Open AccessBook
Tribology: Friction and Wear of Engineering Materials
TLDR
In this paper, surface topography and surfaces in contact are discussed, as well as surface engineering in tribology, materials for bearings and sliding wear by hard particles, friction and friction.Abstract:
Preface * Introduction * Surface topography and surfaces in contact * Friction * Lubricants and lubrication * Sliding wear * Wear by hard particles * Wear and design * Surface engineering in tribology * Materials for bearings * Author index * Subject index.read more
Citations
More filters
Journal ArticleDOI
The effect of load and relative humidity on friction coefficient between high density polyethylene on galvanized steel—preliminary results
TL;DR: In this paper, the influence of applied load and relative humidity (RH) in the friction coefficient of high-density polyethylene (HDPE) pin on hot dip galvanized steel disc was presented.
Journal ArticleDOI
Surface modification of austenitic stainless steel by titanium ion implantation
TL;DR: In this paper, the wear properties of AISI 316 stainless steel implanted with Ti were investigated for ion doses in the range (2.3−5.4) × 10 16 ions cm −2 and average ion energies of 60 and 90 keV.
Journal Article
Tribological behaviour of TiAlN coated carbides in dry sliding tests
Wit Grzesik,Z. Zalisz,S. Król +2 more
TL;DR: In this article, a pin-on-disc device with round tool inserts was applied to conduct friction and wear tests in which both the friction coefficient and the linear wear of the tribo-pairs were continuously recorded versus sliding distance.
Dissertation
The use of laboratory erosion tests for the prediction of wear in pneumatic conveyor bends
TL;DR: In this paper, an optically based construction for a cylindrical mirror was used to predict the location of the puncture point in the bend, and the intensification of particle impacts in the region of the pipe bend due to the geometry of the bend.
Journal ArticleDOI
Abrasion–corrosion: New insights from force measurements
Marcelo Braga dos Santos,Wilian da Silva Labiapari,M.A.N. Ardila,W.M. da Silva,J.D.B. de Mello +4 more
TL;DR: In this article, a fixed-ball micro-abrasion tester is used to measure the forces acting on the contact of abrasion-corrosion processes in stainless steels.