scispace - formally typeset
Open AccessDissertation

Characterisation and Modelling of Graphene FETs for Terahertz Mixers and Detectors

TLDR
In this article, the authors investigated the practical viability of high-frequency GFETs based on large-area graphene from chemical vapour deposition (CVD) and derived the closed-form expressions for the noise equivalent power.
Abstract
Graphene is a two-dimensional sheet of carbon atoms with numerous envisaged applications owing to its exciting properties. In particular, ultrahigh-speed graphene field effect transistors (GFETs) are possible due to the unprecedented carrier velocities in ideal graphene. Thus, GFETs may potentially advance the current upper operation frequency limit of RF electronics. In this thesis, the practical viability of high-frequency GFETs based on large-area graphene from chemical vapour deposition (CVD) is investigated. Device-level GFET model parameters are extracted to identify performance bottlenecks. Passive mixer and power detector terahertz circuits operating above the present active GFET transit time limit are demonstrated. The first device-level microwave noise characterisation of a CVD GFET is presented. This allows for the de-embedding of the noise parameters and construction of noise models for the intrinsic device. The correlation of the gate and drain noise in the PRC model is comparable to that of Si MOSFETs. This indicates higher long-term GFET noise relative to HEMTs. An analytical power detector model derived using Volterra analysis on the FET large-signal model is verified at frequencies up to 67 GHz. The drain current derivatives, intrinsic capacitors and parasitic resistors of the closed-form expressions for the noise equivalent power (NEP) are extracted from DC and S-parameter measurements. The model shows that a short gate length and a bandgap in the channel are required for optimal FET sensitivity. A power detector integrated with a split bow-tie antenna on a Si substrate demonstrates an optical NEP of 500 pW/Hz^1/2 at 600 GHz. This represents a state-of-the-art result for quasi-optically coupled, rectifying direct detectors based on GFETs operating at room temperature. The subharmonic GFET mixer utilising the electron-hole symmetry in graphene is scaled to operate with a centre frequency of 200 GHz, the highest frequency reported so far for graphene integrated circuits. The down-converter circuit is implemented in a coplanar waveguide (CPW) on Si and exhibits a conversion loss (CL) of 29 ± 2 dB in the 185-210 GHz band. In conclusion, the CVD GFETs in this thesis are unlikely to reach the performance required for high-end RF applications. Instead, they currently appear more likely to compete in niche applications such as flexible electronics.

read more

Citations
More filters
Journal ArticleDOI

Mechanisms and applications of carbon nanotubes in terahertz devices: A review

TL;DR: In this paper, the mechanisms of utilizing carbon nanotubes to generate, modulate, polarize, and detect terahertz radiation have been discussed, and the main performance achievement for such devices is summarized briefly, and an outlook on the performance improvement for existing deficiencies is presented.
Journal Article

A self-consistent theory for graphene transport.

TL;DR: In this paper, the authors show that most of the observed transport properties of graphene sheets at zero magnetic field can be explained by scattering from charged impurities, with weak dependence on impurity concentration.
Proceedings Article

Opening the terahertz window with integrated diode circuits

TL;DR: The terahertz region of the electromagnetic spectrum, spanning from 100 GHz through 10 THz, is of increasing importance for a wide range of scientific, military and commercial applications.
Journal Article

High-frequency performance of scaled carbon nanotube array field-effect transistors

TL;DR: In this paper, the authors report the radio-frequency performance of carbon nanotube array transistors that have been realized through the aligned assembly of highly separated, semiconducting carbon nanotsubes on a fully scalable device platform.
References
More filters
Journal ArticleDOI

Electric Field Effect in Atomically Thin Carbon Films

TL;DR: Monocrystalline graphitic films are found to be a two-dimensional semimetal with a tiny overlap between valence and conductance bands and they exhibit a strong ambipolar electric field effect.
Journal ArticleDOI

The electronic properties of graphene

TL;DR: In this paper, the basic theoretical aspects of graphene, a one-atom-thick allotrope of carbon, with unusual two-dimensional Dirac-like electronic excitations, are discussed.
Journal ArticleDOI

Large-Area Synthesis of High-Quality and Uniform Graphene Films on Copper Foils

TL;DR: It is shown that graphene grows in a self-limiting way on copper films as large-area sheets (one square centimeter) from methane through a chemical vapor deposition process, and graphene film transfer processes to arbitrary substrates showed electron mobilities as high as 4050 square centimeters per volt per second at room temperature.
Journal ArticleDOI

Roll-to-roll production of 30-inch graphene films for transparent electrodes

TL;DR: The roll-to-roll production and wet-chemical doping of predominantly monolayer 30-inch graphene films grown by chemical vapour deposition onto flexible copper substrates are reported, showing high quality and sheet resistances superior to commercial transparent electrodes such as indium tin oxides.
Journal ArticleDOI

Detection of individual gas molecules adsorbed on graphene

TL;DR: In this paper, it was shown that micrometre-size sensors made from graphene are capable of detecting individual events when a gas molecule attaches to or detaches from graphene's surface.
Related Papers (5)