scispace - formally typeset
Open AccessBook

Tribology: Friction and Wear of Engineering Materials

Ian M. Hutchings
TLDR
In this paper, surface topography and surfaces in contact are discussed, as well as surface engineering in tribology, materials for bearings and sliding wear by hard particles, friction and friction.
Abstract: 
Preface * Introduction * Surface topography and surfaces in contact * Friction * Lubricants and lubrication * Sliding wear * Wear by hard particles * Wear and design * Surface engineering in tribology * Materials for bearings * Author index * Subject index.

read more

Citations
More filters
Journal ArticleDOI

Effect of microstructure on slurry abrasion response of En-31 steel

S.G. Sapate, +3 more
- 01 Jan 2008 - 
TL;DR: In this article, the effect of sliding distance, normal load and slurry concentration on volume loss of heat treated En-31 steel was studied. And the morphology of the worn surfaces after slurry abrasion was studied under scanning electron microscope.
Journal ArticleDOI

Tribocorrosion behavior of hot pressed CoCrMo alloys in artificial saliva

Mihaela Buciumeanu, +6 more
- 01 May 2016 - 
TL;DR: In this paper, the influence of processing conditions on the tribocorrosion behavior of hot pressed CoCrMo biomedical alloys was investigated and the worn surfaces were inspected by means of SEM/EDS.
Journal ArticleDOI

Laser cladding technique for erosive wear applications: a review

Sarpreet Singh, +3 more
TL;DR: In this article, an attempt has been made to compile the literature related to laser cladding technology, its applications, process parameters, coatingmaterials and their effectiveness to bestow solutions to various types of surface degradation with special emphasis on slurry erosion problems.
Journal ArticleDOI

Tribological properties of laser clad Stellite 6 coatings on steel substrates

C. Navas, +3 more
- 01 Feb 2006 - 
TL;DR: In this article, the deposition of laser cladding of Stellite 6 alloy coatings on two different base materials: an AISI 1045 carbon steel and an AisI 304 stainless steel.
Journal ArticleDOI

Effect of Particulate Contamination in Grease-Lubricated Hybrid Rolling Bearings

Lars Kahlman, +1 more
- 16 Sep 1999 - 
TL;DR: In this paper, the performance of all-steel and hybrid rolling bearings was investigated in the presence of two well-defined particulate contaminants, titania (anatase) and silica (quartz) particles.