Missouri University of Science and Technology

About: Missouri University of Science and Technology is a education organization based out in Rolla, Missouri, United States. It is known for research contribution in the topics: Artificial neural network & Control theory. The organization has 9380 authors who have published 21161 publications receiving 462544 citations. The organization is also known as: Missouri S&T & University of Missouri–Rolla.

Determining the nucleation rate curve for lithium disilicate glass by differential thermal analysis

Abstract: The crystallization of lithium disilicate (Li2O+2SiO2) glass nucleated at various temperatures was studied by differential thermal analysis (DTA). A plot of the DTA crystallization peak height versus nucleation temperature closely resembles the classical nucleation rate curve for lithium disilicate glass whose maximum is at 453 C. The glass becomes saturated with internal nuclei when heated at 453 C for 10 h. The activation energy for crystallization and the heat of crystallization are independent of the concentration of nuclei and are 249 + or - 10 and 67 + or - 3 kJ/mol, respectively. The Avrami exponent, n, depends strongly on the concentration of nuclei in the glass.

Integration of a StatCom and Battery Energy Storage

Abstract: The integration of an energy storage system, such as battery energy storage (BESS), into a FACTS device can provide dynamic decentralized active power capabilities and much-needed flexibility for mitigating transmission level power flow problems. This paper will introduce an integrated static synchronous compensator (StatCom)/BESS for the improvement of dynamic and transient stability and transmission capability, compare the performance of the different FACTS/BESS combinations, and provide experimental verification of the proposed controls on a scaled StatCom/BESS system.

The genesis of the cellular precipitation reaction

Abstract: The morphology of cellular precipitation in a Cu-9.5 at. pet In alloy has been investigated by light and electron microscopy. Both cellular and general precipitation were observed to occur simultaneously in quenched and aged alloys while only cellular precipitation was observed to occur in isothermally aged alloys. Because of the presence of wide, solute rich, precipitate free zones in the vicinity of grain boundaries in the quenched and aged alloys, the early development of cellular precipitation was found to be identical for both types of heat treatment. From light and electron microscopy observations of the early stages of cellular precipitation a mechanism for the formation of cells was developed. At the start of aging, the unoccupied grain boundary begins to migrate under the influence of grain boundary migration forces as if it were in a single phase alloy. As the boundary migrates, solute segregates along it to form allotriomorphs which pin the boundary. The boundary continues to migrate and bows between the simultaneously forming allotriomorphs. With further aging, the allotriomorphs lengthen following the bowing boundary and the allotriomorphs become the initial precipitate lamellae of the developing cell as a steady-state lamellar structure develops. Assuming that the critical step in the development of a cell is the ability of the boundary to bow between the initial allotriomorphs, a criterion for the occurrence of cellular precipitation was developed.