National University of La Plata

About: National University of La Plata is a education organization based out in La Plata, Argentina. It is known for research contribution in the topics: Population & Stars. The organization has 12993 authors who have published 30013 publications receiving 495118 citations. The organization is also known as: UNLP & Universidad Nacional de La Plata.

Measurements of Higgs boson production and couplings in the four-lepton channel in pp collisions at center-of-mass energies of 7 and 8 TeV with the ATLAS detector

Abstract: The final ATLAS Run 1 measurements of Higgs boson production and couplings in the decay channel H -> ZZ* -> l(+)l(-)l(+)l'(-), where l, l' = e or mu, are presented. These measurements were performed using pp collision data corresponding to integrated luminosities of 4.5 and 20.3 fb(-1) at center-of-mass energies of 7 and 8 TeV, respectively, recorded with the ATLAS detector at the LHC. The H -> ZZ* -> 4l signal is observed with a significance of 8.1 standard deviations, with an expectation of 6.2 standard deviations, at m(H) = 125.36 GeV, the combined ATLAS measurement of the Higgs boson mass from the H -> gamma gamma and H -> ZZ* -> 4l channels. The production rate relative to the Standard Model expectation, the signal strength, is measured in four different production categories in the H -> ZZ* -> 4l channel. The measured signal strength, at this mass, and with all categories combined, is 1.44(-0.33)(+0.40). The signal strength for Higgs boson production in gluon fusion or in association with (tt) over bar or (bb) over bar pairs is found to be 1.7(-0.4)(+0.5), while the signal strength for vector-boson fusion combined with WH/ZH associated production is found to be 0.3(-0.9)(+1.6).

Search for top squark pair production in final states with one isolated lepton, jets, and missing transverse momentum in √s=8 TeV pp collisions with the ATLAS detector

Abstract: The results of a search for top squark (stop) pair production in final states with one isolated lepton, jets, and missing transverse momentum are reported. The analysis is performed with proton-proton collision data at root s = 8 TeV collected with the ATLAS detector at the LHC in 2012 corresponding to an integrated luminosity of 20 fb(-1). The lightest supersymmetric particle (LSP) is taken to be the lightest neutralino which only interacts weakly and is assumed to be stable. The stop decay modes considered are those to a top quark and the LSP as well as to a bottom quark and the lightest chargino, where the chargino decays to the LSP by emitting a W boson. A wide range of scenarios with different mass splittings between the stop, the lightest neutralino and the lightest chargino are considered, including cases where the W bosons or the top quarks are off-shell. Decay modes involving the heavier charginos and neutralinos are addressed using a set of phenomenological models of supersymmetry. No significant excess over the Standard Model prediction is observed. A stop with a mass between 210 and 640 GeV decaying directly to a top quark and a massless LSP is excluded at 95% confidence level, and in models where the mass of the lightest chargino is twice that of the LSP, stops are excluded at 95% confidence level up to a mass of 500 GeV for an LSP mass in the range of 100 to 150 GeV. Stringent exclusion limits are also derived for all other stop decay modes considered, and model-independent upper limits are set on the visible cross-section for processes beyond the Standard Model.

AC-coupled front-end for biopotential measurements

Abstract: AC coupling is essential in biopotential measurements. Electrode offset potentials can be several orders of magnitude larger than the amplitudes of the biological signals of interest, thus limiting the admissible gain of a dc-coupled front end to prevent amplifier saturation. A high-gain input stage needs ac input coupling. This can be achieved by series capacitors, but in order to provide a bias path, grounded resistors are usually included, which degrade the common mode rejection ratio (CMRR). This paper proposes a novel balanced input ac-coupling network that provides a bias path without any connection to ground, thus resulting in a high CMRR. The circuit being passive, it does not limit the differential dc input voltage. Furthermore, differential signals are ac coupled, whereas common-mode voltages are dc coupled, thus allowing the closed-loop control of the dc common mode voltage by means of a driven-right-leg circuit. This makes the circuit compatible with common-mode dc shifting strategies intended for single-supply biopotential amplifiers. The proposed circuit allows the implementation of high-gain biopotential amplifiers with a reduced number of parts, thus resulting in low power consumption. An electrocardiogram amplifier built according to the proposed design achieves a CMRR of 123 dB at 50 Hz.

A Scenario Construction Process

Abstract: Scenario is a description technique that has been attracting a lot of attention from practitioners and from researchers. Several disciplines have been using scenarios for some time now, but recently the information system community has dedicated special attention to the possibilities that this description technique provides to enhance understandability of task-related descriptions and communicability among stakeholders. This paper aims its attention at a particular scenario construction process, but while doing so it tackles important problems regarding scenario management, in particular scenario organisation. Our scenarios are described in a structured way, using a simple conceptual model together with a form-oriented language. We have been using this representation for some time now, and our results are based on several case studies conducted with real-world problems.