Showing papers on "Waste disposal published in 2009"

Transport and release of chemicals from plastics to the environment and to wildlife

Abstract: Plastics debris in the marine environment, including resin pellets, fragments and microscopic plastic fragments, contain organic contaminants, including polychlorinated biphenyls (PCBs), polycyclic aromatic hydrocarbons, petroleum hydrocarbons, organochlorine pesticides (2,2′-bis(p-chlorophenyl)-1,1,1-trichloroethane, hexachlorinated hexanes), polybrominated diphenylethers, alkylphenols and bisphenol A, at concentrations from sub ng g–1 to µg g–1. Some of these compounds are added during plastics manufacture, while others adsorb from the surrounding seawater. Concentrations of hydrophobic contaminants adsorbed on plastics showed distinct spatial variations reflecting global pollution patterns. Model calculations and experimental observations consistently show that polyethylene accumulates more organic contaminants than other plastics such as polypropylene and polyvinyl chloride. Both a mathematical model using equilibrium partitioning and experimental data have demonstrated the transfer of contaminants from plastic to organisms. A feeding experiment indicated that PCBs could transfer from contaminated plastics to streaked shearwater chicks. Plasticizers, other plastics additives and constitutional monomers also present potential threats in terrestrial environments because they can leach from waste disposal sites into groundwater and/or surface waters. Leaching and degradation of plasticizers and polymers are complex phenomena dependent on environmental conditions in the landfill and the chemical properties of each additive. Bisphenol A concentrations in leachates from municipal waste disposal sites in tropical Asia ranged from sub µg l–1 to mg l–1 and were correlated with the level of economic development.

Plastics, the environment and human health: current consensus and future trends.

Abstract: Plastics have transformed everyday life; usage is increasing and annual production is likely to exceed 300 million tonnes by 2010. In this concluding paper to the Theme Issue on Plastics, the Environment and Human Health, we synthesize current understanding of the benefits and concerns surrounding the use of plastics and look to future priorities, challenges and opportunities. It is evident that plastics bring many societal benefits and offer future technological and medical advances. However, concerns about usage and disposal are diverse and include accumulation of waste in landfills and in natural habitats, physical problems for wildlife resulting from ingestion or entanglement in plastic, the leaching of chemicals from plastic products and the potential for plastics to transfer chemicals to wildlife and humans. However, perhaps the most important overriding concern, which is implicit throughout this volume, is that our current usage is not sustainable. Around 4 per cent of world oil production is used as a feedstock to make plastics and a similar amount is used as energy in the process. Yet over a third of current production is used to make items of packaging, which are then rapidly discarded. Given our declining reserves of fossil fuels, and finite capacity for disposal of waste to landfill, this linear use of hydrocarbons, via packaging and other short-lived applications of plastic, is simply not sustainable. There are solutions, including material reduction, design for end-of-life recyclability, increased recycling capacity, development of bio-based feedstocks, strategies to reduce littering, the application of green chemistry life-cycle analyses and revised risk assessment approaches. Such measures will be most effective through the combined actions of the public, industry, scientists and policymakers. There is some urgency, as the quantity of plastics produced in the first 10 years of the current century is likely to approach the quantity produced in the entire century that preceded.

Environmental implications of plastic debris in marine settings--entanglement, ingestion, smothering, hangers-on, hitch-hiking and alien invasions.

Abstract: Over the past five or six decades, contamination and pollution of the world’s enclosed seas, coastal waters and the wider open oceans by plastics and other synthetic, non-biodegradable materials (generally known as ‘marine debris’) has been an ever-increasing phenomenon. The sources of these polluting materials are both land- and marine-based, their origins may be local or distant, and the environmental consequences are many and varied. The more widely recognized problems are typically associated with entanglement, ingestion, suffocation and general debilitation, and are often related to stranding events and public perception. Among the less frequently recognized and recorded problems are global hazards to shipping, fisheries and other maritime activities. Today, there are rapidly developing research interests in the biota attracted to freely floating (i.e. pelagic) marine debris, commonly known as ‘hangers-on and hitch-hikers’ as well as material sinking to the sea floor despite being buoyant. Dispersal of aggressive alien and invasive species by these mechanisms leads one to reflect on the possibilities that ensuing invasions could endanger sensitive, or at-risk coastal environments (both marine and terrestrial) far from their native habitats.

Monitoring the abundance of plastic debris in the marine environment

Abstract: Plastic debris has significant environmental and economic impacts in marine systems. Monitoring is crucial to assess the efficacy of measures implemented to reduce the abundance of plastic debris, but it is complicated by large spatial and temporal heterogeneity in the amounts of plastic debris and by our limited understanding of the pathways followed by plastic debris and its long-term fate. To date, most monitoring has focused on beach surveys of stranded plastics and other litter. Infrequent surveys of the standing stock of litter on beaches provide crude estimates of debris types and abundance, but are biased by differential removal of litter items by beachcombing, cleanups and beach dynamics. Monitoring the accumulation of stranded debris provides an index of debris trends in adjacent waters, but is costly to undertake. At-sea sampling requires large sample sizes for statistical power to detect changes in abundance, given the high spatial and temporal heterogeneity. Another approach is to monitor the impacts of plastics. Seabirds and other marine organisms that accumulate plastics in their stomachs offer a cost-effective way to monitor the abundance and composition of small plastic litter. Changes in entanglement rates are harder to interpret, as they are sensitive to changes in population sizes of affected species. Monitoring waste disposal on ships and plastic debris levels in rivers and storm-water runoff is useful because it identifies the main sources of plastic debris entering the sea and can direct mitigation efforts. Different monitoring approaches are required to answer different questions, but attempts should be made to standardize approaches internationally.

Titanium nanomaterial removal and release from wastewater treatment plants.

Abstract: Titanium (Ti) occurs naturally in soils and as highly purified titanium dioxide (Ti5O2) in many commercial products that have been used for decades. We report for the first time the occurrence, characterization, and removal of nano- and larger-sized Ti at wastewater treatment plants (WWTPs). At one WWTP studied in detail, raw sewage contained 100 to nearly 3000 microg TVL Ti larger than 0.7 microm accounted for the majority of the Ti in raw sewage, and this fraction was well removed by WWTP processes. Ti concentrations in effluents from this and several other WWTPs ranged from <5 to 15 microg/L and were nearly all present in the < 0.7 microm size fraction. As Ti was removed, it accumulated in settled solids at concentrations ranging from 1 to 6 microg Ti/mg. Ti-containing solids were imaged in sewage, biosolids, and liquid effluent as well as in commercial products containing engineered TiO2. Single nanoparticles plus spherical aggregates (50 nm to a few hundred nanometer in size) composed of sub-50 nm spheres of Ti and oxygen only (presumably TiO2) were observed in all samples. Significantly larger silicate particles containing a mixture of Ti and other metal atoms were also observed in the samples. To support the field work, laboratory adsorption batch and sequencing batch reactor experiments using TiO2 and activated sludge bacteria verified that adsorption of TiO2 onto activated sludge biomass occurs. Monitoring for TiO2 in the environment where WWTP liquid effluent is discharged (rivers, lakes, oceans) or biomass disposed (landfills, agriculture and soil amendments, incinerator off-gas or residuals) will increase our knowledge on the fate and transport of other nanomaterials in the environment

Contamination of surface, ground, and drinking water from pharmaceutical production.

Abstract: Low levels of pharmaceuticals are detected in surface, ground, and drinking water worldwide. Usage and incorrect disposal have been considered the major environmental sources of these microcontaminants. Recent publications, however, suggest that wastewater from drug production can potentially be a source of much higher concentrations in certain locations. The present study investigated the environmental fate of active pharmaceutical ingredients in a major production area for the global bulk drug market. Water samples were taken from a common effluent treatment plant near Hyderabad, India, which receives process water from approximately 90 bulk drug manufacturers. Surface water was analyzed from the recipient stream and from two lakes that are not contaminated by the treatment plant. Water samples were also taken from wells in six nearby villages. The samples were analyzed for the presence of 12 pharmaceuticals with liquid chromatography-mass spectrometry. All wells were determined to be contaminated with drugs. Ciprofloxacin, enoxacin, cetirizine, terbinafine, and citalopram were detected at more than 1 microg/L in several wells. Very high concentrations of ciprofloxacin (14 mg/L) and cetirizine (2.1 mg/L) were found in the effluent of the treatment plant, together with high concentrations of seven additional pharmaceuticals. Very high concentrations of ciprofloxacin (up to 6.5 mg/L), cetirizine (up to 1.2 mg/L), norfloxacin (up to 0.52 mg/L), and enoxacin (up to 0.16 mg/L) were also detected in the two lakes, which clearly shows that the investigated area has additional environmental sources of insufficiently treated industrial waste. Thus, insufficient wastewater management in one of the world's largest centers for bulk drug production leads to unprecedented drug contamination of surface, ground, and drinking water. This raises serious concerns regarding the development of antibiotic resistance, and it creates a major challenge for producers and regulatory agencies to improve the situation.

The Progressive Increase of Food Waste in America and Its Environmental Impact

Abstract: Food waste contributes to excess consumption of freshwater and fossil fuels which, along with methane and CO(2) emissions from decomposing food, impacts global climate change. Here, we calculate the energy content of nationwide food waste from the difference between the US food supply and the food consumed by the population. The latter was estimated using a validated mathematical model of metabolism relating body weight to the amount of food eaten. We found that US per capita food waste has progressively increased by approximately 50% since 1974 reaching more than 1400 kcal per person per day or 150 trillion kcal per year. Food waste now accounts for more than one quarter of the total freshwater consumption and approximately 300 million barrels of oil per year.

Protecting-group-free synthesis as an opportunity for invention

Abstract: The constant pressure to prepare compounds in a more efficient manner has placed the process by which traditional synthetic chemistry is conducted under scrutiny. Areas that have the potential to be improved must be highlighted and modified, so that we can approach the criterion of the 'ideal synthesis'. One area that offers this prospect is the minimization of the use of protecting groups in synthesis. A protection/deprotection event introduces at least two steps into a sequence, incurring costs from additional reagents and waste disposal, and generally leads to a reduced overall yield. Here we present relevant historical context and highlight recent (post-2004) total syntheses that have developed new chemistry in an effort to exclude protecting groups. The invention of chemoselective methodologies is crucial to the execution of 'protecting-group-free' synthesis, and recent advances in this area are also highlighted.

Evaluation of hazardous waste transportation firms by using a two step fuzzy-AHP and TOPSIS methodology

Abstract: Hazardous wastes are likely to cause danger to human health and/or environment. Safe transportation of them is so important. Consequently, selection of the right and most appropriate transportation firm is an important problem for hazardous waste generators. In this paper, a two step methodology is structured to evaluate hazardous waste transportation firms containing the methods of fuzzy-AHP and TOPSIS. And a numerical example is presented to clarify the methodology.

Detection of 140 clinically relevant antibiotic-resistance genes in the plasmid metagenome of wastewater treatment plant bacteria showing reduced susceptibility to selected antibiotics

Abstract: To detect plasmid-borne antibiotic-resistance genes in wastewater treatment plant (WWTP) bacteria, 192 resistance-gene-specific PCR primer pairs were designed and synthesized. Subsequent PCR analyses on total plasmid DNA preparations obtained from bacteria of activated sludge or the WWTP's final effluents led to the identification of, respectively, 140 and 123 different resistance-gene-specific amplicons. The genes detected included aminoglycoside, β-lactam, chloramphenicol, fluoroquinolone, macrolide, rifampicin, tetracycline, trimethoprim and sulfonamide resistance genes as well as multidrug efflux and small multidrug resistance genes. Some of these genes were only recently described from clinical isolates, demonstrating genetic exchange between clinical and WWTP bacteria. Sequencing of selected resistance-gene-specific amplicons confirmed their identity or revealed that the amplicon nucleotide sequence is very similar to a gene closely related to the reference gene used for primer design. These results demonstrate that WWTP bacteria are a reservoir for various resistance genes. Moreover, detection of about 64 % of the 192 reference resistance genes in bacteria obtained from the WWTP's final effluents indicates that these resistance determinants might be further disseminated in habitats downstream of the sewage plant.

Municipal solid waste characteristics and management in nigeria

Abstract: Municipal solid waste management has emerged as one of the greatest challenges facing environmental protection agencies in developing countries. This study presents the current solid waste management practices and problems in Nigeria. Solid waste management is characterized by inefficient collection methods, insufficient coverage of the collection system and improper disposal. The waste density ranged from 280 to 370 kg/m 3 and the waste generation rates ranged from 0.44 to 0.66 kg/capita/day. The common constraints faced environmental agencies include lack of institutional arrangement, insufficient financial resources, absence of bylaws and standards, inflexible work schedules, insufficient information on quantity and composition of waste, and inappropriate technology. The study suggested study of institutional, political, social, financial, economic and technical aspects of municipal solid waste management in order to achieve sustainable and effective solid waste management in Nigeria.

Perfluoroalkyl sulfonic and carboxylic acids: a critical review of physicochemical properties, levels and patterns in waters and wastewaters, and treatment methods.

Abstract: Perfluorinated acids (PFAs) are an emerging class of environmental contaminants present in various environmental and biological matrices. Two major PFA subclasses are the perfluorinated sulfonic acids (PFSAs) and carboxylic acids (PFCAs). The physicochemical properties and partitioning behavior for the linear PFA members are poorly understood and widely debated. Even less is known about the numerous branched congeners with varying perfluoroalkyl chain lengths, leading to confounding issues around attempts to constrain the properties of PFAs. Current computational methods are not adequate for reliable multimedia modeling efforts and risk assessments. These compounds are widely present in surface, ground, marine, and drinking waters at concentrations that vary from pg L(-1) to microg L(-1). Concentration gradients of up to several orders of magnitude are observed in all types of aquatic systems and reflect proximity to known industrial sources concentrated near populated regions. Some wastewaters contain PFAs at mg L(-1) to low g L(-1) levels, or up to 10 orders of magnitude higher than present in more pristine receiving waters. With the exception of trifluoroacetic acid, which is thought to have both significant natural and anthropogenic sources, all PFSAs and PFCAs are believed to arise from human activities. Filtration and sorption technologies offer the most promising existing removal methods for PFAs in aqueous waste streams, although sonochemical approaches hold promise. Additional studies need to be conducted to better define opportunities from evaporative, extractive, thermal, advanced oxidative, direct and catalyzed photochemical, reductive, and biodegradation methods. Most PFA treatment methods exhibit slow kinetic profiles, hindering their direct application in conventional low hydraulic residence time systems.