A Universal Double‐Side Passivation for High Open‐Circuit Voltage in Perovskite Solar Cells: Role of Carbonyl Groups in Poly(methyl methacrylate)
Jun Peng,Jafar Iqbal Khan,Wenzhu Liu,Esma Ugur,Yiliang Wu,Heping Shen,Kai Wang,Hoang X. Dang,Erkan Aydin,Xinbo Yang,Yimao Wan,Klaus Weber,Kylie R. Catchpole,Frédéric Laquai,Stefaan De Wolf,Thomas P. White +15 more
TLDR
In this article, the perovskite cell devices were designed and analyzed with the support of the Australian Government through the Australian Renewable Energy Agency (ARENA) and the Australian Research Council.Abstract:
This work was supported by the Australian Government through the Australian Renewable Energy Agency (ARENA) and the Australian Research Council. Responsibility for the views, information or advice expressed herein is not accepted by the Australian Government. J.P. acknowledges the funding support from Australian Nanotechnology Network (ANN) and Department of Innovation, Industry, Science and Research (DIISR). The research reported in this publication was supported by funding from King Abdullah University of Science and Technology (KAUST). The authors thank Xavier Pita, scientific illustrator at King Abdullah University of Science and Technology (KAUST), for producing Figure 1a in this paper. J.P. conceived the idea, designed the overall experiments, and led the project. J.P., T.D., H.S., and Y.W. prepared and characterized the perovskite cell devices. J.I.K. and E.U. performed the TA and TRPL measurements and data analysis. F.L. supervised the TA and TRPL measurements and analysis. W.L., X.Y., and J. P. conducted the FTIR measurements and analysis. W.L. performed the DFT calculation. T.D., H.S., and Y.W. conducted the PL imaging measurements. H.D. conducted the XRD and SEM measurements. K.W. conducted the NMR measurements and analysis. E.A. conducted the EQE measurements. J.P., J.I.K., K.J.W., K.R.C., F.L., S.D.W., and T.P.W. contributed to the results analysis and interpretation. T.P.W. and S.D.W. supervised the project. J.P. wrote the manuscript. All authors contributed to the discussion of the results and revision of the manuscript.read more
Citations
More filters
Journal ArticleDOI
Minimizing non-radiative recombination losses in perovskite solar cells
TL;DR: In this paper, the predominant pathways that contribute to non-radiative recombination losses in perovskite solar cells, and evaluate their impact on device performance are analyzed, and some notable advances in mitigating these losses are highlighted.
Journal ArticleDOI
Recent Progresses on Defect Passivation toward Efficient Perovskite Solar Cells
Journal ArticleDOI
Defect and Contact Passivation for Perovskite Solar Cells.
TL;DR: The focus is on the origin of the various voltage-limiting mechanisms in PSCs, and the effect of such methods on the reduction of hysteresis are described.
Journal ArticleDOI
Nonradiative Recombination in Perovskite Solar Cells: The Role of Interfaces
TL;DR: Quantification of the quasi-Fermi level splitting in perovskite films with and without attached transport layers allows to identify the origin of nonradiative recombination, and to explain the VOC of operational devices, proving that in state-of-the-art solar cells,Nonradiatives recombination at the interfaces between the perovkite and the transport layers is more important than processes in the bulk or at grain boundaries.
References
More filters
Journal ArticleDOI
Organometal Halide Perovskites as Visible-Light Sensitizers for Photovoltaic Cells
TL;DR: Two organolead halide perovskite nanocrystals were found to efficiently sensitize TiO(2) for visible-light conversion in photoelectrochemical cells, which exhibit strong band-gap absorptions as semiconductors.
Journal ArticleDOI
Efficient Hybrid Solar Cells Based on Meso-Superstructured Organometal Halide Perovskites
Michael M. Lee,Joël Teuscher,Tsutomu Miyasaka,Takurou N. Murakami,Takurou N. Murakami,Henry J. Snaith +5 more
TL;DR: A low-cost, solution-processable solar cell, based on a highly crystalline perovskite absorber with intense visible to near-infrared absorptivity, that has a power conversion efficiency of 10.9% in a single-junction device under simulated full sunlight is reported.
Journal ArticleDOI
Sequential deposition as a route to high-performance perovskite-sensitized solar cells
Julian Burschka,Norman Pellet,Norman Pellet,Soo-Jin Moon,Robin Humphry-Baker,Peng Gao,Mohammad Khaja Nazeeruddin,Michael Grätzel +7 more
TL;DR: A sequential deposition method for the formation of the perovskite pigment within the porous metal oxide film that greatly increases the reproducibility of their performance and allows the fabrication of solid-state mesoscopic solar cells with unprecedented power conversion efficiencies and high stability.
Journal ArticleDOI
Electron-hole diffusion lengths exceeding 1 micrometer in an organometal trihalide perovskite absorber.
Samuel D. Stranks,Giles E. Eperon,Giulia Grancini,Christopher Menelaou,Marcelo J. P. Alcocer,Tomas Leijtens,Laura M. Herz,Annamaria Petrozza,Henry J. Snaith +8 more
TL;DR: In this article, transient absorption and photoluminescence-quenching measurements were performed to determine the electron-hole diffusion lengths, diffusion constants, and lifetimes in mixed halide and triiodide perovskite absorbers.
Journal Article
Electron-Hole Diffusion Lengths Exceeding 1 Micrometer in an Organometal Trihalide Perovskite Absorber
Samuel D. Stranks,Giles E. Eperon,Giulia Grancini,Christopher Menelaou,Marcelo J. P. Alcocer,Tomas Leijtens,Laura M. Herz,Annamaria Petrozza,Henry J. Snaith +8 more
TL;DR: In this paper, transient absorption and photoluminescence-quenching measurements were performed to determine the electron-hole diffusion lengths, diffusion constants, and lifetimes in mixed halide and triiodide perovskite absorbers.