Compact heat exchangers
Reads0
Chats0
TLDR
The third edition of the second edition as discussed by the authors was published in 1964 and contains basic test data for eleven new surface configurations, including some of the very compact ceramic matrices, in both the English and the Systeme International (SI) system of units.Abstract:
This third edition is an update of the second edition published in 1964. New data and more modern theoretical solutions for flow in the simple geometries are included, although this edition does not differ radically from the second edition. It contains basic test data for eleven new surface configurations, including some of the very compact ceramic matrices. Al dimensions are given in both the English and the Systeme International (SI) system of units.read more
Citations
More filters
Journal ArticleDOI
Mathematical modeling and experimental study of heat transfer in a low-duty air-cooled heat exchanger
TL;DR: In this article, a semi-empirical correlation for the Nusselt number on the water-side in the transitional and turbulent range when the Reynolds number is higher than 2300 was determined.
Journal ArticleDOI
Heat transfer and pressure drop characteristics of an array of plates aligned at angles to the flow in a rectangular duct
TL;DR: In this article, the heat transfer and pressure drop characteristics of an array of plates, aligned at various angles of 20-35° to the direction of air flow in a rectangular, straight duct, have been investigated experimentally in the range of Reynolds numbers between 350 and 5000.
Journal ArticleDOI
An experimental investigation on the airside performance of fin-and-tube heat exchangers having sinusoidal wave fins
B. Youn,Nae-Hyun Kim +1 more
TL;DR: In this article, the heat transfer and friction characteristics of the heat exchangers having sinusoidal wave fins were experimentally investigated, and the effect of waffle configuration (herringbone or sinusoid) on heat transfer coefficients and friction factors was investigated.
Journal ArticleDOI
The impact of heat exchanger fouling on the optimum operation and maintenance of the Stirling engine
TL;DR: In this paper, the effect of heat exchanger fouling on the performance of the Stirling engine in combined heat and power (CHP) application is investigated, and a cost model is developed for the engine to translate changes in performance into economy in CHP operation.
Journal ArticleDOI
Investigation on convective heat transfer characteristics of single phase liquid flow in multi-port micro-channel tubes
TL;DR: In this article, the effects of different boundary conditions on the simultaneous pressure drop and heat transfer characteristics were studied, and the results showed that the Nusselt numbers decrease with the increase of inlet temperature and heat flux.