Open Access
Guide for the Design and Construction of Externally Bonded FRP Systems for Strengthening Concrete Structures
Charles E. Bakis,Damian I. Kachlakev,Morris Schupack,P. N. Balaguru,Duane J. Gee,Vistasp M. Karbhari,David Scott,Craig A. Ballinger,T. Russell Gentry,Howard S. Kliger,Rajan Sen,Lawrence C. Bank,Arie Gerritse,James G. Korff,Mohsen Shahawy,Karl Gillette,Michael W. Lee,Carol K. Shield,Brahim Benmokrane,William J. Gold,Ibrahim M. Mahfouz,Khaled Soudki,Gregg J. Blaszak,Charles H. Goodspeed,Henry N. Marsh,R. Taerwe,Gordon L. Brown,F. Grace,Orange S. Marshall,Vicki L. Brown,Mark F. Green,Houssam Toutanji,Thomas I. Campbell,Mark E. Greenwood,Ayman Mosallam,Taketo Uomoto,Charles W. Dolan,Doug D. Gremel,Antoine E. Naaman,Miroslav Vadovic,Michael S. Guglielmo,Antonio Nanni,David R. Vanderpool,Rami M. Elhassan,Issam E. Harik,Kenneth W. Neale,Milan Vatovec,Salem S. Faza,Mark P. Henderson,Stephanie L. Walkup,Edward R. Fyfe,Bohdan N. Horeczko,Max L. Porter,David White,David M. Gale,Srinivasa L. Iyer,Sami H. Rizkalla,John P. Busel +57 more
- pp 1-154
TLDR
The Emerging Technology Series as mentioned in this paper is a series of information and recommendations based on available test data, technical reports, limited experience with field applications, and the opinions of committee members, with a focus on the development and appropriate use of new and emerging technologies.Abstract:
*Co-chairs of the subcommittee that prepared this document. Note: The committee acknowledges the contribution of associate member Paul Kelley. ACI encourages the development and appropriate use of new and emerging technologies through the publication of the Emerging Technology Series. This series presents information and recommendations based on available test data, technical reports, limited experience with field applications, and the opinions of committee members. The presented information and recommendations, and their basis, may be less fully developed and tested than those for more mature technologies. This report identifies areas in which information is believed to be less fully developed, and describes research needs. The professional using this document should understand the limitations of this document and exercise judgment as to the appropriate application of this emerging technology.read more
Citations
More filters
Journal ArticleDOI
Structural behaviors of deficient steel SHS short columns strengthened using CFRP
TL;DR: In this paper, the experimental and numerical investigations on the structural behaviors of steel square hollow section (SHS) compression members having initial horizontal or vertical deficiencies which were strengthened using Carbon Fiber Reinforced Polymer (CFRP) sheets were investigated.
Journal ArticleDOI
On the design of shear-strengthened RC members through the use of textile reinforced mortar overlays
TL;DR: In this paper, a design model to calculate the contribution of the textile reinforced mortar (TRM) jacket to the total shear resistance was developed using all the well reported available data that were grouped based on the observed failure modes.
Journal ArticleDOI
Investigation on the bond behavior of clay bricks reinforced with SRP and SRG strengthening systems
TL;DR: In this article, the role of the type of adhesive on the bond mechanism of steel reinforcements externally applied on clay bricks is investigated, and simple formulas devoted to predict the bond resistance of such systems are also proposed.
Finite element modeling of rc connections strengthened with frp laminates
TL;DR: In this article, a finite element (FE) modeling has been proposed for the non-linear analysis of RC joints covered with fiber reinforced plastic (FRP) overlays, which consists of the effects of anchorage slip and anchorage extension of the steel reinforcement in the connection zone.
Journal ArticleDOI
Performance of FRP-Strengthened Beams Subjected to Elevated Temperatures
Kiang Hwee Tan,Yuqian Zhou +1 more
TL;DR: In this paper, the flexural behavior of fiber-reinforced polymer (FRP)-strengthened beams after exposure to elevated temperatures in an electrical furnace was investigated.
References
More filters
Journal ArticleDOI
Theoretical stress strain model for confined concrete
TL;DR: In this paper, a stress-strain model for concrete subjected to uniaxial compressive loading and confined by transverse reinforcement is developed for concrete sections with either spiral or circular hoops, or rectangular hoops with or without supplementary cross ties.
MonographDOI
Seismic Design of Reinforced Concrete and Masonry Buildings
T. Paulay,M. J. N. Priestly +1 more
TL;DR: In this paper, the causes and effects of earthquakes: Seismicity, Structural Response, Seismic Action, and Seismical Action in Member Design principles of member design.
Book
Seismic Design and Retrofit of Bridges
TL;DR: In this article, the authors focus on designing adequate displacement and ductility capacity into new bridges, with less significance placed on strength, where a strength hierarchy is established in a bridge to ensure that damage is controllable and occurs only where the designer intends.
Journal ArticleDOI
Fiber-Reinforced Polymer Composites for Construction—State-of-the-Art Review
Charles E. Bakis,Lawrence C. Bank,Vicki L. Brown,Edoardo Cosenza,Julio F. Davalos,John J. Lesko,Atsuhiko Machida,Sami H. Rizkalla,Thanasis Triantafillou +8 more
TL;DR: A concise state-of-the-art survey of fiber-reinforced polymer composites for construction applications in civil engineering is presented in this article, which includes a historical review, the current state of the art, and future challenges.
Fiber-Reinforced Polymer Composites for Construction—State-of-the-Art Review
Charles E. Bakis,Lawrence C. Bank,Vicki L. Brown,Edoardo Cosenza,Julio F. Davalos,John J. Lesko,Atsuhiko Machida,Sami H. Rizkalla,Thanasis Triantafillou +8 more
TL;DR: A concise state-of-the-art survey of fiber-reinforced polymer composites for construction applications in civil engineering is presented in this article, which includes a historical review, the current state of the art, and future challenges.
Related Papers (5)
Guide for the Design and Construction of Externally Bonded FRP Systems for Strengthening Concrete Structures (ACI 440.2R-02)
K. Soudki,T. Alkhrdaji +1 more
Externally bonded FRP reinforcement for RC structures
Thanasis Triantafillou,Stijn Matthys,Katrien Audenaert,György L. Balázs,M. Blaschko,Hendrik Blontrock,Christoph Czaderski,Emmanuelle David,Angello Di Tomasso,William Duckett,Dick Hordijk,Michael Leeming,Heinz Meier,Giorgio Monti,Richard Moss,Uwe Neubauer,Roland Niedermeier,Björn Täljsten,G. Zehetmaier,Konrad Zilch +19 more