Journal ArticleDOI
Polymer microfluidic devices
Holger Becker,Laurie E. Locascio +1 more
Reads0
Chats0
TLDR
This article presents a review of polymer-based microfluidic systems including their material properties, fabrication methods, device applications, and finally an analysis of the market that drives their development.About:
This article is published in Talanta.The article was published on 2002-02-11. It has received 1150 citations till now.read more
Citations
More filters
Planar fluid-tunable waveguide arrays
TL;DR: In this paper, the authors explored planar analogues to several existing fluid-infiltrated microstructured fiber devices for refractive index sensing, and special attention was given to the application of these planar periodic guiding schemes.
Book
Introduction to microfluidics
TL;DR: In this paper, physics at the micrometric scale and hydrodynamics of microfluidic systems are discussed, including diffusion, mixing, and separation in Microfluidics and Thermal Transfers.
Journal ArticleDOI
Plastic fingerprint replica: solvent-assisted 3D molding and motion-promoted nano-spherulite formation
TL;DR: In this paper, the authors describe the procedure and principle of creating highly resolved, chemically robust, 3D fingerprint physical replicas, which is based on the solvent-assisted molding of transparent plastics and motion-promoted growth of semi-crystalline polymeric nanostructures.
Patent
Methods of dispensing and withdrawing liquid in an electrowetting device
TL;DR: In this article, a method for dispensing liquid, comprising the steps of positioning a droplet to be dispensed in a gap of an electrowetting device using an Electrowetting array, and then dispensing the droplet through a hole in a housing or substrate of the device.
Fabrication of a circular PDMS microchannel to construct a three-dimensional endothelial cell layer
TL;DR: In this paper, a simple and efficient fabrication method for generating microfluidic channels with a circular cross-sectional geometry by exploiting the reflow phenomenon of a thick positive photoresist was described.
References
More filters
Book
CRC Handbook of Chemistry and Physics
TL;DR: CRC handbook of chemistry and physics, CRC Handbook of Chemistry and Physics, CRC handbook as discussed by the authors, CRC Handbook for Chemistry and Physiology, CRC Handbook for Physics,
Journal ArticleDOI
Rapid prototyping of microfluidic systems in poly(dimethylsiloxane)
TL;DR: A procedure that makes it possible to design and fabricate microfluidic systems in an elastomeric material poly(dimethylsiloxane) (PDMS) in less than 24 h by fabricating a miniaturized capillary electrophoresis system is described.
Journal ArticleDOI
Fabrication of microfluidic systems in poly(dimethylsiloxane)
J.C. McDonald,David C. Duffy,Janelle R. Anderson,Daniel T. Chiu,Hongkai Wu,Olivier Schueller,George M. Whitesides +6 more
TL;DR: Fabrication of microfluidic devices in poly(dimethylsiloxane) (PDMS) by soft lithography provides faster, less expensive routes to devices that handle aqueous solutions.
Journal ArticleDOI
A Sequencing Method Based on Real-Time Pyrophosphate
Journal ArticleDOI
Micromachining a Miniaturized Capillary Electrophoresis-Based Chemical Analysis System on a Chip
TL;DR: In this article, the authors demonstrated a miniaturized system for sample handling and separation using electrophoresis-based separations of amino acids with up to 75,000 theoretical plates in about 15 seconds.