Random circuit breaker network model for unipolar resistance switching (Advanced Materials (2008) 20 (1154))

TLDR: Noh et al. as mentioned in this paper proposed a percolation model based on a network of circuit breakers with two switchable metastable states to explain the reversible resistance switching behavior in polycrystalline TiO2 thin capacitors.

Abstract: The existence of reversible resistance switching (RS) behaviors induced by electric stimulus has been known for some time, and these intriguing physical phenomena have been observed in numerous materials, including oxides. As conventional charge-based random access memory is expected to face a size limit in the near future, a surge of renewed interest has been developed in RS phenomena for possible applications in small nonvolatile memory devices called resistance random access memory (RRAM). Of particular interest is unipolar RS, which shows the RS at two values of applied voltage of the same polarity. The unipolar RS exhibits a much larger resistance change than other RS phenomena, and this greatly simplifies the process of reading the memory state. When fabricated with oxide p-n diodes, memory cells using unipolar RS can be stacked vertically, which has the potential for dramatically increasing memory density. Therefore, unipolar RRAM may be a good candidate for multi-stacked, high density, nonvolatile memory. The most important scientific and technical issues concerning unipolar RS are how it works and the identification of its controlling parameters. Some studies have reported that unipolar RS comes from a homogeneous/inhomogeneous transition of current distribution, while others maintain that it comes from the formation and rupture of conducting filaments. Even with recent extensive studies on unipolar RS, its basic origin is still far from being understood. In addition, no model exists that actually explains how the reversible switching can occur at two values of applied voltage. This lack of a quantitative model poses a major barrier for unipolar RRAM applications. In this study, we describe RS behavior in polycrystalline TiO2 film. To explain the basic mechanism of unipolar RS behavior, we propose a new percolation model based on a network of ‘‘circuit breakers’’ with two switchable metastable states. The random circuit breaker (RCB) network model can explain the long-standing material issue of how unipolar RS occurs. This simple percolation model is different from the conventional percolation models, which have dealt only with static or irreversible dynamic processes. In addition, the RCB network model provides an indication of how to overcome the substantial distribution of switching voltages, which is currently considered the most serious obstacle to practical unipolar RRAM applications. The unipolar RS phenomenon can be explained by the current (I)-voltage (V) curves in Figure 1a, which are derived from measurements of our polycrystalline TiO2 thin capacitors. At the pristine state (green dot), they are in an insulating state. As the external voltage Vext increases from zero and reaches a threshold voltage Vforming, a sudden increase occurs in the current. If the current is not limited to a certain value, here called the compliance current Icomp, the TiO2 capacitor would experience a dielectric breakdown and be destroyed. However, [*] Prof. T. W. Noh, S. C. Chae, S. B. Lee, S. H Chang, Dr. C. Liu ReCOE & FPRD, Department of Physics and Astronomy Seoul National University Seoul 151-747 (Korea) E-mail: twnoh@snu.ac.kr