scispace - formally typeset
Journal ArticleDOI

Evaluation of freestanding GaN as an alpha and neutron detector

Reads0
Chats0
TLDR
In this article, the authors demonstrated the feasibility of ionizing radiation detectors created from significantly thicker freestanding n-type gallium nitride (GaN), grown via hydride vapor phase epitaxy (HVPE).
Abstract
The wide bandgap (3.39) eV and large dislocation energy of the III–V semiconductor gallium nitride (GaN) make this a desirable material for charged particle spectroscopy in high temperature, high radiation environments. While other research groups have established that charged particle detectors can be fabricated from high quality, thin films of molecular beam epitaxy (MBE) and metal organic chemical vapor deposition (MOCVD) grown GaN, this work demonstrates the feasibility of ionizing radiation detectors created from significantly thicker freestanding n-type GaN, grown via hydride vapor phase epitaxy (HVPE). Detectors were fabricated by depositing Ni/Au pads on n-type GaN, forming a Schottky barrier diode. Capacitance–voltage measurements on the detectors showed an intrinsic carrier concentration in the range of 10 −16  cm −3 –10 –15  cm −3 , and indicated an inhomogeneous distribution between diodes on the same wafer. The radiation sensitivity of the fabricated detectors was analyzed using alpha particles from an 241 Am source. Charge collection efficiency (CCE) calculations from these experiments indicate an efficiency of 100 percent. The detectors were also successfully used to detect neutron induced charged particles using a Li 2 O foil in a neutron beam.

read more

Citations
More filters
Journal ArticleDOI

Review of using gallium nitride for ionizing radiation detection

TL;DR: In this article, GaN has been used for photodetection such as solar blind imaging as well as ultraviolet and even X-ray detection with the largest band gap energy of all commercial semiconductors, and has found wide application in the making of optoelectronic devices.
Journal ArticleDOI

Review—The Current and Emerging Applications of the III-Nitrides

TL;DR: In this article, the authors review III-nitride material properties and their corresponding applications in LEDs, solar cells, power and radio frequency (RF) electronics, magnetic devices, thermoelectrics and nuclear detection.
Journal ArticleDOI

Performance Analysis of a Pt/n-GaN Schottky Barrier UV Detector

TL;DR: In this article, the electrical and optical properties of an n-type gallium nitride (GaN)-based Schottky barrier ultraviolet (UV) detector, where a platinum (Pt) metal layer forms the anode contact, have been evaluated by means of detailed numerical simulations considering a wide range of incident light intensities.
Journal ArticleDOI

Thin film cadmium telluride charged particle sensors for large area neutron detectors

TL;DR: In this paper, the capacitance-voltage behavior of thin-film charged particle detectors is studied and correlated to the response due to alpha radiation, which is desirable so that the detector does not give false positive counts from gamma rays.
Journal ArticleDOI

Numerical simulation study of a high efficient AlGaN-based ultraviolet photodetector

TL;DR: In this paper, a 2D numerical simulation study of a p+n-n+ AlGaN-based ultraviolet photodetector, which is designed to achieve true solar blindness with a cutoff wavelength of 0.31μm, is presented.
References
More filters
Journal ArticleDOI

SRIM – The stopping and range of ions in matter (2010)

TL;DR: SRIM as discussed by the authors is a software package concerning the stopping of ion/atom collisions, and individual interatomic potentials have been included for all ion and atom collisions in the SRIM package.
Journal ArticleDOI

Candela‐class high‐brightness InGaN/AlGaN double‐heterostructure blue‐light‐emitting diodes

Abstract: Candela‐class high‐brightness InGaN/AlGaN double‐heterostructure (DH) blue‐light‐emitting diodes(LEDs) with the luminous intensity over 1 cd were fabricated As an active layer, a Zn‐doped InGaN layer was used for the DH LEDs The typical output power was 1500 μW and the external quantum efficiency was as high as 27% at a forward current of 20 mA at room temperature The peak wavelength and the full width at half‐maximum of the electroluminescence were 450 and 70 nm, respectively This value of luminous intensity was the highest ever reported for blue LEDs
Journal ArticleDOI

A Review on the Reliability of GaN-Based LEDs

TL;DR: In this paper, the degradation mechanisms that limit the reliability of GaN-based light-emitting diodes (LEDs) are reviewed, and a set of specific experiments aimed at separately analyzing the degradation of the properties of the active layer, of the ohmic contacts and of the package/phosphor system are presented.
Journal ArticleDOI

Current Status of GaN-Based Solid-State Lighting

Shuji Nakamura
- 01 Feb 2009 - 
TL;DR: The continuous improvement in luminous efficacy of white light-emitting-diode (LED) sources offers the potential of considerable energy savings in general lighting applications as mentioned in this paper, with further improvements expected in the near future.
Related Papers (5)