produced, either in the molding process or by cutting the testpiece in a standard fashion.Abstract:
The resistance to tearing of a rubber vulcanizate is usually determined by loading in a specified manner a test-piece of the vulcanizate of standard shape, in which a notch has been produced, either in the molding process or by cutting the test-piece in a standard fashion. A wide variety of shapes of test-piece and notch and of methods of loading have been recommended by various authors (see, for example, Buist1).read more
Citations
More filters
Journal ArticleDOI
Peel tests for quantifying adhesion and toughness: A review
TL;DR: A review of the historical development of peel tests and a categorization scheme that is applicable to various peel configurations can be found in this article , where four categories are presented, depending on whether peeling is elastic or inelastic, and if debonding is self-similar or not.
Journal ArticleDOI
Wool/Polymer Interactions Part II : Measurement of Adhesion Between Single Wool Fibers and a Polyurethane Elastomerl
Brett O. Bateup,Illa Souren +1 more
TL;DR: In this article, two methods were investigated for measuring the adhesion between single Lincoln fibers and a polyurethane elastomer, and the importance of viscoelastic properties on the measured adhesive force was shown at low speeds of testing where the wool/polymer adhesive force increased with speed, parallel to the tearing energy of the elastomers.
Proceedings ArticleDOI
Tear strength estimation of electroactive polymer-based strain sensors
TL;DR: A trouser type of specimen made from conducting and stretchable freestanding films consisting of SEBS rubber and dodecyl benzenesulfonic acid (DBSA) doped polyaniline composite was used for fabricating the capacitive strain sensor and tear strength estimation as discussed by the authors .
References
More filters
Journal ArticleDOI
Large elastic deformations of isotropic materials IV. further developments of the general theory
TL;DR: In this article, the surface forces necessary to produce simple shear in a cuboid of either compressible or incompressible material and those required to generate simple torsion in a right-circular cylinder of incompressibly material are derived.
Journal ArticleDOI
Large Elastic Deformations of Isotropic Materials. VII. Experiments on the Deformation of Rubber
R. S. Rivlin,D. W. Saunders +1 more
TL;DR: In this paper, it was shown that the load-deformation curves obtained for certain simple types of deformation of vulcanized rubber test-pieces in terms of a single stored energy function can be interpreted on the basis of the theory of large elastic deformations of incompressible isotropic materials.
Journal ArticleDOI
An analysis of the conditions for rupture due to griffith cracks
TL;DR: In this paper, the authors present a model in which the crack is bounded by the atoms centred on the planes z =±½a, these planes being the boundaries of two semi-infinite elastic solids.
Journal ArticleDOI
The free energy of deformation for vulcanized rubber
R. S. Rivlin,D. W. Saunders +1 more
TL;DR: Load-deformation measurements on a number of natural rubber vulcanizates covering a wide range of hardness are reported in this paper, where the mean chain segment lengths obtained from swelling measurements are given.